參數資料
型號： ATMEGA1284-PU
廠商： Atmel
文件頁數： 29/160頁
文件大?。?/td> 0K
描述： IC MCU AVR 128K FLASH 40PDIP
產品培訓模塊： MCU Product Line Introduction
megaAVR Introduction
標準包裝： 10
系列： AVR® ATmega
核心處理器： AVR
芯體尺寸： 8-位
速度： 20MHz
連通性： I²C，SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 32
程序存儲器容量： 128KB（64K x 16）
程序存儲器類型： 閃存
EEPROM 大?。?/td> 4K x 8
RAM 容量： 16K x 8
電壓 - 電源 (Vcc/Vdd)： 1.8 V ~ 5.5 V
數據轉換器： A/D 8x10b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 40-DIP（0.600"，15.24mm）
包裝： 管件
配用： ATSTK600-RC05-ND - STK600 ROUTING CARD AVR
124
8272E–AVR–04/2013
ATmega164A/PA/324A/PA/644A/PA/1284/P
16.9.1
Compare Output Mode and Waveform Generation
The Waveform Generator uses the COMnx1:0 bits differently in normal, CTC, and PWM modes.
For all modes, setting the COMnx1:0 = 0 tells the Waveform Generator that no action on the
OCnx Register is to be performed on the next compare match. For compare output actions in the
non-PWM modes refer to Table 16-2 on page 133. For fast PWM mode refer to Table 16-3 on
page 134, and for phase correct and phase and frequency correct PWM refer to Table 16-4 on
A change of the COMnx1:0 bits state will have effect at the first compare match after the bits are
written. For non-PWM modes, the action can be forced to have immediate effect by using the
FOCnx strobe bits.
16.10 Modes of Operation
The mode of operation, that is, the behavior of the Timer/Counter and the Output Compare pins,
is defined by the combination of the Waveform Generation mode (WGMn3:0) and Compare Out-
put mode (COMnx1:0) bits. The Compare Output mode bits do not affect the counting sequence,
while the Waveform Generation mode bits do. The COMnx1:0 bits control whether the PWM out-
put generated should be inverted or not (inverted or non-inverted PWM). For non-PWM modes
the COMnx1:0 bits control whether the output should be set, cleared or toggle at a compare
For detailed timing information refer to ”Timer/Counter Timing diagrams” on page 131.
16.10.1
Normal mode
The simplest mode of operation is the Normal mode (WGMn3:0 = 0). In this mode the counting
direction is always up (incrementing), and no counter clear is performed. The counter simply
overruns when it passes its maximum 16-bit value (MAX = 0xFFFF) and then restarts from the
BOTTOM (0x0000). In normal operation the Timer/Counter Overflow Flag (TOVn) will be set in
the same timer clock cycle as the TCNTn becomes zero. The TOVn Flag in this case behaves
like a 17th bit, except that it is only set, not cleared. However, combined with the timer overflow
interrupt that automatically clears the TOVn Flag, the timer resolution can be increased by soft-
ware. There are no special cases to consider in the Normal mode, a new counter value can be
written anytime.
The Input Capture unit is easy to use in Normal mode. However, observe that the maximum
interval between the external events must not exceed the resolution of the counter. If the interval
between events are too long, the timer overflow interrupt or the prescaler must be used to
extend the resolution for the capture unit.
The Output Compare units can be used to generate interrupts at some given time. Using the
Output Compare to generate waveforms in Normal mode is not recommended, since this will
occupy too much of the CPU time.
16.10.2
Clear Timer on Compare Match (CTC) mode
In Clear Timer on Compare or CTC mode (WGMn3:0 = 4 or 12), the OCRnA or ICRn Register
are used to manipulate the counter resolution. In CTC mode the counter is cleared to zero when
the counter value (TCNTn) matches either the OCRnA (WGMn3:0 = 4) or the ICRn (WGMn3:0 =
12). The OCRnA or ICRn define the top value for the counter, hence also its resolution. This
mode allows greater control of the compare match output frequency. It also simplifies the opera-
tion of counting external events.
相關PDF資料
PDF描述
VE-B2M-IY-F3 CONVERTER MOD DC/DC 10V 50W
VE-B2M-IY-F2 CONVERTER MOD DC/DC 10V 50W
ATMEGA3250V-8AU IC AVR MCU 32K 8MHZ 100TQFP
ATMEGA3250-16AU IC AVR MCU 32K 16MHZ 100TQFP
VE-B2L-IY-F3 CONVERTER MOD DC/DC 28V 50W
相關代理商/技術參數
參數描述
ATMEGA1284P-XPLD 功能描述:開發板和工具包 - AVR MEGA-1284P Xplained Evaluation kit RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V
ATMEGA1284RFR2-ZF 制造商:Atmel Corporation 功能描述:2.4GHZ 128K SOC 48PIN IND 125C TRAY - Trays 制造商:Atmel Corporation 功能描述:IC MCU 8BIT 128KB FLASH 48VQFN 制造商:Atmel Corporation 功能描述:2.4GHZ 128K SOC 48pin Ind 125C Tray
ATMEGA1284RFR2-ZFR 制造商:Atmel Corporation 功能描述:2.4GHZ 128K SOC 48 PIN IND125C T&R - Tape and Reel 制造商:Atmel Corporation 功能描述:IC MCU 8BIT 128KB FLASH 48VQFN 制造商:Atmel Corporation 功能描述:2.4GHZ 128K SOC 48 pin Ind125C T&R
ATMEGA1284RFR2-ZU 制造商:Atmel Corporation 功能描述:2.4GHZ 802.15.4 128K SOC 48PIN TRAY - Trays 制造商:Atmel Corporation 功能描述:IC MCU 8BIT 128KB FLASH 48VQFN 制造商:Atmel Corporation 功能描述:2.4GHZ 802.15.4 128K SOC 48pin Tray
ATMEGA1284RFR2-ZUR 制造商:Atmel Corporation 功能描述:2.4GHZ 802.15.4 128K SOC 48PIN T&R - Tape and Reel 制造商:Atmel Corporation 功能描述:IC MCU 8BIT 128KB FLASH 48VQFN 制造商:Atmel Corporation 功能描述:2.4GHZ 802.15.4 128K SOC 48pin T&R
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*