- 您現在的位置：買賣IC網 > PDF目錄43901 > L99PM62XP (STMICROELECTRONICS) 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 PDF資料下載
參數資料
| 型號： | L99PM62XP |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 電源管理 |
| 英文描述： | 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| 封裝： | ROHS COMPLIANT, POWERSSO-36 |
| 文件頁數： | 21/98頁 |
| 文件大小： | 1117K |
| 代理商： | L99PM62XP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁
Description
L99PM62XP
Doc ID 16363 Rev 2
2.8.1
Error handling
The L99PM62XP provides the following 3 error handling features which are not described in
the LIN Spec. V2.1, but are realized in different stand alone LIN transceivers / micro
controllers to switch the application back to normal operation mode.
Dominant TxDL time out
If TXDL is in dominant state (low) for more than 12 ms (typ) the transmitter is disabled, the
status bit is latched and can be read and optionally cleared by SPI. The transmitter remains
disabled until the status register is cleared. This feature can be disabled via SPI.
Permanent recessive
If TXDL changes to dominant (low) state but RXDL signal does not follow within 40 s the
transmitter is disabled, the status bit is latched and can be read and optionally cleared by
SPI. The transmitter remains disabled until the status register is cleared.
Permanent dominant
If the bus state is dominant (low) for more than 12 ms a permanent dominant status is
detected. The status bit is latched and can be read and optionally cleared by SPI. The
transmitter is not disabled.
2.8.2
Wake up (from LIN)
In standby mode the L99PM62XP can receive a wake up from LIN bus. For the wake up
feature the L99PM62XP logic differentiates two different conditions.
Normal wake up
Normal wake up can occur when the LIN transceiver was set in standby mode while LIN was
in recessive (high) state. A dominant level at LIN for tlinbus, switches the L99PM62XP to
active mode.
Wake up from short to GND condition
If the LIN transceiver was set in standby mode while LIN was in dominant (low) state,
recessive level at LIN for tlinbus, switches the L99PM62XP to active mode.
Note:
A wake up caused by a message on the bus starts the voltage regulator and the
microcontroller to switch the application back to normal operation mode.
2.8.3
LIN pull-up
The master node pull-up resistor (1 k
Ω) can be connected to Vs using the internal LIN_PU
high-side switch. This high-side switch can be controlled by SPI in order to allow
disconnection of the pull-up resistor in case of LIN bus short to GND conditions.
相關PDF資料 |
PDF描述 |
|---|---|
| LA5635H | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| LA5693D | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDIP8 |
| LA5693M | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
| LA8638NV | COMPANDER, PDSO30 |
| LA8638V | COMPANDER, PDSO30 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L99PM62XPTR | 功能描述:馬達/運動/點火控制器和驅動器 SPI CNTROL DIAGNOSIS INTERFACE DEVICE RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L99PM72GXPTR | 功能描述:Automotive PMIC PowerSSO-36 制造商:stmicroelectronics 系列:- 包裝:剪切帶（CT） 零件狀態:有效 應用:汽車級 電流 - 電源:6mA 電壓 - 電源:6 V ~ 18 V 工作溫度:-40°C ~ 130°C 安裝類型:表面貼裝 封裝/外殼:36-??FSOP（0.295"，7.50mm 寬） 供應商器件封裝:PowerSSO-36 標準包裝:1 |
| L99SD01-E | 制造商:STMicroelectronics 功能描述:ABD VIPOWER - Rail/Tube |
| L99SD01TR-E | 制造商:STMicroelectronics 功能描述:ABD VIPOWER - Tape and Reel |
| L9A0212 | 制造商:LSI 制造商全稱:LSI 功能描述:Microprocessor |
發布緊急采購，3分鐘左右您將得到回復。