- 您現在的位置：買賣IC網 > PDF目錄368135 > PSD211R Field Programmable Microcontroller Peripherals(可編程邏輯,可加密,19個可單獨配置I/O,通用PLD有12個輸入) PDF資料下載
參數資料
| 型號： | PSD211R |
| 英文描述： | Field Programmable Microcontroller Peripherals(可編程邏輯,可加密,19個可單獨配置I/O,通用PLD有12個輸入) |
| 中文描述： | 現場可編程微控制器外圍設備（可編程邏輯，可加密，19個可單獨配置的I / O，通用PLD的有12個輸入） |
| 文件頁數： | 7/32頁 |
| 文件大?。?/td> | 175K |
| 代理商： | PSD211R |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Multiplexed Address/Data
8-bit Data Bus
Port A
I/O or low-order address lines
Port B
I/O and/or CS0–CS7
AD0/A0–AD7/A7
Low-order multiplexed address/data byte
A8–A15
High-order address bus byte
PSD211R
2-7
The PSD211R operates in 8-bit address/data mode, enabling it to interface directly to
8- and 16-bit microcontrollers.
Multiplexed 8-bit Address/Data Bus
The address/data bus (AD0/A0–AD7/A7) is bi-directional and permits the latching of the
address when the ALE signal is active. On the same pins, the data is read from or written to
the device; this depends on the state of the RD/E pin or PSEN pin and WR/V
PP
or R/W
pins. The high-order address bus (A8–A15) contains the high-order address bus byte. Ports
A and B can be configured as in Table 2.
A8–A15
AD0–AD7
ALE
PSEN
R/W or WR/V
PP
RD/E
A19/CSI
RESET
I/O or CS0–CS7
A16–A18 or
CS8–CS10
PA
PB
PC
I/O or A0–A7
Legend:
AD0–AD7 = Addresses A0–A7 multiplexed with data lines D0–D7.
Figure 2. Port Configurations
Operating Mode
Table 2. Bus and Port Configuration Options
Programmable
Address
Decoder (PAD)
The PSD211R consists of two programmable arrays referred to as PAD A and PAD B
(Figure 3). PAD A is used to generate chip select signals derived from the input address to
the internal EPROM blocks and I/O ports. All its I/O functions are listed in Table 3 and
shown in Figure 3. PAD B outputs to Ports B and C for off-chip usage.
PAD B can also be used to extend the decoding to select external devices or as a random
logic replacement. The input bus to both PAD A and PAD B is the same. By using the
PSDsoft Development Tools software, each programmable bit in the PAD array can have
one of three logic states of 0, 1, and don’t care (X). In a user’s logic design, both PADs can
share the same inputs, using the X for input signals that are not supposed to affect other
functions. The PADs use reprogrammable CMOS EPROM technology and can be
programmed and erased (if using windowed packages) by the user.
相關PDF資料 |
PDF描述 |
|---|---|
| PSD301-20QI | Field-Programmable Peripheral |
| PSD301-20U | 40V 1 Form A Photo Voltaic Relay in a 4-Lead SOP Package; A PVY116 with Standard Packaging |
| PSD301-20UI | Field-Programmable Peripheral |
| PSD301-20XI | Field-Programmable Peripheral |
| PSD301-20XM | 400V 1 Form A Photo Voltaic Relay in a 6-pin SMT Package; A PVT412AS with Tape and Reel Packaging |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSD211R-B-15J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD211R-B-15L | 制造商:WSI 功能描述: |
| PSD211R-B-15M | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD211R-B-70J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD211RB-70J | 功能描述:SPLD - 簡單可編程邏輯器件 U 511-ZPSD301B-70J RoHS:否 制造商:Texas Instruments 邏輯系列:TICPAL22V10Z 大電池數量:10 最大工作頻率:66 MHz 延遲時間:25 ns 工作電源電壓:4.75 V to 5.25 V 電源電流:100 uA 最大工作溫度:+ 75 C 最小工作溫度:0 C 安裝風格:Through Hole 封裝 / 箱體:DIP-24 |
發布緊急采購，3分鐘左右您將得到回復。