- 您現在的位置：買賣IC網 > PDF目錄24822 > 935266671518 (NXP SEMICONDUCTORS) 1 CHANNEL(S), 400M bps, SERIAL COMM CONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | 935266671518 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 1 CHANNEL(S), 400M bps, SERIAL COMM CONTROLLER, PQFP144 |
| 封裝： | 20 X 20 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-486-1, LQFP-144 |
| 文件頁數： | 6/83頁 |
| 文件大?。?/td> | 316K |
| 代理商： | 935266671518 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁
Philips Semiconductors
Preliminary specification
PDI1394L41
1394 content protection AV link layer controller
2000 Dec 01
11
12.2.5
Audio Support
The AV transmitter has some additional features to support some types of audio transport. These are enabled by setting bit 30 (AUDIO) of
ITXPKCTL (0x020) to logic 1. At the rising edge of AVxFSYNC, a SYT time stamp will be generated and written into the SYT queue of the
isochronous transmitter. This stamp will point to a time in the future dictated by the following formula:
SYT[15:12] = CYCTM[15:12] + programmed SYT_DELAY value + 2
SYT[11:0] = CYCTM[11:0]
The additional delay of two cycles is specific to this AUDIO mode. The oldest SYT time stamp in the SYT queue will be sent first, but only when
accompanied by a data payload. Any pending SYT time stamp will be held until the next non-empty bus packet is sent. At the moment of
transmission, the SYT time stamp should at least point one cycle in the future. If it points to a time that is less than one cycle in the future, it will
be discarded.
The SYT queue in the isochronous transmitter can store 4 entries, the SYT queue in the isochronous receiver can store six entries. This
supports the case where an 8 kHz signal is applied to AVxFSYNC, and AUDIO = 1, and SYT_Delay = 2. Assuming there is data on every cycle,
the receiver will receive an SYT time stamp each cycle with the first SYT time stamp pointing just less than six cycles in the future. When the
SYT queue in the isochronous receiver is full, then the most recently received SYT time stamp is overwritten with the next arriving SYT time
stamp. If the queue should become full or contain a corrupted time stamp, the queue will automatically clear and indicate so by setting the
“SYTOVF” interrupt.
12.2.6
SY – Sync Support
This feature supports the 1394 digital camera specification. The state of this pin will be reflected in the SY bit (ITXCTL register 0x034) and will
be transmitted along with the isochronous data block that was entered with it. The intended use of this pin is to signal the start of a new frame of
video in the isochronous header section of the data payload. Similarly, the isochronous receiver will assert the AVxSY pin simultaneously with
the first byte of the isochronous bus packet in which the SY value was received. NOTE: The SY functionality is only intended to be used when
the M6 cipher and de-cipher are not enabled.
SV01787
AV DATA
AV SYNC
AV SY
Figure 1.
Behavior of “SY” signal at AVport of receiver
12.2.7
Programmable Buffer Memory
The PDI1394L41 maintains six distinct buffers that are highly configurable to optimize bandwidth capabilities. Buffers can be increased or
decreased from the default value by accessing the indirect address range of 0x100 through 0x1FC (INDADDR, 0x0F8). If the AV Layer is
configured to transmit or receive DVB compliant MPEG-2 type data, the default Isochronous (AV) buffer sizes are recommended. FIFO sizes
cannot be changed dynamically; after a FIFO size change, transmitters and receivers must be reset.
Buffers can be programmed with 64 quadlet (256 Byte) granularity. Minimum buffer size is 64 quadlets, maximum buffer size is limited to 11 kB.
The sum of all buffers cannot exceed 12K Bytes, or 3K Quadlets.
DEFAULT BUFFER SIZE
BUFFER MEMORY
SIZE
(Quadlets)
Asynchronous Receive Response FIFO
256
Asynchronous Receive Request FIFO
256
Asynchronous Transmit Response FIFO
256
Asynchronous Transmit Request FIFO
256
Isochronous (AV) Transmit Buffer
1024
Isochronous (AV) Receive Buffer
1024
相關PDF資料 |
PDF描述 |
|---|---|
| 08-55-0134 | KK 156 TERMINAL CRIMP 18-24 AWG GOLD |
| 08-55-0133 | KK 156 TERMINAL CRIMP 18-24 AWG GOLD |
| 08-58-0111 | Connector |
| 08-50-0187 | Solderless Terminal; Body Material:Brass; Contact Plating:Tin; Series:6838; Wire Size (AWG):20-18; External Depth:0.11"; Lead Pitch:3.96"; Operating Temp. Min:0 C; Reel Quantity:7000; Voltage Rating:250V |
| 08-50-0189 | Solderless Terminal; Body Material:Brass; Contact Plating:Tin; Series:6838; Wire Size (AWG):20-18; External Depth:0.11"; Lead Pitch:3.96mm; Operating Temp. Min:0 C; Voltage Rating:250V RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 935267356112 | 制造商:NXP Semiconductors 功能描述:IC TEA1507PN |
| 935268081112 | 制造商:NXP Semiconductors 功能描述:SUB ONLY IC |
| 935268721125 | 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R |
| 935269304128 | 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP |
| 935269544557 | 制造商:NXP Semiconductors 功能描述:SUB ONLY TDA9587-2US1-V1.3 |
發布緊急采購，3分鐘左右您將得到回復。