- 您現在的位置：買賣IC網 > PDF目錄16231 > KSZ8842-16MVL-EVAL (Micrel Inc)BOARD EVALUATION KSZ8842-16MVL PDF資料下載
參數資料
| 型號： | KSZ8842-16MVL-EVAL |
| 廠商： | Micrel Inc |
| 文件頁數： | 47/141頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION KSZ8842-16MVL |
| 標準包裝： | 1 |
| 主要目的： | 接口，以太網控制器（PHY 和 MAC） |
| 嵌入式： | 否 |
| 已用 IC / 零件： | KSZ8842-16MVL |
| 主要屬性： | 2 個端口，100BASE-TX/10BASE-T |
| 次要屬性： | 8/16 位接口，LinkMD 線纜診斷 |
| 已供物品： | 板 |
| 相關產品： | 576-3270-ND - IC SWITCH ETH 2P 32BIT 128LQFP 576-3076-ND - IC MAC CTLR 2PORT ETH 100-LFBGA KSZ8842-32MVL-ND - IC ETHERNET SW 2PORT BUS 128LQFP 576-2120-ND - IC ETHERNET SW 2PORT BUS 128LQFP 576-2119-ND - IC ETHERNET SW 2PORT BUS 128LQFP |
| 其它名稱： | 576-1635 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁當前第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁
Micrel, Inc.
KSZ8842-16/32 MQL/MVL/MVLI/MBL
October 2007
140
M9999-102207-1.9
MDI
Medium Dependent Interface
An Ethernet port connection that allows network hubs or switches to
connect to other hubs or switches without a null-modem, or crossover,
cable. MDI provides the standard interface to a particular media (copper
or fiber) and is therefore 'media dependent.'
MDI-X Medium Dependent Interface Crossover
An Ethernet port connection that allows networked end stations (i.e.,
PCs or workstations) to connect to each other using a null-modem, or
crossover, cable. For 10/100 full-duplex networks, an end point (such as
a computer) and a switch are wired so that each transmitter connects to
the far end receiver. When connecting two computers together, a cable
that crosses the TX and RX is required to do this. With auto MDI-X, the
PHY senses the correct TX and RX roles, eliminating any cable
confusion.
MIB
Management Information Base
The MIB comprises the management portion of network devices. This
can include things like monitoring traffic levels and faults (statistical),
and can also change operating parameters in network nodes (static
forwarding addresses).
MII
Media Independent Interface
The MII accesses PHY registers as defined in the IEEE 802.3
specification.
NIC
Network Interface Card
An expansion board inserted into a computer to allow it to be connected
to a network. Most NICs are designed for a particular type of network,
protocol, and media, although some can serve multiple networks.
NPVID Non Port VLAN ID
The Port VLAN ID value is used as a VLAN reference.
PLL
Phase-Locked Loop
An electronic circuit that controls an oscillator so that it maintains a
constant phase angle (i.e., lock) on the frequency of an input, or
reference, signal. A PLL ensures that a communication signal is locked
on a specific frequency and can also be used to generate, modulate,
and demodulate a signal and divide a frequency.
PME Power Management Event
An occurrence that affects the directing of power to different
components of a system.
QMU Queue Management Unit
Manages packet traffic between MAC/PHY interface and the system
host. The QMU has built-in packet memories for receive and transmit
functions called TXQ (Transmit Queue) and RXQ (Receive Queue).
SA
Source Address
The address from which information has been sent.
TDR
Time Domain Reflectometry
TDR is used to pinpoint flaws and problems in underground and aerial
wire, cabling, and fiber optics. They send a signal down the conductor
and measure the time it takes for the signal -- or part of the signal -- to
return.
UTP
Unshielded Twisted Pair
Commonly a cable containing 4 twisted pairs of wires. The wires are
twisted in such a manner as to cancel electrical interference generated
in each wire, therefore shielding is not required.
VLAN Virtual Local Area Network
A configuration of computers that acts as if all computers are connected
by the same physical network but which may be located virtually
anywhere.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-JTN-EZ-F4 | CONVERTER MOD DC/DC 18.5V 25W |
| VE-JTN-EZ-F3 | CONVERTER MOD DC/DC 18.5V 25W |
| VE-JTN-EZ-F2 | CONVERTER MOD DC/DC 18.5V 25W |
| VE-JTN-EY-S | CONVERTER MOD DC/DC 18.5V 50W |
| VE-JT3-EY-S | CONVERTER MOD DC/DC 24V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8842-16MVLI | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-16MVLI TR | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-32 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with Non-PCI Interface |
| KSZ8842-32MQL | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (32-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-32MQLA6 | 功能描述:IC SWITCH 10/100 32BIT 128PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
發布緊急采購，3分鐘左右您將得到回復。