參數資料
型號： SN260Q
廠商： STMICROELECTRONICS
元件分類： 微控制器/微處理器
英文描述： LOCAL AREA NETWORK CONTROLLER, QCC40
封裝： 6 X 6 MM, 0.90 MM HEIGHT, ROHS COMPLIANT, MQ220, QFN-40
文件頁數： 24/47頁
文件大?。?/td> 1592K
代理商： SN260Q
SPI protocol
SN260
SN260 in reset. While nRESET is asserted, assert (active low) either nWAKE or PTI_DATA
and then deassert nRESET to boot the SN260. Do not deassert nWAKE or PTI_DATA until
the SN260 asserts nHOST_INT, indicating that the SN260 has fully booted and is ready to
accept data over the SPI Protocol. Once nHOST_INT is asserted, nWAKE or PTI_DATA way
be deasserted. Refer to the EmberZNet Application Developer’s Guide (120-4028-000) for
more information on the bootloader and the format of the Bootloader Frame.
7.6.2
Unexpected resets
The SN260 is designed to protect itself against undefined behavior due to unexpected
resets. The protection is based on the state of Slave Select since the inter-command
spacing mandates that Slave Select must return to idle. The SN260’s internal SPI Protocol
uses Slave Select returning to idle as a trigger to re-initialize its SPI Protocol. By always re-
initializing, the SN260 is protected against the Host unexpectedly resetting or terminating a
transaction. Additionally, if Slave Select is active when the SN260 powers on, the SN260 will
ignore SPI data until Slave Select returns to idle. By ignoring SPI traffic until idle, the SN260
will not begin receiving in the middle of a transaction.
If the Host resets, in most cases it should reset the SN260 as well so that both devices are
once again in the same state: freshly booted. Alternately, the Host can attempt to recover
from the reset by recovering its previous state and resynchronizing with the state of the
SN260.
If the SN260 resets during a transaction, the Host can expect either a Wait Section timeout
or a missing Frame Terminator indicating an invalid Response.
If the SN260 resets outside of a transaction, the Host should proceed normally.
7.7
Transaction examples
This section contains the following transaction examples:
●
●
●
●
7.7.1
SPI protocol version
Figure 9.
SPI protocol version example
相關PDF資料
PDF描述
SN54128J TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDIP14
SNJ54128W TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDFP14
SN54132J TTL/H/L SERIES, QUAD 2-INPUT NAND GATE, CDIP14
SN74S132N3 S SERIES, QUAD 2-INPUT NAND GATE, PDIP14
SN54175W TTL/H/L SERIES, POSITIVE EDGE TRIGGERED D FLIP-FLOP, COMPLEMENTARY OUTPUT, CDFP16
相關代理商/技術參數
參數描述
SN260QT 功能描述:射頻收發器 ZIGBEE 802.15.4 NETWORK PROCESSOR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
SN2634 制造商:Omron Corporation 功能描述:RELAY ASSEMBLY
SN26500PWR 制造商:Texas Instruments 功能描述:
SN27210DRKR 制造商:Texas Instruments 功能描述:Custom firmware of BQ27210
SN27322 制造商:Texas Instruments 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*