- 您現在的位置：買賣IC網 > PDF目錄25646 > SPC563M64L5COAY (STMICROELECTRONICS) 32-BIT, FLASH, 80 MHz, MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | SPC563M64L5COAY |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 80 MHz, MICROCONTROLLER, PQFP144 |
| 封裝： | 20 X 20 MM, LEAD FREE, LQFP-144 |
| 文件頁數： | 71/140頁 |
| 文件大?。?/td> | 1310K |
| 代理商： | SPC563M64L5COAY |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
SPC563M64
Overview
Doc ID 14642 Rev 6
●
Can optionally cause system reset or interrupt request on timeout
●
Reset by writing a software key to memory mapped register
●
Enabled out of reset
●
Configuration is protected by a software key or a write-once register
1.3.20
Debug Features
Nexus Port Controller
The NPC (Nexus Port Controller) block provides real-time development support capabilities
for the SPC563Mxx Power Architecture-based MCU in compliance with the IEEE-ISTO
5001-2003 standard. This development support is supplied for MCUs without requiring
external address and data pins for internal visibility. The NPC block is an integration of
several individual Nexus blocks that are selected to provide the development support
interface for the SPC563Mxx. The NPC block interfaces to the host processor (e200z335),
eTPU, and internal buses to provide development support as per the IEEE-ISTO 5001-2003
standard. The development support provided includes program trace and run-time access to
the MCUs internal memory map and access to the Power Architecture and eTPU internal
registers during halt. The Nexus interface also supports a JTAG only mode using only the
JTAG pins. SPC563Mxx in the production LQFP144 supports a 3.3 V reduced (4-bit wide)
Auxiliary port. These Nexus port pins can also be used as 5 V I/O signals to increase usable
I/O count of the device. When using this Nexus port as IO, Nexus trace is still possible using
calibration tool calibration. In the calibration tool calibration package, the full 12-bit Auxiliary
port is available.
Note:
In the calibration tool package, the full Nexus Auxiliary port shares balls with the addresses
of the calibration bus. Therefore multiplexed address/data bus mode must be used for the
calibration bus when using full width Nexus trace in calibration tool assembly.
The following features are implemented:
●
5-pin JTAG port (JCOMP, TDI, TDO, TMS, and TCK)
–
Always available in production package
–
Supports both JTAG Boundary Scan and debug modes
–3.3 V interface
–
Supports Nexus class 1 features
–
Supports Nexus class 3 read/write feature
●
9-pin Reduced Port interface in LQFP144 production package
–
Alternate function as IO
–
5 V (in GPIO or alternate function mode), 3.3 V (in Nexus mode) interface
–
Auxiliary Output port
1 MCKO (message clock out) pin
4 MDO (message data out) pins
2 MSEO (message start/end out) pins
1 EVTO (event out) pin
–
Auxiliary input port
1 EVTI (event in) pin
相關PDF資料 |
PDF描述 |
|---|---|
| SPL2Y81 | 808 nm, LASER DIODE |
| SPL2Y98 | 975 nm, LASER DIODE |
| SPLBS79 | LASER DIODE |
| SPLEB98-E | 975 nm, LASER DIODE |
| SPLQY81 | 808 nm, LASER DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SPC563M64L7COAR | 功能描述:32位微控制器 - MCU 32-BIT Embedded MCU 80 MHz, 1.5 Mbyte RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| SPC563M64L7COAY | 制造商:STMicroelectronics 功能描述:JDP MICRO - Bulk |
| SPC563M64L7-ENG | 制造商:STMicroelectronics 功能描述:ENG SAMPLES - Bulk |
| SPC563MADPT144S | 功能描述:32位微控制器 - MCU Socketed Mini Mod SPC563M QFP144 RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| SPC563MADPT176S | 功能描述:32位微控制器 - MCU Socketed Mini Mod SPC563M QFP176 RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。