參數資料
型號: LTC3554EPD#TRPB
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 0.5 A BATTERY CHARGE CONTROLLER, 1295 kHz SWITCHING FREQ-MAX, PQCC20
封裝: 3 X 3 MM, 0.55 MM HEIGHT, LEAD FREE, PLASTIC, UTQFN-20
文件頁數: 15/36頁
文件大?。?/td> 418K
代理商: LTC3554EPD#TRPB
LTC3554
22
3554p
Since the power transfer from BVIN to SW is through a
high impedance current source rather than through a low
impedance MOSFET switch, power loss scales with load
current as in a linear low dropout (LDO) regulator, rather
than as in a switching regulator. For near-zero load condi-
tions where regulator quiescent current is the dominant
power loss, standby mode is ideal. But at any appreciable
load current, Burst Mode operation yields the best overall
conversion efciency.
Shutdown
Each step-down switching regulator is shut down and
enabled via the Pushbutton Interface section. In shutdown,
each switching regulator draws only a few nanoamps of
leakage current from the BVIN pin. Each disabled regulator
also pulls down on its output with a 10k resistor from its
switch pin to ground.
Dropout Operation
It is possible for a step-down switching regulator’s input
voltage to fall near or below its programmed output volt-
age (e.g., a battery voltage of 3.4V with a programmed
output voltage of 3.3V). When this happens, the PMOS
switch duty cycle increases to 100%, keeping the switch on
continuously. Known as dropout operation, the respective
output voltage equals the regulator’s input voltage minus
the voltage drops across the internal P-channel MOSFET
and the inductor.
OPERATION
Soft-Start Operation
In normal operating mode, soft-start works by gradually
increasing the peak inductor current for each step-down
switching regulator over a 500μs period. This allows each
output to rise slowly, helping minimize the inrush current
needed to charge up the output capacitor. A soft-start cycle
occurs whenever a given switching regulator is enabled.
Soft-start occurs only in normal operation, but not in
standby mode. Standby mode operation is already in-
herently current-limited, since the regulator works by
intermittently turning on a current source from BVIN to
SW. Changing the state of the STBY pin while the regu-
lators are operating doesn’t trigger a new soft-start cycle,
to avoid glitching the outputs.
Frequency/Slew Rate Select
The FSEL pin allows an application to dynamically trade
off between highest efciency and reduced electromag-
netic interference (EMI) emission.
When FSEL is high, the switching regulator frequency is
set to 2.25MHz to stay out of the AM radio band. Also,
new patent pending circuitry is enabled which limits the
slew rate of the switch nodes (SW1 and SW2). This new
circuitry is designed to transition the switch node over a
period of a few nanoseconds, signicantly reducing radi-
ated EMI and conducted supply noise.
相關PDF資料
PDF描述
LTC3560IS6#TRPBF 2.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6
LTC3563EDC 1.75 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6
LTC3568EDD#TR 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
LTC3568IDD 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
LTC3568IDD#TR 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
LTC3554EPDTRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Micropower USB Power Manager with Li-Ion Charger and Two Step-Down Regulators
LTC3554EUD#PBF 功能描述:IC USB POWER MANAGER 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.173",4.40mm 寬)裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF)
LTC3554EUD#TRPBF 功能描述:IC USB POWER MANAGER 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP(4x4) 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR
LTC3554EUD-1#PBF 功能描述:IC USB POWER MANAGER 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP(4x4) 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR
LTC3554EUD-1#TRPBF 功能描述:IC USB POWER MANAGER 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP(4x4) 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR