- 您現在的位置：買賣IC網 > PDF目錄385396 > HSP50415VI (INTERSIL CORP) CABLE ASSEMBLY; 75 OHM TNC MALE TO 75 OHM TNC MALE; 75 OHM, RG6A/U COAX PDF資料下載
參數資料
| 型號： | HSP50415VI |
| 廠商： | INTERSIL CORP |
| 元件分類： | 通信及網絡 |
| 英文描述： | CABLE ASSEMBLY; 75 OHM TNC MALE TO 75 OHM TNC MALE; 75 OHM, RG6A/U COAX |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP100 |
| 封裝： | 14 X 20 MM, PLASTIC, MQFP-100 |
| 文件頁數： | 11/29頁 |
| 文件大小： | 229K |
| 代理商： | HSP50415VI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
4-11
resulting 23-bit output rounded at bit position 5 (multOut<5>)
to 17-bits. The extra bit is carried to check for overflow at the
output of the shifter. The output of the multiplier
(multOut<22:6>) is then shifted to the appropriate position
per the exponent bits with a shift value of 0xB positioning the
data at the top of the shifter. The final shifted output is then
checked for saturation and limited to 16-bits before being
output.
Fixed Coefficient 19-TAP Interpolating
Halfband
Following the post-FIR gain stage is a pair of fixed coefficient
19-tap interpolate by 2 halfband filters. The halfband filter
may be totally bypassed if not required. If bypassed, the data
to the filter is zeroed which reduces power consumption. The
halfband filter coefficients are:
1, 0, -17, 0, 87, 0, -299, 0, 1252, 2048, 1252, 0, -299, 0, 87,
0, -17, 0, 1
The interpolate by 2 is accomplished via zero-stuffing and
low-pass filtering. The output of this filter is rounded to 16-
bits. The output is checked for saturation and limited if
necessary. The data exits the halfband filters as a parallel
I<15:0> and Q<15:0> data stream at the interpolated sample
rate. Figure 8 shows the frequency response of the Half-
Band filter.
Interpolating Filter
Following the halfband stage, the data enters the last stage
of interpolating filters. Again, the I and Q filters are identical
so the subsequent discussion will refer to a single channel.
The data is input to the interpolating filter at this stage’s input
sample rate which is dependent on the previous stage’s
interpolation rate. At this stage the input sample rate clock is
generated by the SYMBOL NCO. For every output sample
generated, there is a 12-bit phase value that is also
generated in the SYMBOL NCO (the top 12-bits of the phase
accumulator). The Interpolator uses this phase value to
compute output samples at the output sample rate (FSOUT)
which is the final output sample rate of the chip. The nulls in
the interpolation filter frequency response align with the
interpolation images of the shaping filter. Input to this stage
should be no greater than -2dB fullscale to prevent overflow.
The impulse response of the Interpolation filter is shown in
Figures 9 through 11 for an interpolate by 16 filter (the
interpolation ratio, L, is equal to 16). This block may be
bypassed if desired. Figures 12 through 17 depict the
response for varying interpolation ratios.
FIGURE 8. HALF-BAND FREQUENCY RESPONSE
100
80
60
40
20
0
-20
-40
-60
-80
M
NORMALIZED FREQUENCY (NYQUIST = 1)
0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1.0
HSP50415
相關PDF資料 |
PDF描述 |
|---|---|
| HSP50415EVAL1 | HSP50415EVAL1 Evaluation Kit |
| HSP9501 | Programmable Data Buffer(可編程數據緩沖器) |
| HSP9520 | Multilevel Pipeline Registers |
| HSP9520CP | Multilevel Pipeline Registers |
| HSP9520CS | Multilevel Pipeline Registers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HSP50415VIZ | 功能描述:調節器/解調器 W/ANL 100MQFP-40+85C PROGRAMABLE MODLTR RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
| HSP50A | 制造商:JLWORLD 制造商全稱:JLWORLD 功能描述:SPEAKER SOUND GENERATORS |
| HSP50B | 制造商:JLWORLD 制造商全稱:JLWORLD 功能描述:SPEAKER SOUND GENERATORS |
| HSP50SA8 | 制造商:RDI 功能描述:SPEAKER 2 ROUND 8 OHMS CLEAR FACE |
| HSP-50SA-8 | 制造商:RDI 功能描述:SPEAKER 2 ROUND 8 OHMS CLEAR FACE |
發布緊急采購，3分鐘左右您將得到回復。