- 您現在的位置：買賣IC網 > PDF目錄374039 > ADUC836BS (ANALOG DEVICES INC) MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU PDF資料下載
參數資料
| 型號： | ADUC836BS |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU |
| 中文描述： | 8-BIT, FLASH, 12.58 MHz, MICROCONTROLLER, PQFP52 |
| 封裝： | 14 X 14 MM, MO-022-AC-1, MQFP-52 |
| 文件頁數： | 42/80頁 |
| 文件大小： | 5913K |
| 代理商： | ADUC836BS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
ADuC836
–42–
WATCHDOG TIMER
The purpose of the watchdog timer is to generate a device reset
or interrupt within a reasonable amount of time if the ADuC836
enters an erroneous state, possibly due to a programming error,
electrical noise, or RFI. The watchdog function can be disabled
by clearing the WDE (Watchdog Enable) bit in the Watchdog
Control (WDCON) SFR. When enabled, the watchdog circuit will
generate a system reset or interrupt (WDS) if the user program
fails to set the watchdog (WDE) bit within a predetermined
amount of time (see PRE3–0 bits in WDCON). The watchdog
timer itself is a 16-bit counter that is clocked at 32.768 kHz. The
watchdog timeout interval can be adjusted via the PRE3–0 bits in
WDCON. Full control and status of the watchdog timer function
can be controlled via the Watchdog Timer Control SFR (WDCON).
The WDCON SFR can only be written by user software if the
double write sequence described in WDWR below is initiated on
every write access to the WDCON SFR.
Table XIX. WDCON SFR Bit Designations
Bit Name
7 PRE3
6 PRE2
5 PRE1
4 PRE0
3 WDIR
Description
Watchdog Timer Prescale Bits.
The Watchdog timeout period is given by the equation t
WD
= (2
PRE
(2
9
/f
PLL
))
(0
PRE
7; f
PLL
= 32.768 kHz)
Timeout
PRE3 PRE2
PRE1
PRE0
Period (ms)
0
0
0
0
15.6
0
0
0
1
31.2
0
0
1
0
62.5
0
0
1
1
125
0
1
0
0
250
0
1
0
1
500
0
1
1
0
1000
0
1
1
1
2000
1
0
0
0
0.0
PRE3–0 > 1001
Watchdog Interrupt Response Enable Bit. If this bit is set by the user, the watchdog will generate an interrupt
response instead of a system reset when the watchdog timeout period has expired. This interrupt is not disabled by
the CLR EA instruction, and it is also a fixed, high priority interrupt. If the watchdog is not being used to monitor
the system, it can alternatively be used as a timer. The prescaler is used to set the timeout period in which an
interrupt will be generated. (See also Note 1, Table XXXIX in the Interrupt System section.)
Watchdog Status Bit.
Set by the watchdog controller to indicate that a watchdog timeout has occurred.
Cleared by writing a 0 or by an external hardware reset. It is not cleared by a watchdog reset.
Watchdog Enable Bit.
Set by user to enable the watchdog and clear its counters. If a 1 is not written to this bit within the watchdog timeout
period, the watchdog will generate a reset or interrupt, depending on WDIR.
Cleared under the following conditions: User writes 0, watchdog reset (WDIR = 0); hardware reset; PSM interrupt.
Watchdog Write Enable Bit.
To write data into the WDCON SFR involves a double instruction sequence. The WDWR bit must be set and the
very next instruction must be a write instruction to the WDCON SFR. For example:
CLR
EA
; disable interrupts while writing
; to WDT
SETB
WDWR
; allow write to WDCON
MOV
WDCON, #72h
; enable WDT for 2.0s timeout
SETB
EA
; enable interrupts again (if rqd)
Action
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Reset or Interrupt
Immediate Reset
Reserved
2 WDS
1 WDE
0 WDWR
WDCON Watchdog Timer Control Register
SFR Address C0H
Power-On Default Value 10H
Bit Addressable Yes
REV. A
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC842BCP62-3 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC843BCP62-5 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC842BCP62-5 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC843BCP62-3 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC842BCP32-3 | MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC836BS | 制造商:Analog Devices 功能描述:IC SEMICONDUCTOR ((NS)) |
| ADUC836BSZ | 功能描述:IC ADC DUAL 16BIT W/MCU 52-MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN，SCI，SPI 外圍設備:POR，PWM，溫度傳感器，WDT 輸入/輸出數:21 程序存儲器容量:40KB（20K x 16） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| ADUC841 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| ADUC841BCP32-5 | 制造商:Analog Devices 功能描述:MICROCONVERTER 1-CYCLE VERSION ADUC829 - Trays |
| ADUC841BCP62-3 | 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 62KB Flash 3V 56-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:8BIT CISC 62KB FLASH 20MHZ 3.3V 56LFCSP - Bulk |
發布緊急采購，3分鐘左右您將得到回復。