- 您現在的位置：買賣IC網 > PDF目錄385399 > HT47C20 (Holtek Semiconductor Inc.) 8-BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | HT47C20 |
| 廠商： | Holtek Semiconductor Inc. |
| 元件分類： | 8位微控制器 |
| 英文描述： | 8-BIT MICROCONTROLLER |
| 中文描述： | 8位微控制器 |
| 文件頁數： | 11/56頁 |
| 文件大?。?/td> | 352K |
| 代理商： | HT47C20 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
HT47C20
11
January 18, 2000
must be placed in TBLP. The TBLH is read
only and cannot be restored. If the main rou-
tine and the ISR (Interrupt Service Routine)
both employ the table read instruction, the
contents of the TBLH in the main routine are
likely to be changed by the table read instruc-
tion used in the ISR. Errors can occur. In
other words, using the table read instruction
in the main routine and the ISR simulta-
neously should be avoided. However, if the ta-
ble read instruction has to be applied in both
the main routine and the ISR, the interrupt is
supposed to be disabled prior to the table read
instruction. It will not be enabled until the
TBLH has been backed up. All table related
instructions need two cycles to complete the
operation. These areas may function as nor-
mal program memory depending upon the re-
quirements.
Stack register
STACK
This is a special part of the memory which is
used to save the contents of the program coun-
ter (PC) only. The stack is organized into four
levels and is neither part of the data nor part of
the program space, and is neither readable nor
writeable. The activated level is indexed by the
stack pointer (SP) and is neither readable nor
writeable. At a subroutine call or interrupt ac-
knowledgment, the contents of the program
counter arepushedontothestack.Attheendofa
subroutine or an interrupt routine, signaled by
a return instruction (RET or RETI), the pro-
gram counter is restored to its previous value
from the stack. After a chip reset, the SP will
point to the top of the stack.
If the stack is full and a non-masked interrupt
takes place, the interrupt request flag will be
recorded but the acknowledgment will be inhib-
ited. When the stack pointer is decremented (by
RET or RETI), the interrupt will be serviced.
This feature prevents stack overflow allowing
the programmer to use the structure more eas-
ily. In a similar case, if the stack is full and a
CALL is subsequently executed, stack over-
flow occurs and the first entry will be lost (only
the most recent four return addresses are
stored).
Data memory
RAM
The data memory is designed with 83
The data memory and is divided into two func-
tional groups: special function registers and
general purpose data memory (64 8). Most are
read/write, but some are read only.
8 bits.
The special function registers include the indi-
rect addressing register 0 (00H), the memory
pointer register 0 (mp0; 01H), the indirect ad-
dressing register 1 (02H), the memory pointer
register 1 (MP1;03H), the bank pointer
(BP;04H), the accumulator (ACC;05H), the pro-
gram counter lower-order byte register
(PCL;06H), the table pointer (TBLP;07H), the
table higher-order byte register (TBLH;08H),
the real time clock control register (RTCC;09H),
the status register (STATUS;0AH), the inter-
ruptcontrolregister0(INTC0;0BH),theI/Oreg-
isters (PA;12H, PB;14H), the interrupt control
register 1 (INTC1;1EH), the timer/event counter
Ahigher order byte register (TMRAH; 20H), the
timer/event counter A lower order byte register
(TMRAL; 21H), the timer/event counter control
register (TMRC; 22H), the timer/event counter B
higher order byte register (TMRBH; 23H), the
timer/event counter B lower order byte register
(TMRBL; 24H), and the RC oscillator type A/D
Instruction(s)
Table Location
*10
*9
*8
*7
*6
*5
*4
*3
*2
*1
*0
TABRDC [m]
P10
P9
P8
@7
@6
@5
@4
@3
@2
@1
@0
TABRDL [m]
1
1
1
@7
@6
@5
@4
@3
@2
@1
@0
Table location
Note: *10~*0: Table location bits
@7~@0: Table pointer bits
P10 P8: Current program counter bits
相關PDF資料 |
PDF描述 |
|---|---|
| HT47R20 | 8 位R-F 型OTP 單片機 |
| HT48C05 | Cost-Effective I/O Type 8-Bit MCU |
| HT48C06 | Cost-Effective I/O Type 8-Bit MCU |
| HT48C10-1 | 8-Bit High Performance RISC-like Microcontroller Suitable for Multiple I/O Application(高性能、指令類似RISC的8位微控制器，用于多I/O接口設備) |
| HT48C50-1 | 8-Bit High Performance RISC-like Microcontroller Suitable for Multiple I/O Application(高性能、指令類似RISC的8位微控制器，用于多I/O接口設備) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT47C20_02 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:8-Bit R-F Type Mask MCU |
| HT47C20-1 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:R-F Type 8-Bit MCU |
| HT47C20-1_08 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:R-F Type 8-Bit MCU |
| HT47C20L | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:8-Bit Microcontroller |
| HT47C20L_05 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:R-F Type Low Voltage 8-Bit Mask MCU |
發布緊急采購，3分鐘左右您將得到回復。