- 您現在的位置：買賣IC網 > PDF目錄375230 > AD1843JS (ANALOG DEVICES INC) CAP 3300PF 100V CERAMIC DISC Y5P PDF資料下載
參數資料
| 型號： | AD1843JS |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 消費家電 |
| 英文描述： | CAP 3300PF 100V CERAMIC DISC Y5P |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP80 |
| 封裝： | PLASTIC, QFP-80 |
| 文件頁數： | 10/64頁 |
| 文件大?。?/td> | 848K |
| 代理商： | AD1843JS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
REV. 0
–10–
AD1843
Miscellaneous
Pin Name
PQFP
TQFP
I/O
Description
XTALI
61
76
I
24.576 MHz Crystal Input. When using a crystal as the clock source, the crystal
should be connected between the XTALI and XTALO pins. This crystal should
be 24.576 MHz for the normal sampling rate range, i.e., 4 kHz to 54 kHz. A
clock input (perhaps the CLKOUT of another AD1843) may be driven into
XTALI in place of a crystal. The external clock input must be greater than or equal
to 512 times the maximum desired AD1843 sampling frequency.
24.576 MHz Crystal Output. When using a crystal as the clock source, the crystal
should be connected between the XTALI and XTALO pins. If a clock is driven
directly into XTALI, then XTALO should be left unconnected.
Power Down.
PWRDWN
is active LO. The assertion of this signal will initialize
the on-chip Control Registers to their default values, and will completely and
quietly power down the AD1843. If a crystal is not connected between XTALI
and XTALO, there must be a 24.576 MHz clock input on XTALI for at least
5 ms after this signal is asserted LO for proper operation. The AD1843 will not
be completely powered down until after this 5 ms period elapses. The AD1843
always finishes an in-progress power-up sequence before initiating a power-down
sequence, and vice versa. If the
PWRDWN
pin is asserted while a power-up sequence
is in progress, the 24.576 MHz clock signal on XTALI must persist for a worst
case maximum of 479 ms (power up = 470 ms, autocalibration = 4 ms, power
down = 5 ms) after
PWRDWN
is asserted. When INIT (Control Register
Address 0, Bit 15) is set to a “1,” the power-down sequence is complete. See
the “Power Management” section for important additional details.
Reset.
RESET
is active LO. The assertion of this signal will initialize the on-chip
registers to their default values, and will completely power down the AD1843.
RESET
is similar to
PWRDWN
, except that when
PWRDWN
is asserted, power
down is “quiet” and performed synchronously to the internal clocks. When
RESET
is asserted, power down is “noisy” and performed asynchronously to the internal
clocks.
Power-Down Mono Feedthrough. When the AD1843 mixer is powered down,
and PDMNFT is asserted HI, the Mono Input (MIN, PQFP Pin 19) is routed to
the Mono Output (MOUT, PQFP Pin 35), and the signal applied to MIN will
feedthrough to MOUT. When the AD1843 mixer is powered down and
PDMNFT is deasserted LO, the feedthrough of MIN to MOUT will be muted.
When the AD1843 mixer is not powered down, and MIN to MOUT feedthrough
is desired, the Mono Input Mix Mute (Control Register Address 8, Bit 15) and the
Mono Output Mute (Control Register Address 8, Bit 6) must be unmuted. During
power-down feedthrough, the signal applied to the MIN input appears only at
the MOUT output. During normal operation, the signal applied to the MIN
input appears at both the MOUT and the LOUT1 outputs. The state of the
PDMNFT pin should be changed when the AD1843 mixer is powered up. If the
state of PDMNFT is changed when the AD1843 is in total power-down, audible
pops and clicks will likely result.
Common-Mode Voltage Output. Nominal 2.25 volt reference available externally
for dc-coupling and level-shifting. CMOUT should not be used where it will sink
or source current.
Voltage Reference Filter. Voltage reference filter point for external bypassing only.
Left Channel Filter. This pin requires a 1.0
μ
F capacitor to analog ground for
proper operation.
Right Channel Filter. This pin requires a 1.0
μ
F capacitor to analog ground for
proper operation.
Left Channel Antialias Filter. This pin requires a 1000 pF capacitor to analog
ground for proper operation.
Right Channel Antialias Filter. This pin requires a 1000 pF capacitor to analog
ground for proper operation.
XTALO
62
77
O
PWRDWN
51
64
I
RESET
52
65
I
PDMNFT 49
61
I
CMOUT
38
47
O
V
REF
FILTL
39
25
48
31
I
I
FILTR
23
29
I
AAFILTL 24
30
I
AAFILTR 22
28
I
相關PDF資料 |
PDF描述 |
|---|---|
| AD1843JST | Serial-Port 16-Bit SoundComm Codec |
| AD1846JP | Low Cost Parallel-Port 16-Bit SoundPort Stereo Codec |
| AD1849KP | Serial-Port 16-Bit SoundPort Stereo Codec |
| AD1851 | 16-Bit, 16×Fs PCM Audio DACs(16位,單片PCM音頻D/A轉換器) |
| AD1892JR | Integrated Digital Receiver/Rate Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD1843JST | 制造商:AD 制造商全稱:Analog Devices 功能描述:Serial-Port 16-Bit SoundComm Codec |
| AD1845 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Parallel-Port 16-Bit SoundPort Stereo Codec |
| AD1845JP | 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC 制造商:Rochester Electronics LLC 功能描述:16 BIT AUDIO CODEC - Bulk 制造商:Analog Devices 功能描述:IC CODEC 16-BIT AUDIO |
| AD1845JP-REEL | 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC T/R |
| AD1845JPZ | 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC |
發布緊急采購，3分鐘左右您將得到回復。