參數資料
型號： W29GL064CB7S
廠商： WINBOND ELECTRONICS CORP
元件分類： PROM
英文描述： 64M X 1 FLASH 3V PROM, 70 ns, PDSO48
封裝： 12 X 20 MM, GREEN, TSOP-48
文件頁數： 8/65頁
文件大小： 648K
代理商： W29GL064CB7S
W29GL064C
10
7.2.9.2
Chip Erase
The Chip Erase operation returns all memory locations containing a bit state of “0” to the “1” state,
effectively clearing all data. This action requires six instruction cycles to commence the erase
operation. The unlock sequence is the first two cycles, followed by the configuration cycle, the fourth
and fifth are also ”unlock cycles”, and the sixth cycle initiates the chip erase operation.
Once the chip erase algorithm begins, no other instruction will be accepted. However, if a hardware
reset is executed or the operating voltage is below acceptable levels, the chip erase operation will be
terminated and automatically returns to Read mode.
The embedded chip erase algorithm status can be verified by the following:
Status
DQ7
DQ6
DQ5
DQ2
RY/#BY
1
In progress
0
Toggling
0
Toggling
0
Exceeded time limit
0
Toggling
1
Toggling
0
Table 7-5
Polling During Embedded Chip Erase Operation
Note:
1.
RY/#BY is an open drain pin and should be connected to VCC through a high value pull-up resistor.
7.2.10
Erase Suspend/Resume
If there is a sector erase operation in progress, an Erase Suspend instruction is the only valid
instruction that may be issued. Once the Erase Suspend instruction is executed during the 50s time-
out period following a Sector Erase instruction, the time-out period will terminate right away and the
device will enter Erase-Suspend Read mode. If an Erase Suspend instruction is executed after the
sector erase operation has started, the device will not enter Erase-Suspended Read mode until
approximately 20s (5s typical) time has elapsed. To determine the device has entered the Erase-
Suspend Read mode, use DQ6, DQ7 and RY/#BY status to verify the state of the device.
Once the device has entered Erase-Suspended Read mode, it is possible to read or program any
sector(s) except those being erased by the erase operation. Only the contents of the status register is
present when attempting to read a sector that has been scheduled to erase or be programmed when
in the suspend mode. A resume instruction must be executed and recommend checking DQ6 toggle
bit status, before issuing another erase instruction.
The status register bits can be verified to determine the current status of the device:
Status
DQ7
DQ6
DQ5 DQ3 DQ2 DQ1RY/#BY
Erase suspend read in erase suspended sector
1
No toggle 0
N/A Toggle N/A
1
Erase suspend read in non-erase suspended sector
Data
DataData Data Data
1
Erase suspend program in non-erase suspended sector DQ7# Toggle
0
N/A
0
Table 7-6
Polling During Embedded Erase Suspend
Instruction sets such as read silicon ID, sector protect verify, program, CFI query and erase resume
can also be executed during Erase-Suspend mode, except sector and chip erase.
7.2.11 Sector Erase Resume
Only in the Erase-Suspended Read mode can the Sector Erase Resume instruction be a valid
command. Once erase resumes, another Erase Suspend instruction can be executed, but allow a
400s interval between Erase Resume and the next Erase Suspend instruction.
相關PDF資料
PDF描述
W29GL128CL1B 128M X 1 FLASH 3V PROM, 100 ns, PBGA64
W29N102CP-55B 64K X 16 FLASH 3.3V PROM, 55 ns, PQCC44
W2D15A250A 1 FUNCTIONS, 50 V, FERRITE CHIP
W1D15A270A 1 FUNCTIONS, 50 V, FERRITE CHIP
W2Z1M72SJ38BC 1M X 72 MULTI DEVICE SRAM MODULE, 3.8 ns, PBGA209
相關代理商/技術參數
參數描述
W29GL064CH7B 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE
W29GL064CH7T 制造商:Winbond Electronics Corp 功能描述:IC FLASH 64MBIT 70NS 56TSOP
W29GL064CL7B 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE
W29GL064CL7T 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE
W29GL064CT7A 功能描述:IC FLASH 64MBIT 70NS 48TFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:閃存 存儲器類型:閃存 - NAND 存儲容量:4G（256M x 16） 速度:- 接口:并聯 電源電壓:2.7 V ~ 3.6 V 工作溫度:0°C ~ 70°C 封裝/外殼:48-TFSOP（0.724"，18.40mm 寬） 供應商設備封裝:48-TSOP I 包裝:Digi-Reel® 其它名稱:557-1461-6
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*