參數資料
型號: IT8673F
廠商: Electronic Theatre Controls, Inc.
英文描述: GT 35C 35#12 SKT PLUG
中文描述: 先進的輸入/輸出(高級I / O)的初步規范V0.5
文件頁數: 100/128頁
文件大?。?/td> 780K
代理商: IT8673F
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁當前第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
IT8673F
(3) ECP Pin Descriptions
0
Table 11-42. ECP Pin Descriptions
Name
Type
Description
nStrobe (HostClk)
O
Used for handshaking with Busy to write data and addresses into the peripheral
device.
PD0-PD7
I/O
Address or data or RLE data.
nAck (PeriphClk)
I
Used for handshaking with nAutoFd to transfer data from the peripheral device to
the Host.
Busy (PeriphACK)
I
The peripheral uses this signal for flow control in the forward direction
(hand-shaking with nStrobe). In the reverse direction, this signal is used to
determine whether a command or data information is present on PD0-PD7.
PError
(nAckReverse)
I
Used to acknowledge nInit from the peripheral which drives this signal low, allowing
the host to drive the PD bus.
Select
I
Printer On-Line indication.
nAutoFd (HostAck)
O
In the reverse direction, it is used for handshaking between the nAck and the Host.
When it is asserted, a peripheral data byte is requested. In the forward direction,
this signal is used to determine whether a command or data information is present
on PD0-PD7.
nFault
(nPeriphRequest)
I
In the forward direction (only), the peripheral is allowed (but not required) to assert
this signal (low) to request a reverse transfer while in ECP mode. The signal
provides a mechanism for peer-to-peer communication. It is typically used to
generate an interrupt to the host, which has the ultimate control over the transfer
direction.
nInit
(nReverseRequest)
O
The host may drive this signal low to place the PD bus in the reverse direction. In
the ECP mode, the peripheral is permitted to drive the PD bus when nInit is low and
nSelectIn is high.
nSelectIn (1284
Active)
O
Always inactive (high) in the ECP mode.
(4) Data Port (Primary Base+0h, Modes 000 and 001)
Its contents will be cleared by a RESET. In a write operation, the contents of the data bus are latched by
Data Register at the rising edge of the IOW# input. The contents are then sent without being inverted to
PD0-PD7. The contents of data ports are read and sent to the host in a read operation.
(5) ecpAFifo PORT (Address/RLE) (Primary Base+0h, Mode 011)
Any data byte written to this port are placed in the FIFO and tagged as an ECP Address/RLE. The hardware
then sends this data automatically to the peripheral. The operation of this port is only valid in forward
direction (dcr(5)=0).
相關PDF資料
PDF描述
IT8687R GT 35C 35#12 SKT PLUG
ITC1000 GT 85C 85#16 SKT PLUG
ITF86130SK8T N-Channel, Logic Level, Power MOSFET(N溝道邏輯電平功率MOS場效應管)
ITF86182SK8T 11A, 30V, 0.0115 Ohm, P-Channel, Logic Level, Power MOSFET
ITF87012SVT 6A, 20V, 0.035 Ohm, N-Channel,2.5V Specified Power MOSFET(6A, 20V, 0.035Ω N溝道2.5V專用功率MOS場效應管)
相關代理商/技術參數
參數描述
IT8687R 制造商:ITE 功能描述:
IT86B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86C 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86F 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220