參數資料
型號： HYB18T512800AF-3.7
廠商： INFINEON TECHNOLOGIES AG
英文描述： 512-Mbit DDR2 SDRAM
中文描述： 512兆位DDR2 SDRAM的
文件頁數： 68/117頁
文件大小： 2102K
代理商： HYB18T512800AF-3.7
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁當前第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁
HYB18T512[40/80/16]0AF–[3/3S/3.7/5]
512-Mbit DDR2 SDRAM
Functional Description
Data Sheet
68
Rev. 1.3, 2005-01
09112003-SDM9-IQ3P
Figure 53
Auto Refresh Timing
3.24.2
Self-Refresh Command
The Self-Refresh command can be used to retain data,
even if the rest of the system is powered down. When
in the Self-Refresh mode, the DDR2 SDRAM retains
data without external clocking. The DDR2 SDRAM
device has a built-in timer to accommodate Self-
Refresh operation. The Self-Refresh Command is
defined by having CS, RAS, CAS and CKE held LOW
with WE HIGH at the rising edge of the clock. The
device must be in idle state and ODT must be turned off
before issuing Self Refresh command, by either driving
ODT pin LOW or using EMRS(1) command. Once the
command is registered, CKE must be held LOW to
keep the device in Self-Refresh mode. The DLL is
automatically disabled upon entering Self Refresh and
is automatically enabled upon exiting Self Refresh.
When the DDR2 SDRAM has entered Self-Refresh
mode all of the external control signals, except CKE,
are “don’t care”. The DRAM initiates a minimum of one
Auto Refresh command internally within
t
CKE
period
once it enters Self Refresh mode. The clock is internally
disabled during Self-Refresh Operation to save power.
The minimum time that the DDR2 SDRAM must remain
in Self Refresh mode is
t
CKE
. The user may change the
external clock frequency or halt the external clock one
clock after Self-Refresh entry is registered, however,
the clock must be restarted and stable before the
device can exit Self-Refresh operation.
The procedure for exiting Self Refresh requires a
sequence of commands. First, the clock must be stable
prior to CKE going back HIGH. Once Self-Refresh Exit
command is registered, a delay of at least
t
XSNR
must
be satisfied before a valid command can be issued to
the device to allow for any internal refresh in progress.
CKE must remain HIGH for the entire Self-Refresh exit
period
t
XSRD
for proper operation. Upon exit from Self
Refresh, the DDR2 SDRAM can be put back into Self
Refresh mode after
t
XSNR
expires. NOP or deselect
commands must be registered on each positive clock
edge during the Self-Refresh exit interval
t
XSNR
. ODT
should be turned off during
t
XSNR
.
The use of Self Refresh mode introduces the possibility
that an internally timed refresh event can be missed
when CKE is raised for exit from Self Refresh mode.
Upon exit from Self Refresh, the DDR2 SDRAM
requires a minimum of one extra auto refresh command
before it is put back into Self Refresh Mode.
T0
T2
T1
T3
AR
CK, CK
CMD
Precharge
> = t
RP
NOP
AUTO
REFRESH
ANY
NOP
> = t
RFC
> = t
RFC
AUTO
REFRESH
NOP
NOP
NOP
CKE
"high"
相關PDF資料
PDF描述
HYB18T512800AF-3S 512-Mbit DDR2 SDRAM
HYB18T512800AC-37 M39012 MIL RF CONNECTOR
HYB18T512800AC-5 M39012 MIL RF CONNECTOR
HYB18T512800AC DDR2 Registered Memory Modules
HYB18T512800AF DDR2 Registered Memory Modules
相關代理商/技術參數
參數描述
HYB18T512800AF-3S 制造商:Qimonda 功能描述: 制造商:Infineon Technologies AG 功能描述:32M X 16 DDR DRAM, 0.45 ns, PBGA84
HYB18T512800BF-2.5 功能描述:IC DDR2 SDRAM 512MBIT 60TFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:60 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:16K (2K x 8) 速度:2MHz 接口:SPI 3 線串行 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 產品目錄頁面:1449 (CN2011-ZH PDF)
HYB18T512800BF-3.7 功能描述:IC DDR2 SDRAM 512MBIT 60TFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C，2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN（2x3） 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)
HYB18T512800BF-3S 功能描述:IC DDR2 SDRAM 512MBIT 60TFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:2,500 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:1K (128 x 8) 速度:100kHz 接口:UNI/O?（單線） 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MSOP 包裝:帶卷 (TR)
HYB25D128160AT-6 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:128 Mbit Double Data Rate SDRAM
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*