- 您現在的位置：買賣IC網 > PDF目錄382380 > PCD5013H (NXP SEMICONDUCTORS) FLEX roaming decoder II PDF資料下載
參數資料
| 型號： | PCD5013H |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 尋呼電路 |
| 英文描述： | FLEX roaming decoder II |
| 中文描述： | TELECOM, PAGING DECODER, PQFP32 |
| 封裝： | 7 X 7 MM, 1.40 MM HEIGHT, PLASTIC, SOT-358-1, LQFP-32 |
| 文件頁數： | 17/76頁 |
| 文件大小： | 270K |
| 代理商： | PCD5013H |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
1999 Apr 12
17
Philips Semiconductors
Product specification
FLEX
roaming decoder II
PCD5013
8.4.3
C
ONFIGURATION SEQUENCE
A typical configuration and synchronisation sequence
would be as follows, see Fig.11 for event timings:
1.
The PCD5013 is reset by the host.
2.
After 76800 clock cycles the PCD5013 interrupts the
host to read the part ID by pulling the READY
line LOW.
3.
The host pulls SS LOW at the start of each
SPI transfer and clocks out the part ID data.
4.
The host configures the following aspects of PCD5013
operation:
a) General configuration (Section 8.4.4)
b) Receiver operation (Section 8.5)
c) FLEX
CAPCODE configuration (Section 8.6).
The PCD5013 writes a part ID packet in response to
each incoming packet.
5.
At the end of each packet the PCD5013 pulls the
READY line HIGH, and then LOW again to indicate
that packet processing is complete.
The host writes a control packet to enable FLEX
decoding in the PCD5013 (Section 8.4.7).
The host writes a checksum packet to enable SPI data
output by the PCD5013 (Section 8.4.2).
On recognising a SYNC word, the PCD5013
synchronises to the channel.
The PCD5013 initiates an SPI transfer writing the
status packet, indicating that it is now in synchronous
mode.
6.
7.
8.
9.
Fig.11 Typical configuration and synchronization sequence.
handbook, full pagewidth
MBK097
SPI
DECODER-TO-HOST
RESET
READY
SS
FLEX DATASTREAM
SPI
HOST-TO-DECODER
checksum packet
(7)
control packet
(6)
partid packet
(4)
configuration packets
(addresses, receiver etc.)
status packet
(9)
partid packet
(4)
(1)
(2)
(3)
(5)
(5)
(5)
(8)
SYNC
Numbers within parenthesis refer to sequence numbers, see Section 8.4.3.
相關PDF資料 |
PDF描述 |
|---|---|
| PCD5032 | ADPCM CODEC for digital cordless telephones |
| PCD5032H | ADPCM CODEC for digital cordless telephones |
| PCD5032T | ADPCM CODEC for digital cordless telephones |
| PCD5041 | DECT burst mode controller |
| PCD5041H | DECT burst mode controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCD5032 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ADPCM CODEC for digital cordless telephones |
| PCD5032B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Linear CODEC |
| PCD5032D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Linear CODEC |
| PCD5032H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ADPCM CODEC for digital cordless telephones |
| PCD5032T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ADPCM CODEC for digital cordless telephones |
發布緊急采購，3分鐘左右您將得到回復。