參數資料
型號： ADV7343BSTZ
廠商： Analog Devices Inc
文件頁數： 75/108頁
文件大?。?/td> 0K
描述： IC ENCODER VIDEO W/DAC 64-LQFP
產品變化通告： ADV734x, ADV739x Feature Improvement
標準包裝： 1
類型： 視頻編碼器
應用： DVD，Blu-Ray
電壓 - 電源，模擬： 3.3V
電壓 - 電源，數字： 1.8V
安裝類型： 表面貼裝
封裝/外殼： 64-LQFP
供應商設備封裝： 64-LQFP（10x10）
包裝： 托盤
Data Sheet
ADV7342/ADV7343
Rev. | Page 69 of 108
Table 57. S_VSYNC Output Control1, 2
ED/HD Input
Sync Format
(Subaddress
0x30, Bit 2)
ED/HD VSYNC
Control
(Subaddress
0x34, Bit 2)
ED/HD Sync
Output Enable
(Subaddress
0x02, Bit 7)
SD Sync Output
Enable
(Subaddress 0x02,
Bit 6)
Video Standard
Signal on S_VSYNC Pin
Duration
X
0
X
Tristate
N/A
X
0
1
Interlaced
Pipelined SD VSYNC/field
See the
section
0
1
x
X
Pipelined ED/HD VSYNC
or field signal
As per VSYNC or
field signal timing
1
0
1
X
All HD interlaced
standards
Pipelined field signal
based on AV Code F bit
Field
1
0
1
X
All ED/HD
progressive
standards
Pipelined VSYNC based
on AV Code V bit
Vertical blanking
interval
X
1
X
All ED/HD
standards
except 525p
Pipelined ED/HD VSYNC
based on the
vertical counter
Aligned with
serration lines
X
1
X
525p
Pipelined ED/HD VSYNC
based on the vertical
counter
Vertical blanking
interval
1
In all ED/HD standards where there is a VSYNC output, the start of the VSYNC pulse is aligned with the falling edge of the embedded VSYNC in the output video.
2
X = don’t care.
LOW POWER MODE
Subaddress 0x0D, Bits[2:0]
For power-sensitive applications, the ADV7342/ADV7343
support an Analog Devices proprietary low power mode of
operation on DAC 1, DAC 2, and DAC 3. To use this low power
mode, these DACs must be operating in full-drive mode (RSET1
= 510 , RL = 37.5 ). Low power mode is not available in low-
drive mode (RSET = 4.12 k, RL = 300 ). Low power mode can
be independently enabled or disabled on DAC 1, DAC 2, and
DAC 3 using Subaddress 0x0D, Bits[2:0]. Low power mode is
disabled by default on each DAC.
In low power mode, DAC current consumption is content
dependent. On a typical video stream, it can be reduced by as
much as 40%. For applications requiring the highest possible video
performance, low power mode should be disabled.
CABLE DETECTION
Subaddress 0x10
The ADV7342/ADV7343 include an Analog Devices propri-
etary cable detection feature. The cable detection feature is
available on DAC 1 and DAC 2, while operating in full-drive
mode (RSET1 = 510 , RL1 = 37.5 , assuming a connected
cable). The feature is not available in low-drive mode (RSET1 =
4.12 k, RL = 300 ). For a DAC to be monitored, the DAC
must be powered up in Subaddress 0x00.
The cable detection feature can be used with all SD, ED, and
HD video standards. It is available for all output configurations,
that is, CVBS, YC, YPrPb, and RGB output configurations.
For CVBS/YC output configurations, both DAC 1 and DAC 2
are monitored; that is, the CVBS and YC luma outputs are
monitored. For YPrPb and RGB output configurations, only
DAC 1 is monitored; that is, the luma or green output is
monitored.
Once per frame, the ADV7342/ADV7343 monitor DAC 1
and/or DAC 2, updating Subaddress 0x10, Bit 0 and Bit 1,
respectively. If a cable is detected on one of the DACs, the
relevant bit is set to 0. If not, the bit is set to 1.
DAC AUTOPOWER-DOWN
Subaddress 0x10, Bit 4
For power-sensitive applications, a DAC autopower-down
feature can be enabled using Subaddress 0x10, Bit 4. This feature
is available only when the cable detection feature is enabled.
With this feature enabled, the cable detection circuitry monitors
DAC 1 and/or DAC 2 once per frame. If they are unconnected,
some or all of the DACs automatically power down. Which
DAC or DACs are powered down depends on the selected
output configuration.
For CVBS/YC output configurations, if DAC 1 is unconnected,
only DAC 1 powers down. If DAC 2 is unconnected, DAC 2 and
DAC 3 power down.
For YPrPb and RGB output configurations, if DAC 1 is
unconnected, all three DACs power down. DAC 2 is not
monitored for YPrPb and RGB output configurations.
Once per frame, DAC 1 and/or DAC 2 is monitored. If a cable is
detected, the appropriate DAC or DACs remain powered up for
the duration of the frame. If no cable is detected, the appropriate
DAC or DACs power down until the next frame, when the process
is repeated.
D
相關PDF資料
PDF描述
ADV7391BCPZ IC ENCODER VIDEO W/DAC 32LFCSP
ADV7511KSTZ IC XMITTER HDMI 12BIT 100LQFP
ADV7511WBSWZ IC XMITTER HDMI AUTO 64LQFP
ADV7622BSTZ-RL IC TXRX HDMI 4:1 144LQFP
ADV7623BSTZ IC TXRX HDMI 4:1 144LQFP
相關代理商/技術參數
參數描述
ADV7343WBSTZ 功能描述:IC ENCODER VID 12BIT DAC 64LQFP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:視頻編碼器 應用:DVD，Blu-Ray 電壓 - 電源，模擬:2.6 V ~ 3.46 V 電壓 - 電源，數字:1.71 V ~ 1.89 V 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1
ADV7343WBSTZ-RL 功能描述:Video Encoder IC DVD, Blu-Ray 64-LQFP (10x10) 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 類型:視頻編碼器 應用:DVD，Blu-Ray 電壓 - 電源，模擬:2.6 V ~ 3.46 V 電壓 - 電源，數字:1.71 V ~ 1.89 V 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1,500
ADV7344 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six 14-Bit Noise Shaped Video DACs
ADV7344BSTZ 制造商:Analog Devices 功能描述:
ADV73505501 制造商:LG Corporation 功能描述:Frame Assembly
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*