- 您現在的位置：買賣IC網 > PDF目錄45052 > M66291GP UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 PDF資料下載
參數資料
| 型號： | M66291GP |
| 元件分類： | 總線控制器 |
| 英文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 |
| 封裝： | 7 X 7 MM, 0.50 MM PITCH, PLASTIC, LQFP-48 |
| 文件頁數： | 78/126頁 |
| 文件大?。?/td> | 893K |
| 代理商： | M66291GP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁當前第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
M66291GP/HP
Rev 1.01 2004.11.01 page 55 of 122
(2) RWND (Buffer Rewind) Bit (b12)
This bit rewinds (initializes) the buffer pointer.
When set to OUT buffer (EPi_DIR bit = “0”)
When the IVAL bit of the CPU_FIFO Control Register is set to “1”, the buffer reading pointer can be
initialized by writing “1” to this bit. This enables reading of the receive data from the beginning.
When set to IN buffer (EPi_DIR bit = “1”)
When the IVAL bit of the CPU_FIFO Control Register is set to “0”, the buffer writing pointer can be
initialized by writing “1” to this bit. This enables resetting of the transmit data from the beginning.
The operation is equivalent to the case when “1” is set to the BCLR bit if set to IN buffer.
(3) BSWP (Byte Swap Mode) Bit (b7)
This bit sets the endian of the CPU_FIFO Data Register.
When this bit is set to “0”, the CPU_FIFO Data Register gets such as little endian.
When this bit is set to “1”, the CPU_FIFO Data Register gets such as big endian.
b15~b8
b7~b0
Little Endian
odd number address
even number address
Big Endian
even number address
odd number address
Note:
Do not set this bit to “1” when the mode is set to 8-bit (set by the Octl bit or *HWR/*BYTE pin).
(4) Octl (Register 8-Bit Mode) Bit (b6)
This bit sets the access mode of the CPU_FIFO Data Register.
When this bit is set to “0”, the CPU_FIFO Data Register is set to 16-bit mode, and all bits of the CPU_FIFO
Data Register are valid.
When this bit is set to “1”, the CPU_FIFO Data Register is set to 8-bit mode, and the upper-order 8 bits of the
CPU_FIFO Data Register (b15 to b8) are invalid.
When set to OUT buffer (EPi_DIR bit = “0”), change this bit before receiving the data. When set to IN buffer
(EPi_DIR bit = “1”), if the Creq bit is equal to “1”, do not change this bit.
This bit becomes invalid (fixed to 8-bit mode) when the mode is set to 8-bit by *HWR/*BYTE pin.
In such case, this bit is read “0”.
Note:
The access width of the CPU_FIFO Data Register is controlled by the logical sum of this bit and the EPi_Octl
bits of the EPi Configuration Register 1 specified by the CPU_EP bits. Hence, the mode is set to 8-bit if “1” is
set to either this bit or to the EPi_Octl bits of the EPi Configuration Register 1. Make sure that both bits must be
set to “0” to change to 16-bit mode.
(5) CPU_EP (CPU Access Endpoint Designate) Bits (b3~b0)
These bits select the endpoint accessed by CPU.
Make sure that the endpoint selection does not get overlapped with the selection by the DMA_EP bits.
When making a change in these bits to select the other the endpoint, make sure that the source endpoint and
the destination endpoint to be changed are not under the access by the CPU or during receiving/transmitting
of SIE (under access to FIFO buffer).
相關PDF資料 |
PDF描述 |
|---|---|
| M66291GP | UNIVERSAL SERIAL BUS CONTROLLER, PQFP48 |
| M66596FP | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| M66596WG | UNIVERSAL SERIAL BUS CONTROLLER, PBGA64 |
| M6XXLFXI | OTHER CLOCK GENERATOR, QCC16 |
| M300LFXIT | 50 MHz, OTHER CLOCK GENERATOR, QCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M66291GP#201 | 制造商:Renesas Electronics Corporation 功能描述:IC ASSP USB2.0 DEVICE CONTROLLER 48LQFP |
| M66291GP#RB0S | 功能描述:IC USB CONTROLLER GEN-PUR 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| M66291GPRB0S | 制造商:Renesas Electronics Corporation 功能描述:USB2.0 Device Controller,LQFP48 |
| M66291HP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:ASSP (USB2.0 Device Controller) |
| M66291HP#200D | 功能描述:IC USB CONTROLLER GEN-PUR 52VQFN RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
發布緊急采購，3分鐘左右您將得到回復。