- 您現在的位置：買賣IC網 > PDF目錄98084 > SN260Q (STMICROELECTRONICS) LOCAL AREA NETWORK CONTROLLER, QCC40 PDF資料下載
參數資料
| 型號： | SN260Q |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | LOCAL AREA NETWORK CONTROLLER, QCC40 |
| 封裝： | 6 X 6 MM, 0.90 MM HEIGHT, ROHS COMPLIANT, MQ220, QFN-40 |
| 文件頁數： | 29/47頁 |
| 文件大?。?/td> | 1592K |
| 代理商： | SN260Q |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
SN260
UART Gateway Protocol
8
UART Gateway Protocol
The UART Gateway protocol is designed for network gateway systems in which the host
processor is running a full-scale operating system such as embedded Linux or Windows.
The host sends EmberZNet Serial Protocol (EZSP) commands to the UART interface using
Ember’s Asynchronous Serial Host (ASH) protocol. The EZSP commands are the same as
those used in the SPI protocol, but the SPI protocol is better suited for resource-constrained
microcontroller hosts since ASH uses considerably more host RAM and program storage.
ASH implements error detection/recovery and tolerates latencies on multi-tasking hosts due
to scheduling and I/O buffering. The ASH protocol is described in detail in the UART
Gateway Protocol Reference, 120-3010-000.
Ember supplies ASH host software in source form compatible with Linux and Windows. In
most cases it will need only a few simple edits to adapt it to a particular host system.
Figure 13.
UART interface signals
The UART hardware interface uses the following SN260 signals:
●
Serial data: TXD and RXD
The ASH protocol sends data in both directions, so both TXD and RXD signals are
required. An external pull-up resistor should be connected to TXD to avoid data glitches
while the SN260 is resetting.
●
Flow control: nRTS and nCTS (optional)
ASH uses hardware handshaking for flow control: nRTS enables transmission from the
host to the SN260, and nCTS enables SN260 transmissions to the host. If the host
serial port cannot support RTS/CTS, XON/XOFF flow control may be used instead.
But, XON/XOFF will deliver slightly lower performance.
When using hardware flow control, the SN260’s nRTS must be able to control host
serial output. However, in many gateway systems, the host will not need to throttle
transmission by the SN260. In those systems nCTS may be left unconnected since it
has an internal pull-down and will be continuously asserted.
●
Reset control: nRESET
The host must be able to reset the SN260 to run the ASH protocol. The best way to do
this is to use a host output connected to nRESET. If this is not feasible, the host can
send a special ASH frame that requests the SN260 to reboot, but this method is less
reliable than asserting nRESET and is not recommended for normal use.
相關PDF資料 |
PDF描述 |
|---|---|
| SN54128J | TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDIP14 |
| SNJ54128W | TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDFP14 |
| SN54132J | TTL/H/L SERIES, QUAD 2-INPUT NAND GATE, CDIP14 |
| SN74S132N3 | S SERIES, QUAD 2-INPUT NAND GATE, PDIP14 |
| SN54175W | TTL/H/L SERIES, POSITIVE EDGE TRIGGERED D FLIP-FLOP, COMPLEMENTARY OUTPUT, CDFP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SN260QT | 功能描述:射頻收發(fā)器 ZIGBEE 802.15.4 NETWORK PROCESSOR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| SN2634 | 制造商:Omron Corporation 功能描述:RELAY ASSEMBLY |
| SN26500PWR | 制造商:Texas Instruments 功能描述: |
| SN27210DRKR | 制造商:Texas Instruments 功能描述:Custom firmware of BQ27210 |
| SN27322 | 制造商:Texas Instruments 功能描述: |
發(fā)布緊急采購，3分鐘左右您將得到回復。