- 您現在的位置：買賣IC網 > PDF目錄16163 > MAX3107EVKIT+ (Maxim Integrated Products)EVAL KIT I2C/SPI UART MAX3107 PDF資料下載
參數資料
| 型號： | MAX3107EVKIT+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 43/52頁 |
| 文件大小： | 0K |
| 描述： | EVAL KIT I2C/SPI UART MAX3107 |
| 產品培訓模塊： | Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 主要目的： | 接口，UART |
| 已用 IC / 零件： | MAX3107 |
| 主要屬性： | 圖形用戶界面（GUI） |
| 次要屬性： | I²C & SPI 接口 |
| 已供物品： | 板，線纜 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
SPI/I2C UART with 128-Word FIFOs
Low-Power Operation
To reduce the power consumption during normal opera-
tion, the following techniques can be adopted:
Do not use the internal PLL. This saves the most power
of the options listed here. Disable and bypass the PLL.
With the PLL enabled, the current to the VA supply is
in the range of a few mA (depending on clock and
multiplication factor), while it drops to below 1mA if
disabled.
Keep the internal clock rates as low as possible.
Use low voltage on the VA supply.
Use an external 1.8V supply. This saves the power
dissipated in the internal 1.8V linear regulator for the
1.8V logic supply. Connect the external 1.8V supply to
V18 and disable the internal regulator by connecting
LDOEN to DGND.
Interrupts and Polling
The host controller can manage and control the MAX3107
through polling and/or through interrupts. In polled
mode, the IRQ physical interrupt output is not used and
the host controller polls the ISR register at frequent inter-
vals to establish the state of the MAX3107.
Alternatively, the MAX3107’s physical IRQ interrupt
can be used to interrupt the host controller at specified
events, making polling unnecessary. The IRQ output is
an open-drain output that requires a pullup resistor to VL.
Logic-Level Translation
The MAX3107 can be directly connected to transceivers
and controllers that have different supply voltages. The
VL input defines the logic voltage levels of the control-
ler interface while the VEXT voltage defines the logic of
the transceiver interface. This ensures flexibility when
selecting a controller and transceiver. Figure 24 is an
example of a setup when the controller, transceiver, and
the MAX3107 are powered by three different supplies.
Figure 23. Startup and Initialization Flowchart
POWER-UP/
RST INPUT PULLED HIGH/
RST BIT SET LOW
IS IRQ HIGH?
OR
RevID READ
SUCCESSFULLY
Y
N
CONFIGURE
CLOCKING
CONFIGURE
MODES
CONFIGURE
FIFO CONTROL
CONFIGURE
FLOW CONTROL
CONFIGURE
GPIOs
START
COMMUNICATION
ENABLE
INTERRUPTS
48
Maxim Integrated
MAX3107
相關PDF資料 |
PDF描述 |
|---|---|
| GBB22DHLT | CONN EDGECARD 44POS .050 DIP SLD |
| CGS902U040R4C | CAP ALUM 9000UF 40V SCREW |
| A3AAH-6436M | IDC CABLE - ASC64H/AE64M/ASC64H |
| GBB30DHNN | CONN EDGECARD 60POS .050 DIP SLD |
| 383LX152M450B102VS | CAP ALUM 1500UF 450V 20% SNAP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3107EVKIT+ | 功能描述:UART 接口集成電路 UART with integrated Oscillator RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| MAX3108AEWA+ | 制造商:Maxim Integrated Products 功能描述:LOW SHUTDOWN CURRENT SPI/I?C UART WITH 128-WORD FIFOS IN WLP - Rail/Tube |
| MAX3108AEWA+T | 功能描述:UART 接口集成電路 SPI/I2C UART W/ 128 WORD FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| MAX3108EWA+ | 制造商:Maxim Integrated Products 功能描述:SPI/IAC UART WITH 128-WORD FIFOS IN WLP - Rail/Tube |
| MAX3108EWA+T | 功能描述:IC UART RoHS:是 類別:集成電路 (IC) >> 接口 - UART（通用異步接收器/發送器） 系列:* 標準包裝:250 系列:- 特點:* 通道數:2，DUART FIFO's:16 字節 規程:RS232，RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:托盤 其它名稱:XR16L2551IM-F-ND |
發布緊急采購，3分鐘左右您將得到回復。