- 您現在的位置：買賣IC網 > PDF目錄369814 > LPC2917 (NXP Semiconductors N.V.) ARM9 microcontroller with CAN and LIN PDF資料下載
參數資料
| 型號： | LPC2917 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 32位微控制器 |
| 英文描述： | ARM9 microcontroller with CAN and LIN |
| 中文描述： | 具有CAN和LIN的ARM9微控制器 |
| 文件頁數： | 33/68頁 |
| 文件大小： | 384K |
| 代理商： | LPC2917 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
DRAFTDRAFTDRAFTDRAFTDRAFTDRAFTD
LPC2917_19_1
NXP B.V. 2007. All rights reserved.
Preliminary data sheet
Rev. 1.01 — 15 November 2007
33 of 68
NXP Semiconductors
LPC2917/19
ARM9 microcontroller with CAN and LIN
Each ADC module has four start inputs. An ADC conversion is started when one of the
start ADC conditions is valid:
start 0: ADC external start input pin; can be triggered at a positive or negative edge.
Note that this signal is captured in the ADC clock domain
start 1: If the ‘preceding’ ADC conversion is ended, the sync_out signal starts an ADC
conversion. This signal is captured in the MSCSS subsystem clock domain, see
Section 8.7.5.2
. As can be seen in
Figure 8
, the sync_out of ADC1 is connected to the
start 1 input of ADC2 and the sync_out of ADC2 is connected to the start 1 input of
ADC1.
start 2: The PWM sync_out can start an ADC conversion. The sync_out signal is
synchronized to the ADC clock in the ADC module. This signal is captured in the
MSCSS subsystem clock domain.
start 3: The match outputs from MSCSS timer 0 are connected to the start 3 inputs of
the ADCs. This signal is captured in the ADC clock domain.
The PWM_sync and trans_enable_in of PWM 0 are connected to the 4th match output of
MSCSS timer 0 to start the PWM after a pre-programmed delay. This sync signal is
cascaded through all PWMs, allowing a programmable delay offset between subsequent
PWMs. The sync delay of each PWM can be programmed synchronously or with a
different phase for spreading the power load.
The match outputs of MSCSS timer 1 (PWM control) are connected to the corresponding
carrier inputs of the PWM modules. The carrier signal is modulated with the PWM-
generated waveforms.
The pause input of MSCSS timer 1 (PWM Control) is connected to an external input pin.
Generation of the carrier signal is stopped by asserting the pause of this timer.
The pause input of MSCSS timer 0 (ADC Control) is connected to a ‘NOR’ of the
PWM_sync outputs (start 2 input on the ADCs). If the pause feature of this timer is
enabled the timer only counts when one of the PWM_sync outputs is active HIGH. This
feature can be used to start the ADC once every x PWM cycles, where x corresponds to
the value in the match register of the timer. In this case the start 3 input of the ADC should
be enabled (start on match output of MSCSS timer 0).
The signals connected to the capture inputs of the timers (both MSCSS timer 0 and
MSCSS timer 1) are intended for debugging.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2919 | ARM9 microcontroller with CAN and LIN |
| LPC3180 | 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface |
| LPC61W26X | Microcontroller |
| LPC61W49X | Microcontroller |
| LPC660AIMX | Voltage-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2917/01 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ARM9 microcontroller with CAN and LIN |
| LPC2917FBD144 | 制造商:NXP Semiconductors 功能描述:IC MCU 32BIT ARM968 SMD LQFP144 |
| LPC2917FBD144,551 | 功能描述:ARM微控制器 - MCU ARM968 512K FL/48K RAM LIN 2.0 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2917FBD144/01 | 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM968E-S, 125MHZ, LQFP-144 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM968E-S, 125MHZ, LQFP-144, Controller Family/Series:LPC2900, Core Size:32bit, No. of I/O's:108, Supply Voltage Min:1.71V, Supply Voltage Max:1.89V, Digital IC Case Style:LQFP, No. of Pins:144, Program Memory Size:512KB, |
| LPC2917FBD144/01/, | 功能描述:ARM微控制器 - MCU ARM968 512K FL/48K RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。