- 您現在的位置：買賣IC網 > PDF目錄381841 > FDC37B78X (STANDARD MICROSYSTEMS CORP) Enhanced Super I/O Controller with ACPI Support, Real Time Clock and Consumer IR PDF資料下載
參數資料
| 型號： | FDC37B78X |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 外設及接口 |
| 英文描述： | Enhanced Super I/O Controller with ACPI Support, Real Time Clock and Consumer IR |
| 中文描述： | MULTIFUNCTION PERIPHERAL, PQFP128 |
| 封裝： | QFP-128 |
| 文件頁數： | 155/258頁 |
| 文件大?。?/td> | 1091K |
| 代理商： | FDC37B78X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁當前第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁
155
ACPI/PME/SMI REGISTERS
Logical Device A in the configuration section
contains the address pointer to the ACPI power
management register block, and PM1_BLK.
These are run-time registers; Included in the
PM1_BLK is an enable bit to allow the SCI
group interrupt to be routed to any serial
interrupt or the IRQ11 pin, or onto the
nPME/SCI pin. Note: See IRQ mux control
register for SCI/PME/SMI selection function and
pin configuration bits.
Register Description
The ACPI register model consists of a number
of fixed register blocks that perform designated
functions. A register block consists of a number
of registers that perform Status, Enable and
Control functions. The ACPI specification deals
with events (which have an associated interrupt
status and enable bits, and sometimes an
associated
control
function)
features. The status registers illustrate what
defined function is requesting ACPI interrupt
services (SCI). Any status bit in the ACPI
specification has the following attributes:
A.
Status bits are only set through some
defined “hardware event.”
B.
Unless otherwise noted, Status bits are
cleared by writing a “HIGH” to that bit
position, and upon VTR POR. Writing
a 0 has no effect.
C.
Status bits only generate interrupts
while their associated bit in the enable
register is set.
D.
Function bit positions in the status
register have the same bit position in
the
enable
exceptions to this rule, special status
bits have no enables).
and
control
register
(there
are
Note that this implies that if the respective
enable bit is reset and the hardware event
occurs, the respective status bit is set, however
no interrupt is generated until the enable bit is
set. This allows software to test the state of the
event (by examining the status bit) without
necessarily generating an interrupt. There are a
special class of status bits that have no
respective enable bit, these are called out
specifically, and the respective enable bit in the
enable register is marked as reserved for these
special cases.
The enable registers allow the setting of the
status bit to generate an interrupt. As a general
rule there is an enable bit in the enable register
for every status bit in the status register. The
control register provides special controls for the
associated event, or special control features that
are not associated with an interrupt event. The
ordering of a register block is the status
registers, followed by enable registers, followed
by control registers.
TABLE 68 and TABLE 69 list the PM1/GPE and
PME/SMI/MSC register blocks and the locations
of the registers contained in these blocks. All of
these registers are powered by VTR and battery
backed-up and are reset on Vbat POR.
Wakeup Event Configuration is Retained by
Battery Power
To preserve the configuration of the wakeup
functions that were programmed prior to the
loss of Vtr upon its return, the soft power
management registers, PME, SCI, SMI registers
and GPIO registers are all powered by the
battery. These registers are reset to their
default values only on Vbat POR. These
registers are described in the sections below.
相關PDF資料 |
PDF描述 |
|---|---|
| FDC37B80X | PC98/99 Compliant Enhanced Super I/O Controller with Keyboard/Mouse Wake-Up |
| FDC37C665IR | 3/5 Volt Advanced High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controller with Infranred Support |
| FDC37C665GT | High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controllers |
| FDC37C666GT | High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controllers |
| FDC37C67X | ENHANCED SUPER I/O CONTROLLER WITH FAST IR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FDC37B78X_07 | 制造商:SMSC 制造商全稱:SMSC 功能描述:Super I/O Controller with ACPI Support, Real Time Clock and Consumer IR |
| FDC37B802 | 制造商:Rochester Electronics LLC 功能描述: |
| FDC37B802QFP | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| FDC37B802QFP WAF | 制造商:SMSC 功能描述: |
| FDC37B807QFP | 制造商:SMSC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。