參數資料
型號： DC798B
廠商： Linear Technology
文件頁數： 18/42頁
文件大?。?/td> 0K
描述： BOARD DELTA SIGMA ADC LTC2480
軟件下載： QuikEval System
設計資源： DC798B Design File
DC798B Schematic
標準包裝： 1
系列： QuikEval™
ADC 的數量： 1
位數： 16
采樣率（每秒）： 7.5
數據接口： MICROWIRE?，串行，SPI?
已用 IC / 零件： LTC2480
已供物品： 板
相關產品： LTC2480HMS#TRPBF-ND - IC ADC DELTA SIGMA 16BIT 10MSOP
LTC2480HDD#TRPBF-ND - IC ADC DELTA SIGMA 16BIT 10DFN
LTC2480HDD#PBF-ND - IC ADC 16BIT SRL 7.5SPS 10DFN
LTC2480HMS#PBF-ND - IC ADC 16BIT SER/SPI 10MSOP
LTC2480IMS#TRPBF-ND - IC ADC 16BIT 10-MSOP
LTC2480IMS#PBF-ND - IC ADC 16BIT 10-MSOP
LTC2480IDD#TRPBF-ND - IC ADC 16BIT 10-DFN
LTC2480CMS#TRPBF-ND - IC ADC 16BIT 10-MSOP
LTC2480CMS#PBF-ND - IC ADC 16BIT 10-MSOP
LTC2480CDD#TRPBF-ND - IC ADC 16BIT 10-DFN
更多...
LTC2480
2480fd
CS remains LOW during the data output state. However,
the data output state may be aborted by pulling CS HIGH
anytime between the first and 24th rising edge of SCK (see
Figure 9). On the rising edge of CS, the device aborts the
data output state and immediately initiates a new conver-
sion. If the device has not finished loading the last input
bit SPD of SDI by the time CS is pulled HIGH, the SDI
information is discarded and the previous configuration
is still kept. This is useful for systems not requiring all 24
bits of output data, aborting an invalid conversion cycle,
or synchronizing the start of a conversion. If CS is pulled
HIGH while the converter is driving SCK LOW, the internal
pull-upisnotavailabletorestoreSCKtoalogicHIGHstate.
This will cause the device to exit the internal serial clock
mode on the next falling edge of CS. This can be avoided
by adding an external 10k pull-up resistor to the SCK pin
or by never pulling CS HIGH when SCK is LOW.
Whenever SCK is LOW, the LTC2480’s internal pull-up at
pin SCK is disabled. Normally, SCK is not externally driven
if the device is in the internal SCK timing mode. However,
certainapplicationsmayrequireanexternaldriveronSCK.
If this driver goes Hi-Z after outputting a LOW signal, the
LTC2480’s internal pull-up remains disabled. Hence, SCK
remains LOW. On the next falling edge of CS, the device is
switched to the external SCK timing mode. By adding an
external 10k pull-up resistor to SCK, this pin goes HIGH
once the external driver goes Hi-Z. On the next CS falling
edge, the device will remain in the internal SCK timing
mode.
A similar situation may occur during the sleep state when
CS is pulsed HIGH-LOW-HIGH in order to test the conver-
sion status. If the device is in the sleep state (EOC = 0),
SCK will go LOW. Once CS goes HIGH (within the time
period defined above as tEOCtest), the internal pull-up is
activated. For a heavy capacitive load on the SCK pin, the
internal pull-up may not be adequate to return SCK to a
HIGH level before CS goes low again. This is not a concern
under normal conditions where CS remains LOW after
detecting EOC = 0. This situation is easily overcome by
adding an external 10k pull-up resistor to the SCK pin.
applicaTions inForMaTion
EN
GS2
GS1
GS0
IM
FA
FB
SPD
SDI*
DON’T CARE
SDO
SCK
(INTERNAL)
CS
>tEOCtest
MSB
SIG
BIT 8
TEST EOC
(OPTIONAL)
TEST EOC
BIT 19
BIT 18
BIT 17
BIT 16
BIT 20
BIT 21
BIT 22
EOC
BIT 23
EOC
BIT 0
SLEEP
DATA OUTPUT
Hi-Z
DATA
OUTPUT
CONVERSION
SLEEP
2480 F09
<tEOCtest
TEST EOC
VCC
FO
VREF
IN+
IN–
SCK
SDI
SDO
CS
GND
2
10
INT/EXT CLOCK
3
4
5
9
10k
VCC
7
8
6
1
REFERENCE
VOLTAGE
0.1V TO VCC
ANALOG
INPUT
1F
2.7V TO 5.5V
LTC2480
4-WIRE
SPI INTERFACE
Figure 9. Internal Serial Clock, Reduce Data Output Length
相關PDF資料
PDF描述
EVAL-AD7841EBZ BOARD EVAL FOR AD7841
XRP2525ID-2-F IC PWR SW USB 3.0 SINGLE NSOIC8
EVAL-AD7839EBZ BOARD EVAL FOR AD7839
NRS6010T4R7MMGF INDUCTOR POWER 4.7UH 1.4A SMD
AD7940-DBRD BOARD EVAL FOR AD7940 STAMP SPI
相關代理商/技術參數
參數描述
DC-7G3EWA 制造商:Kingbright Corporation 功能描述:Red/Green 10-seg LED lightbar, DC-7G3EWA
DC7G3HWA 功能描述:LED條和陣列 7GR 3RED BARGRAFT 10 SEGMENT RoHS:否 制造商:Avago Technologies 產品:LED Light Bars 照明顏色:Red 光強度:45 mcd 封裝:Tube
DC-7G3HWA 制造商:Kingbright Corporation 功能描述:
DC7K67J/4LR61 制造商:Duracell 功能描述:
DC8 制造商:Cliff Electronic Components 功能描述:SOCKET PCB DC POWER 1.3MM PK10 制造商:Cliff Electronic Components 功能描述:SOCKET, PCB, DC POWER, 1.3MM, PK10 制造商:Cliff Electronic Components 功能描述:SOCKET, PCB, DC POWER, 1.3MM, PK10, Series:DC, Gender:Receptacle, Voltage Rating
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*