- 您現在的位置：買賣IC網 > PDF目錄98084 > SN260Q (STMICROELECTRONICS) LOCAL AREA NETWORK CONTROLLER, QCC40 PDF資料下載
參數資料
| 型號： | SN260Q |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | LOCAL AREA NETWORK CONTROLLER, QCC40 |
| 封裝： | 6 X 6 MM, 0.90 MM HEIGHT, ROHS COMPLIANT, MQ220, QFN-40 |
| 文件頁數： | 18/47頁 |
| 文件大小： | 1592K |
| 代理商： | SN260Q |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
SN260
SPI protocol
7.2.7
Error conditions
If two or more different error conditions occur back to back, only the first error condition will
be reported to the Host (if it is possible to report the error). The following are error conditions
that might occur with the SN260.
●
Unsupported SPI command
If the SPI Byte of the command is unsupported, the SN260 will drop the incoming
command and respond with the Unsupported SPI Command Error Response. This
error means the SPI Byte is unsupported by the current Mode the SN260 is in.
Bootloader Frames can only be used with the bootloader and EZSP Frames can only
be used with the EZSP.
●
Oversized Payload frame
If the transaction includes a Payload Frame, the Length Byte cannot be a value greater
than 133. If the SN260 detects a length byte greater than 133, it will drop the incoming
Command and abort the entire transaction. The SN260 will then assert nHOST_INT
after Slave Select returns to Idle to inform the Host through an error code in the
Response section what has happened. Not only is the Command in the problematic
transaction dropped by the SN260, but the next Command is also dropped, because it
is responded to with the Oversized Payload Frame Error Response.
●
Aborted transaction
An aborted transaction is any transaction where Slave Select returns to Idle
prematurely and the SPI Protocol dropped the transaction. The most common reason
for Slave Select returning to Idle prematurely is the Host unexpectedly resetting. If a
transaction is aborted, the SN260 will assert nHOST_INT to inform the Host through an
error code in the Response section what has happened. When a transaction is
aborted, not only does the Command in the problematic transaction get dropped by the
SN260, but the next Command also gets dropped since it is responded to with the
Aborted Transaction Error Response.
●
Missing frame terminator
Every Command and Response must be terminated with the Frame Terminator byte.
The SN260 will drop any Command that is missing the Frame Terminator. The SN260
will then immediately provide the Missing Frame Terminator Error Response.
●
Long transaction
A Long Transaction error occurs when the Host clocks too many bytes. As long as the
inter-command spacing requirement is met, this error condition should not cause a
problem, since the SN260 will send only 0xFF outside of the Response section as well
as ignore incoming bytes outside of the Command section.
●
Unresponsive
Unresponsive can mean the SN260 is not powered, not fully booted yet, incorrectly
connected to the Host, or busy performing other tasks. The Host must wait the
maximum length of the Wait section before it can consider the SN260 unresponsive to
the Command section. This maximum length is 200 milliseconds, measured from the
end of the last byte sent in the Command Section. If the SN260 ever fails to respond
during the Wait section, it is valid for the Host to consider the SN260 unresponsive and
to reset the SN260. Additionally, if nHOST_INT does not assert within 10ms of nWAKE
asserting during the wake handshake, the Host can consider the SN260 unresponsive
and reset the SN260.
相關PDF資料 |
PDF描述 |
|---|---|
| SN54128J | TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDIP14 |
| SNJ54128W | TTL/H/L SERIES, QUAD 2-INPUT NOR GATE, CDFP14 |
| SN54132J | TTL/H/L SERIES, QUAD 2-INPUT NAND GATE, CDIP14 |
| SN74S132N3 | S SERIES, QUAD 2-INPUT NAND GATE, PDIP14 |
| SN54175W | TTL/H/L SERIES, POSITIVE EDGE TRIGGERED D FLIP-FLOP, COMPLEMENTARY OUTPUT, CDFP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SN260QT | 功能描述:射頻收發器 ZIGBEE 802.15.4 NETWORK PROCESSOR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| SN2634 | 制造商:Omron Corporation 功能描述:RELAY ASSEMBLY |
| SN26500PWR | 制造商:Texas Instruments 功能描述: |
| SN27210DRKR | 制造商:Texas Instruments 功能描述:Custom firmware of BQ27210 |
| SN27322 | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。