- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3554EPD#TRPB (LINEAR TECHNOLOGY CORP) 0.5 A BATTERY CHARGE CONTROLLER, 1295 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC3554EPD#TRPB |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.5 A BATTERY CHARGE CONTROLLER, 1295 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 3 X 3 MM, 0.55 MM HEIGHT, LEAD FREE, PLASTIC, UTQFN-20 |
| 文件頁數： | 7/36頁 |
| 文件大?。?/td> | 418K |
| 代理商： | LTC3554EPD#TRPB |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3554
15
3554p
Ideal Diode From BAT to VOUT
The LTC3554 has an internal ideal diode from BAT to VOUT
designed to respond quickly whenever VOUT drops below
BAT. If the load increases beyond the input current limit,
additional current will be pulled from the battery via the ideal
diode. Furthermore, if power to VBUS (USB) is removed,
then all of the application power will be provided by the
battery via the ideal diode. The ideal diode is fast enough
to keep VOUT from dropping signicantly with just the
recommended output capacitor. The ideal diode consists
of a precision amplier that enables an on-chip P-channel
MOSFET whenever the voltage at VOUT is approximately
15mV (VFWD) below the voltage at BAT. The resistance of
the internal ideal diode is approximately 240mΩ.
Suspend Mode
When the SUSP pin is pulled high the LTC3554 enters
suspend mode to comply with the USB specication. In
this mode, the power path between VBUS and VOUT is put
in a high impedance state to reduce the VBUS input current
to 15μA. The system load connected to VOUT is supplied
through the ideal diode connected to BAT.
VBUS Undervoltage Lockout (UVLO) and Undervoltage
Current Limit (UVCL)
An internal undervoltage lockout circuit monitors VBUS
and keeps the input current limit circuitry off until VBUS
rises above the rising UVLO threshold (3.8V) and at least
200mV above VBAT. Hysteresis on the UVLO turns off the
input current limit circuitry if VBUS drops below 3.6V or
within 50mV of VBAT. When this happens, system power at
VOUT will be drawn from the battery via the ideal diode. To
minimize the possibility of oscillation in and out of UVLO
when using resistive input supplies, the input current limit
is reduced as VBUS falls below 4.45V typical.
Battery Charger
The LTC3554 includes a constant-current/constant-volt-
age battery charger with automatic recharge, automatic
termination by safety timer, low voltage trickle charging,
bad cell detection and thermistor sensor input for out of
temperature charge pausing. When a battery charge cycle
begins, the battery charger rst determines if the battery
is deeply discharged. If the battery voltage is below VTRKL,
typically 2.9V, an automatic trickle charge feature sets the
battery charge current to 10% of the programmed value. If
the low voltage persists for more than 1/2 hour, the battery
charger automatically terminates. Once the battery voltage
is above 2.9V, the battery charger begins charging in full
power constant current mode. The current delivered to
the battery will try to reach 750V/RPROG. Depending on
available input power and external load conditions, the
battery charger may or may not be able to charge at the
full programmed current. The external load will always be
prioritized over the battery charge current. The USB cur-
rent limit programming will always be observed and only
additional current will be available to charge the battery.
When system loads are light, battery charge current will
be maximized.
Charge Termination
The battery charger has a built-in safety timer. When the
battery voltage approaches the oat voltage, the charge
current begins to decrease as the LTC3554 enters con-
stant-voltage mode. Once the battery charger detects that
it has entered constant-voltage mode, the four hour safety
timer is started. After the safety timer expires, charging
of the battery will terminate and no more current will be
delivered to the battery.
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3560IS6#TRPBF | 2.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3563EDC | 1.75 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3568EDD#TR | 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3568IDD | 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3568IDD#TR | 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3554EPDTRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Micropower USB Power Manager with Li-Ion Charger and Two Step-Down Regulators |
| LTC3554EUD#PBF | 功能描述:IC USB POWER MANAGER 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.173"，4.40mm 寬）裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF) |
| LTC3554EUD#TRPBF | 功能描述:IC USB POWER MANAGER 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3554EUD-1#PBF | 功能描述:IC USB POWER MANAGER 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3554EUD-1#TRPBF | 功能描述:IC USB POWER MANAGER 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
發布緊急采購，3分鐘左右您將得到回復。