參數資料
型號: ADF4150HVBCPZ-RL7
廠商: Analog Devices Inc
文件頁數: 9/28頁
文件大小: 0K
描述: IC FRACTION-N FREQ SYNTH 32LFCSP
標準包裝: 1,500
類型: *
PLL:
輸入: CMOS
輸出: 時鐘
電路數: 1
比率 - 輸入:輸出: 1:2
差分 - 輸入:輸出: 無/是
頻率 - 最大: 3GHz
除法器/乘法器: 是/無
電源電壓: 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 32-WFQFN 裸露焊盤,CSP
供應商設備封裝: 32-LFCSP-WQ(5x5)
包裝: 帶卷 (TR)
ADF4150HV
Rev. 0 | Page 17 of 28
REGISTER 0
Control Bits
When Bits[C3:C1] are set to 000, Register 0 is programmed.
Figure 20 shows the input data format for programming this
register.
16-Bit Integer Value (INT)
The 16 INT bits (Bits[DB30:DB15]) set the INT value, which
determines the integer part of the feedback division factor. The
INT value is used in Equation 1 (see the INT, FRAC, MOD, and
R Counter Relationship section). Integer values from 23 to
32,767 are allowed for the 4/5 prescaler; for the 8/9 prescaler,
the minimum integer value is 75 and the maximum value is
65,535.
12-Bit Fractional Value (FRAC)
The 12 FRAC bits (Bits[DB14:DB3]) set the numerator of the
fraction that is input to the Σ-Δ modulator. This fraction, along
with the INT value, specifies the new frequency channel that
the synthesizer locks to, as shown in the RF Synthesizer—A
Worked Example section. FRAC values from 0 to (MOD 1)
cover channels over a frequency range equal to the PFD refer-
ence frequency.
REGISTER 1
Control Bits
When Bits[C3:C1] are set to 001, Register 1 is programmed.
Figure 21 shows the input data format for programming this
register.
Prescaler Value
The dual-modulus prescaler, along with the INT, FRAC, and
MOD values, determines the overall division ratio from the VCO
output to the PFD input. The PR1 bit (DB27) in Register 1 sets
the prescaler value.
Operating at CML levels, the prescaler takes the clock from the
VCO output and divides it down for the counters. The prescaler
is based on a synchronous 4/5 core. When the prescaler is set to
4/5, the maximum RF frequency allowed is 3 GHz. Therefore,
when operating the ADF4150HV above 3 GHz, the prescaler
must be set to 8/9. The prescaler limits the INT value as follows:
Prescaler = 4/5: NMIN = 23
Prescaler = 8/9: NMIN = 75
12-Bit Phase Value
Bits[DB26:DB15] control the phase word. The word must be
less than the MOD value programmed in Register 1. The phase
word is used to program the RF output phase from 0° to 360°
with a resolution of 360°/MOD. For more information, see the
In most applications, the phase relationship between the RF
signal and the reference is not important. In such applications,
the phase value can be used to optimize the fractional and
subfractional spur levels. For more information, see the Spur
If neither the phase resync nor the spurious optimization function
is used, it is recommended that the phase word be set to 1.
12-Bit Modulus Value (MOD)
The 12 MOD bits (Bits[DB14:DB3]) set the fractional modulus.
The fractional modulus is the ratio of the PFD frequency to the
channel step resolution on the RF output. For more information,
REGISTER 2
Control Bits
When Bits[C3:C1] are set to 010, Register 2 is programmed.
Figure 22 shows the input data format for programming this
register.
Low Noise and Low Spur Modes
The noise modes on the ADF4150HV are controlled by setting
Bits[DB30:DB29] in Register 2 (see Figure 22). The noise modes
allow the user to optimize a design either for improved spurious
performance or for improved phase noise performance.
When the low spur mode is chosen, dither is enabled. Dither
randomizes the fractional quantization noise so that it resembles
white noise rather than spurious noise. As a result, the part is
optimized for improved spurious performance. Low spur mode
is normally used for fast-locking applications when the PLL
closed-loop bandwidth is wide. Wide loop bandwidth is a loop
bandwidth greater than 1/10 of the RFOUT channel step resolu-
tion (fRES). A wide loop filter does not attenuate the spurs to the
same level as a narrow loop bandwidth.
For best noise performance, use the low noise mode option.
When the low noise mode is chosen, dither is disabled. This
mode ensures that the charge pump operates in an optimum
region for noise performance. Low noise mode is extremely
useful when a narrow loop filter bandwidth is available. The
synthesizer ensures extremely low noise, and the filter attenu-
ates the spurs.
Figure 8 and Figure 9 show fractional spur levels when using
low spur mode and low noise mode. Figure 12 shows the in-band
phase noise when using low spur mode and low noise mode.
MUXOUT
The on-chip multiplexer is controlled by Bits[DB28:DB26] (see
相關PDF資料
PDF描述
VI-27Y-MY-F1 CONVERTER MOD DC/DC 3.3V 33W
X9315WST1 IC XDCP 32-TAP 10K 3WIRE 8-SOIC
VI-27Y-MX-F4 CONVERTER MOD DC/DC 3.3V 49.5W
VI-242-IV CONVERTER MOD DC/DC 15V 150W
ADF4154BRU-REEL IC FRACTION-N FREQ SYNTH 16TSSOP
相關代理商/技術參數
參數描述
ADF4151 制造商:AD 制造商全稱:Analog Devices 功能描述:Fractional-N/Integer-N PLL Synthesizer
ADF4151BCPZ 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML,PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤,16-MLF? 供應商設備封裝:16-MLF?(3x3) 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4151BCPZ-RL7 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML,PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤,16-MLF? 供應商設備封裝:16-MLF?(3x3) 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4152HVBCPZ 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤,CSP 供應商器件封裝:32-LFCSP-VQ(5x5) 標準包裝:1
ADF4152HVBCPZ-RL7 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP 制造商:analog devices inc. 系列:- 包裝:剪切帶(CT) 零件狀態:在售 類型:* PLL:是 輸入:CMOS 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:2 差分 - 輸入:輸出:是/無 頻率 - 最大值:5GHz 分頻器/倍頻器:是/是 電壓 - 電源:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-VFQFN 裸露焊盤,CSP 供應商器件封裝:32-LFCSP-VQ(5x5) 標準包裝:1