參數資料
型號： OX16PCI954
廠商： Electronic Theatre Controls, Inc.
英文描述： Integrated Quad UART and PCI interface
中文描述： 綜合四UART和PCI接口
文件頁數： 30/72頁
文件大小： 656K
代理商： OX16PCI954
In enhanced (650) mode the device has the following
features available over those provided by a generic 550.
(Note: some of these are simlar to those provided in 750
mode, but enabled using different registers).
Deeper FIFOs
Sleep mode
Automatic in-band flow control
Special character detection
Infra-red “IrDA-format” transmt and receive mode
Transmt trigger levels
Optional clock prescaler
Data Sheet Revision 1.3
Page 30
OX16PCI954
OXFORD SEMICONDUCTOR LTD.
7.1.6
The additional features offered in 950 mode generally only
apply when the UART is in Enhanced mode (EFR[4]=’1’).
Provided FCR[0] is set, in Enhanced mode the FIFO size is
128 regardless of the state of FIFOSEL.
Note that 950 mode configuration is identical to that of 650
mode, however additional 950 specific features are
enabled using the Additional Control Register ‘ACR’ (see
section 7.11.3). In addition to larger FIFOs and higher baud
rates, the enhancements of the 950 mode over 650
emulation mode are:
Selectable arbitrary trigger levels for the receiver and
transmtter FIFO interrupts
Improved automatic flow control using selectable
arbitrary thresholds
DSR#/DTR#automatic flow control
Transmtter and receiver can be optionally disabled
Software reset of device
Readable FIFO fill levels
Optional generation of an RS-485 buffer enable signal
Four-byte device identification (0x16C95001)
Readable status for automatic in-band and out-of-
band flow control
External 1x clock modes (see section 7.10.4)
Flexible “M+N/8” clock prescaler (see section 7.10.2)
Programmable sample clock to allow data rates up to
15 Mbps (see section 7.10.3).
9-bit data mode
Readable FCR register
950 Mode
The 950 trigger levels are enabled when ACR[5] is set
where bits 4 to 7 of FCR are ignored. Then arbitrary trigger
levels can be defined in RTL, TTL, FCL and FCH registers
(see section 7.11). The Additional Status Register (‘ASR’)
offers flow control status for the local and remote
transmtters. FIFO levels are readable using RFL and TFL
registers.
The UART has a flexible prescaler capable of dividing the
systemclock by any value between 1 and 31.875 in steps
of 0.125. It divides the systemclock by an arbitrary value in
“M+N/8” format, where Mand N are 5- and 3-bit binary
numbers programmed in CPR[7:3] and CPR[2:0]
respectively. This arrangement offers a great deal of
flexibility when choosing an input clock frequency to
synthesise arbitrary baud rates. The default division value
is 4 to provide backward compatibility with 16C650
devices.
The user may apply an external 1x (or Nx) clock for the
transmtter and receiver to the RI#and DSR#pin
respectively. The transmtter clock may instead be asserted
on the DTR#pin. The external clock options are selected
through the CKS register (offset 0x02 of ICR).
It is also possible to define the over-sampling rate used by
the transmtter and receiver clocks. The 16C450/16C550
and compatible devices employ 16 times over-sampling,
where there are 16 clock cycles per bit. However the 95x
UART channels can employ any over-sampling rate from4
to 16 by programmng the TCR register. This allows the
data rates to be increased to 460.8 Kbps using a
1.8432MHz clock, or 15 Mbps using a 60 MHz clock. The
default value after a reset for this register is 0x00, which
corresponds to a 16 cycle sampling clock. Writing 0x01,
0x02 or 0x03 will also result in a 16 cycle sampling clock.
To programthe value to any value from4 to 15 it is
necessary to write this value into the TCR i.e. to set the
device to a 13 cycle sampling clock it would be necessary
to write 0x0D to TCR. For further information see section
7.10.3
The UARTs also offer 9-bit data frames for multi-drop
industrial applications.
相關PDF資料
PDF描述
OX16PCI954-TQC60-A Integrated Quad UART and PCI interface
OX4240 OCXO
OX1040 OCXO
OX1041 OCXO
OX1042 OCXO
相關代理商/技術參數
參數描述
OX16PCI954_05 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Integrated Quad UART and PCI interface
OX16PCI954-TQA1G 功能描述:外圍驅動器與原件 - PCI PCI bridge to quad serial & para. port RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
OX16PCI954-TQC60-A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Integrated Quad UART and PCI interface
OX16PCI954-TQC60-A1 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Integrated Quad UART and PCI interface
OX16PCI958 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Octal UART with PCI Interface
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*