SUPPLEMENTAL APPLICATION NOTES If “CANH minus CANL" />
參數資料
型號: MC33989DWR2
廠商: Freescale Semiconductor
文件頁數: 47/72頁
文件大小: 0K
描述: IC SYSTEM BASE W/CAN 28-SOIC
標準包裝: 1
控制器類型: 系統基礎芯片
接口: CAN
電源電壓: 5.5 V ~ 18 V
電流 - 電源: 45mA
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 28-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 28-SOIC W
包裝: 剪切帶 (CT)
配用: KIT33989DWEVB-ND - KIT EVAL 33989DW HS SBC
其它名稱: MC33989DWR2CT
Analog Integrated Circuit Device Data
Freescale Semiconductor
51
33989
TYPICAL APPLICATIONS
SUPPLEMENTAL APPLICATION NOTES
If “CANH minus CANL” is above the threshold, the bus is dominant and RX is set low. This is illustrated in Figure 36.
Figure 35. CAN Driver Operation in Normal Mode
TX and RX Pins
The TX pin has an internal pull up to V2. The state of TX depends on the V2 status. RX is a push-pull structure, supplied by
V2. When V2 is set at 5.0 V, and CAN is in normal mode, RX reports the bus status. When V2 is off RX is low.
Normal Mode and Slew Rate Selection
The slew rate selection is done via the SPI. Four slew rates are available. The slew rate affects the recessive to dominant and
dominant to recessive transitions. This affect is also the delay time from the TX pin to the bus, and from the bus to RX. The loop
time is thus affected by the slew rate selection.
The following figure is an illustration of the slew rate on CANH, CANL, TX and RX.
Figure 36. Normal Mode and Slew Rate Selection
Minimum Baud Rate
As TX permanent dominant is detected after TDOUT (min 200 s), a minimum Baud rate is required in order to get good
behavior: once TX permanent dominant is detected the CAN driver is off.
The maximum number of consecutive dominant bits in a frame is 12 (6 bits of active error flag and its echo error flag).
200 s/12 = 16.7 s. The minimum Baud rate is 1/6.7 s = 60 KB.
Termination
The MC33989 supports the two main types of bus termination:
Differential termination resistors between CANH and CANL lines.
Split termination concept, with mid point of the differential termination connected to gnd through a capacitor.
CANH
TX
RX
2.5V
CANH-DOM
CANH-REC
CANL
2.5V
CANL-DOM
CANL-REC
CANH-CANL
CAN signal with slew rate 0 selected
CAN signal with slew rate 3 selected
R=60 ohms, CL = CH = 100pF
相關PDF資料
PDF描述
MC3488ADR2G IC LINE DRIVER DUAL EIA 8-SOIC
MC34940EGR2 IC IMAGING DEVICE ELEC 24-SOICW
MC44BS373CAFCR2 IC MODULATOR AUD/VID U/V 20-QFN
MC44BS374CAEFR2 IC AUDIO/VIDEO MODULATOR 16-SOIC
MC44BS374T1AEFR2 IC AUDIO/VIDEO MODULATOR 16-SOIC
相關代理商/技術參數
參數描述
MC33989PEG 功能描述:CAN 接口集成電路 SBC-HS RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube
MC33989PEGR2 功能描述:CAN 接口集成電路 SBC-HS RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube
MC33990D 功能描述:IC TRANSCEIVER J-1850 BUS 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC(0.295",7.50mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
MC33990DR2 功能描述:IC TRANSCEIVER J-1850 BUS 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC(0.295",7.50mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
MC33991DW 制造商:Freescale Semiconductor 功能描述:Gauge Driver Integrated Circuit