- 您現在的位置：買賣IC網 > PDF目錄376463 > XRT83SL28IV (EXAR CORP) 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT PDF資料下載
參數資料
| 型號： | XRT83SL28IV |
| 廠商： | EXAR CORP |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| 中文描述： | DATACOM, PCM TRANSCEIVER, PQFP144 |
| 封裝： | 20 X 20 MM, 1.40 MM HEIGHT, TQFP-144 |
| 文件頁數： | 29/47頁 |
| 文件大?。?/td> | 377K |
| 代理商： | XRT83SL28IV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
xr
REV. 1.0.0
XRT83SL28
8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT
27
3.2.3
The receivers on the backup card should be programmed for "High" impedance. Since there is no external
resistor in the circuit, the receivers on the backup card will not load down the line interface. This key design
feature eliminates the need for relays and provides one bill of materials for all interface modes of operation.
Select the impedance for the desired mode of operation, E1 75
or 120
. To swap the primary card, set the
backup card to internal impedance, then the primary card to "High" impedance. See Figure 22. for a simplified
block diagram of the receive section for a 1:1 redundancy scheme.
F
IGURE
22. S
IMPLIFIED
B
LOCK
D
IAGRAM
OF
THE
R
ECEIVE
I
NTERFACE
FOR
1:1
AND
1+1 R
EDUNDANCY
Receive Interface with 1:1 and 1+1 Redundancy
3.2.4
N+1 redundancy has one backup card for N primary cards. Due to impedance mismatch and signal
contention, external relays are necessary when using this redundancy scheme. The relays create complete
isolation between the primary cards and the backup card. This allows all transmitters and receivers on the
primary cards to be configured in internal impedance, providing one bill of materials for all interface modes of
operation. The transmit and receive sections of the LIU device are described separately.
N+1 Redundancy Using External Relays
"High" Impedance
Internal Impedance
Backplane Interface
Primary Card
Backup Card
XRT83SL28
Rx
E1 Line
Rx
1:1
1:1
XRT83SL28
相關PDF資料 |
PDF描述 |
|---|---|
| XRT83SL30 | SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83SL30IV | SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83VSH28 | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH28IB | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH314 | 14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT83SL28IV-F | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SL30 | 制造商:EXAR 制造商全稱:EXAR 功能描述:SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83SL30ES | 功能描述:外圍驅動器與原件 - PCI 1 CHT1/E1 LIUSH RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SL30IV | 制造商:EXAR 制造商全稱:EXAR 功能描述:SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83SL30IV-F | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。