- 您現在的位置：買賣IC網 > PDF目錄297500 > TL16PNP100APT (TEXAS INSTRUMENTS INC) SPECIALTY MICROPROCESSOR CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | TL16PNP100APT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PQFP48 |
| 封裝： | PLASTIC, QFP-48 |
| 文件頁數： | 8/21頁 |
| 文件大?。?/td> | 304K |
| 代理商： | TL16PNP100APT |
TL16PNP100A
STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER
SLLS200C – MARCH 1995 – REVISED SEPTEMBER 1997
16
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
Table 6. PnP Logical Device Configuration Registers (continued)
ADDRESS PORT
VALUE
REGISTER NAME VALUE
READ/WRITE
CAPABILITY
POWER UP
0
×74
DMA CHANNEL SELECT 0
Read only
00 00 01 00
This register has a value of 4 to indicate that DMA is not supported.
0
×75
DMA CHANNEL SELECT 1
Read only
00 00 01 00
This register has a value of 4 to indicate that DMA is not supported.
EEPROM
The TL16PNP100A has been designed to interface with the ST93C56/66 EEPROM (SGS-Thomson) or an
equivalent. The EEPROM provides the block size for each device and the PnP resource data.
memory organization
The EEPROM should be organized as 128/255 words times 16 bits, so its ORG terminal should be connected
to VCC or left unconnected. The EEPROM memory organization is shown in Table 7.
Table 7. EEPROM Memory Organization
EEPROM
LOCATION
BIT LOCATION
X 0 0 0
X 128/255
PnP Resource Data
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
EEPROM READ (see Figure 8 and Figure 9)
This device only supports read transactions. The READ op code instruction (10) must be sent to the EEPROM.
The op code is then followed by an 8-bit-long address for the 16-bit word. The READ op code with accompanying
address directs the EEPROM to output serial data on the EEPROM data terminals D and Q, which is connected
to the TL16PNP100A bidirectional serial data bus (SIO). Specifically, when a READ op code and address are
received, the instruction and address are decoded and the addressed EEPROM data is transferred into an
output shift register in the EEPROM. Each read transaction consists of a start bit, 2-bit op code (10), 8-bit
address, and 16-bit data. The TL16PNP100A does not accommodate the EEPROM autoaddress next-word
feature.
READ op code transfer (see Figure 8)
Initially, the EEPROM chip select signal (S) which connects to the TL16PNP100A EEPROM chip select (CS),
is raised. The EEPROM data, D and Q, then sample the TL16PNP100A SIO line on the following rising edges
of the TL16PNP100A serial clock, SCLK, until a 1 is sampled and decoded by the EEPROM as a start bit. The
TL16PNP100A SCLK signal connects to the EEPROM clock C. The READ op code (10) is then sampled on
the next two rising edges of SCLK. TL16PNP100A sources the op code at the falling edges of SCLK.
相關PDF資料 |
PDF描述 |
|---|---|
| TL431BU | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, PDSO3 |
| TLE4252D | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO4 |
| TLK4201EARGTRG4 | 4.25-GBPS CABLE AND PC BOARD EQUALIZER |
| TLK4201EARGTR | 4.25-GBPS CABLE AND PC BOARD EQUALIZER |
| TLK4201EARGTTG4 | 4.25-GBPS CABLE AND PC BOARD EQUALIZER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TL16PNP200 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER |
| TL16PNP200A | 制造商:TI 制造商全稱:Texas Instruments 功能描述:STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER |
| TL16PNP550A | 制造商:TI 制造商全稱:Texas Instruments 功能描述:ASYNCHRONOUS COMMUNICATIONS ELEMENT WITH PLUG-AND-PLAY (PnP) AND AUTOFLOW CONTROL |
| TL16PNP550AFN | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TL-17 | 功能描述:手工工具 TOOL RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool |
發布緊急采購，3分鐘左右您將得到回復。