參數資料
型號： DC798B
廠商： Linear Technology
文件頁數： 26/42頁
文件大?。?/td> 0K
描述： BOARD DELTA SIGMA ADC LTC2480
軟件下載： QuikEval System
設計資源： DC798B Design File
DC798B Schematic
標準包裝： 1
系列： QuikEval™
ADC 的數量： 1
位數： 16
采樣率（每秒）： 7.5
數據接口： MICROWIRE?，串行，SPI?
已用 IC / 零件： LTC2480
已供物品： 板
相關產品： LTC2480HMS#TRPBF-ND - IC ADC DELTA SIGMA 16BIT 10MSOP
LTC2480HDD#TRPBF-ND - IC ADC DELTA SIGMA 16BIT 10DFN
LTC2480HDD#PBF-ND - IC ADC 16BIT SRL 7.5SPS 10DFN
LTC2480HMS#PBF-ND - IC ADC 16BIT SER/SPI 10MSOP
LTC2480IMS#TRPBF-ND - IC ADC 16BIT 10-MSOP
LTC2480IMS#PBF-ND - IC ADC 16BIT 10-MSOP
LTC2480IDD#TRPBF-ND - IC ADC 16BIT 10-DFN
LTC2480CMS#TRPBF-ND - IC ADC 16BIT 10-MSOP
LTC2480CMS#PBF-ND - IC ADC 16BIT 10-MSOP
LTC2480CDD#TRPBF-ND - IC ADC 16BIT 10-DFN
更多...
LTC2480
2480fd
applicaTions inForMaTion
internal oscillator and 50Hz mode, the extra gain error is
0.061ppm. If an external clock is used, the corresponding
extra gain error is 0.24 10–6 fEOSCppm.
The magnitude of the dynamic reference current depends
uponthesizeoftheverystableinternalsamplingcapacitors
andupontheaccuracyoftheconvertersamplingclock.The
accuracy of the internal clock over the entire temperature
andpowersupplyrangeistypicallybetterthan0.5%.Such
a specification can also be easily achieved by an external
clock. When relatively stable resistors (50ppm/°C) are
used for the external source impedance seen by VREF+
and GND, the expected drift of the dynamic current gain
error will be insignificant (about 1% of its value over the
entire temperature and voltage range). Even for the most
stringent applications a one-time calibration operation
may be sufficient.
In addition to the reference sampling charge, the refer-
ence pins ESD protection diodes have a temperature
dependentleakagecurrent.Thisleakagecurrent,nominally
1nA (±10nA max), results in a small gain error. A 100Ω
source resistance will create a 0.05V typical and 0.5V
maximum full-scale error.
OUTPUT DATA RATE (READINGS/SEC)
–10
OFFSET
ERROR
(ppm
OF
V
REF
)
10
30
50
0
20
40
20
40
60
80
2480 F20
100
10
0
30
50
70
90
VIN(CM) = VREF(CM)
VCC = VREF = 5V
VIN = 0V
FO = EXT CLOCK
TA = 85°C
TA = 25°C
Figure 20. Offset Error vs Output Data
Rate and Temperature
OUTPUT DATA RATE (READINGS/SEC)
0
+FS
ERROR
(ppm
OF
V
REF
)
500
1500
2000
2500
3500
10
50
70
2480 F21
1000
3000
40
90 100
20 30
60
80
VIN(CM) = VREF(CM)
VCC = VREF = 5V
FO = EXT CLOCK
TA = 85°C
TA = 25°C
OUTPUT DATA RATE (READINGS/SEC)
0
–3500
–FS
ERROR
(ppm
OF
V
REF
)
–3000
–2000
–1500
–1000
0
10
50
70
2480 F22
–2500
–500
40
90 100
20 30
60
80
VIN(CM) = VREF(CM)
VCC = VREF = 5V
FO = EXT CLOCK
TA = 85°C
TA = 25°C
Figure 22. –FS Error vs Output Data
Rate and Temperature
Figure 21. +FS Error vs Output Data
Rate and Temperature
Output Data Rate
When using its internal oscillator, the LTC2480 produces
up to 7.5 samples per second (sps) with a notch frequency
of 60Hz, 6.25sps with a notch frequency of 50Hz and
6.82sps with the 50Hz/60Hz rejection mode. The actual
output data rate will depend upon the length of the sleep
and data output phases which are controlled by the user
and which can be made insignificantly short. When oper-
ated with an external conversion clock (fO connected to
an external oscillator), the LTC2480 output data rate can
be increased as desired. The duration of the conversion
phase is 41036/fEOSC. If fEOSC = 307.2kHz, the converter
behaves as if the internal oscillator is used and the notch
is set at 60Hz.
An increase in fEOSC over the nominal 307.2kHz will
translate into a proportional increase in the maximum
output data rate. The increase in output rate is neverthe-
less accompanied by three potential effects, which must
be carefully considered.
First, a change in fEOSC will result in a proportional change
in the internal notch position and in a reduction of the
converter differential mode rejection at the power line fre-
相關PDF資料
PDF描述
EVAL-AD7841EBZ BOARD EVAL FOR AD7841
XRP2525ID-2-F IC PWR SW USB 3.0 SINGLE NSOIC8
EVAL-AD7839EBZ BOARD EVAL FOR AD7839
NRS6010T4R7MMGF INDUCTOR POWER 4.7UH 1.4A SMD
AD7940-DBRD BOARD EVAL FOR AD7940 STAMP SPI
相關代理商/技術參數
參數描述
DC-7G3EWA 制造商:Kingbright Corporation 功能描述:Red/Green 10-seg LED lightbar, DC-7G3EWA
DC7G3HWA 功能描述:LED條和陣列 7GR 3RED BARGRAFT 10 SEGMENT RoHS:否 制造商:Avago Technologies 產品:LED Light Bars 照明顏色:Red 光強度:45 mcd 封裝:Tube
DC-7G3HWA 制造商:Kingbright Corporation 功能描述:
DC7K67J/4LR61 制造商:Duracell 功能描述:
DC8 制造商:Cliff Electronic Components 功能描述:SOCKET PCB DC POWER 1.3MM PK10 制造商:Cliff Electronic Components 功能描述:SOCKET, PCB, DC POWER, 1.3MM, PK10 制造商:Cliff Electronic Components 功能描述:SOCKET, PCB, DC POWER, 1.3MM, PK10, Series:DC, Gender:Receptacle, Voltage Rating
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*