參數資料
型號: AD7190BRUZ-REEL
廠商: Analog Devices Inc
文件頁數: 27/41頁
文件大?。?/td> 0K
描述: IC ADC 2CH 24BIT W/PGA 24TSSOP
設計資源: Precision Weigh Scale Design Using AD7190 with Internal PGA (CN0102)
標準包裝: 2,500
位數: 24
采樣率(每秒): 4.8k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
電壓電源: 模擬和數字
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 24-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 24-TSSOP
包裝: 帶卷 (TR)
輸入數目和類型: 2 個差分,雙極;4 個偽差分,雙極
AD7190
Data Sheet
Rev. C | Page 32 of 40
Continuous Read
Rather than write to the communications register each time a
conversion is complete to access the data, the AD7190 can be
configured so that the conversions are placed on the DOUT/
RDY line automatically. By writing 01011100 to the commun-
ications register, the user need only apply the appropriate
number of SCLK cycles to the ADC, and the conversion word
is automatically placed on the DOUT/RDY line when a
conversion is complete. The ADC should be configured for
continuous conversion mode.
When DOUT/RDY goes low to indicate the end of a conversion,
sufficient SCLK cycles must be applied to the ADC; the data
conversion is then placed on the DOUT/RDY line. When the
conversion is read, DOUT/RDY returns high until the next
conversion is available. In this mode, the data can be read only
once. Also, the user must ensure that the data-word is read
before the next conversion is complete. If the user has not read
the conversion before the completion of the next conversion,
or if insufficient serial clocks are applied to the AD7190 to
read the word, the serial output register is reset when the next
conversion is complete and the new conversion is placed in
the output serial register.
To exit the continuous read mode, the instruction 01011000
must be written to the communications register while the
RDY pin is low. While in the continuous read mode, the ADC
monitors activity on the DIN line so that it can receive the
instruction to exit the continuous read mode. Additionally, a
reset occurs if 40 consecutive 1s are seen on DIN. Therefore,
DIN should be held low in continuous read mode until an
instruction is to be written to the device.
When several channels are enabled, the ADC continuously
steps through the enabled channels and performs one con-
version on each channel each time that it is selected. DOUT/
RDY pulses low when a conversion is available. When the user
applies sufficient SCLK pulses, the data is automatically placed
on the DOUT/RDY pin. If the DAT_STA bit in the mode
register is set to 1, the contents of the status register are output
along with the conversion. The status register indicates the
channel to which the conversion corresponds.
DIN
SCLK
DOUT/RDY
CS
0x5C
DATA
07640-
023
Figure 31. Continuous Read
相關PDF資料
PDF描述
AD7191BRUZ IC ADC 2CH 24B SD 24TSSOP
AD7192BRUZ IC ADC 24BIT 2CH W/PGA 24-TSSOP
AD7193BCPZ IC ADC 24BIT SPI 4.8KHZ 32LFCSP
AD7194BCPZ IC ADC 24BIT SPI 4.8K 32-LFCSP
AD7195BCPZ-RL7 IC AFE 24BIT 4.8K 32LFSP
相關代理商/技術參數
參數描述
AD7190WBRUZ 功能描述:24 Bit Analog to Digital Converter 2, 4 Input 1 Sigma-Delta 24-TSSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 位數:24 采樣率(每秒):4.8k 輸入數:2,4 輸入類型:差分,個偽差分 數據接口:SPI,DSP 配置:MUX-PGA-ADC 無線電 - S/H:ADC:- A/D 轉換器數:1 架構:三角積分 參考類型:外部, 內部 電壓 - 電源,模擬:5V 電壓 - 電源,數字:2.7 V ~ 5.25 V 特性:PGA,溫度傳感器 工作溫度:-40°C ~ 105°C 封裝/外殼:24-TSSOP(0.173",4.40mm 寬) 供應商器件封裝:24-TSSOP 標準包裝:1
AD7190WBRUZ-RL 制造商:Analog Devices 功能描述:
AD7191 制造商:AD 制造商全稱:Analog Devices 功能描述:Pin-Programmable, Ultralow Noise, 24-Bit, Sigma-Delta ADC for Bridge Sensors
AD7191A/0B 制造商:Sony Nec Optiarc America 功能描述:DOUBLE DUAL INTERNAL DVDRW PATA BEZEL 20X/18X12XRAM - Bulk
AD7191BRUZ 功能描述:IC ADC 2CH 24B SD 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極