參數資料
型號: TSB41BA3-EP
英文描述: IC APEX 20KE FPGA 400K 672-FBGA
中文描述: 軍事增強塑料的IEEE 1394b三端口電纜收發器/仲裁器
文件頁數: 40/50頁
文件大?。?/td> 662K
代理商: TSB41BA3-EP
SLLS418G
JUNE 2000
REVISED JANUARY 2003
40
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
transmit (continued)
00
00
00
00
10
(f)
(g)
(e)
(d)
(c)
(b)
(a)
01
00
00
00
00
00
11
dn
d0, d1, . . .
Link Controls CTL and D
PHY High-Impedance CTL and D Outputs
D0
D7
CTL0, CTL1
SYSCLK
NOTE A: SPD = Speed code (see Table 20), d0
dn = Packet data
00
01
00
SPD
Figure 20. Normal Packet Transmission Timing
The sequence of events for a normal packet transmission is as follows:
1
a.
Transmit operation initiated. The PHY asserts grant on the CTL lines followed by idle to hand over
control of the interface to the link so that the link may transmit a packet. The PHY releases control of
the interface (i.e., it places its CTL and D outputs in a high-impedance state) following the idle cycle.
b.
Optional idle cycle. The link may assert at most one idle cycle preceding assertion of either hold or
transmit. This idle cycle is optional; the link is not required to assert idle preceding either hold or transmit.
c.
Optional hold cycles. The link may assert hold for up to 47 cycles preceding assertion of transmit. These
hold cycle(s) are optional; the link is not required to assert hold preceding transmit.
d.
Transmit data. When data is ready to be transmitted, the link asserts transmit on the CTL lines along
with the data on the D lines.
e.
Transmit operation terminated. The transmit operation is terminated by the link asserting hold or idle
on the CTL lines. The link asserts hold to indicate that the PHY is to retain control of the serial bus in
order to transmit a concatenated packet. The link asserts idle to indicate that packet transmission is
complete and the PHY may release the serial bus. The link then asserts idle for one more cycle following
this cycle of hold or idle before releasing the interface and returning control to the PHY.
f.
Concatenated packet speed-code. If multispeed concatenation is enabled in the PHY, the link asserts
a speed code on the D lines when it asserts hold to terminate packet transmission. This speed code
indicates the transmission speed for the concatenated packet that is to follow. The encoding for this
concatenated packet speed-code is the same as the encoding for the received packet speed code (see
Table 20). The link may not concatenate an S100 packet onto any higher-speed packet.
g.
After regaining control of the interface, the PHY asserts at least one cycle of idle before any subsequent
status transfer, receive operation, or transmit operation.
相關PDF資料
PDF描述
TSB41LV03PFP IC APEX 20KE FPGA 600K 652-BGA
TSB41AB2I IEEE 1394a-2000 TWO-PORT CABLE TRANSCEVER/ARBITER
TSB41LV03AI IEEE 1394a THREE-PORT CABLE TRANSCEIVER/ARBITER
TSC692E 672-pin FineLine BGA
TSC695F IC,FPGA,57120-CELL,CMOS,BGA,1020PIN,PLASTIC
相關代理商/技術參數
參數描述
TSB41BA3IPFP 制造商:Rochester Electronics LLC 功能描述:1394B-2002 3-PORT PHYSICAL LAYER DEVICE - Bulk 制造商:Texas Instruments 功能描述:CBL TRNSCVR 6TR 6TX 6RX 80HTQFP - Trays
TSB41BA3PFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:CBL TRNSCVR 6TR 6TX 6RX 80HTQFP - Trays
TSB41LV01 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE 1394A ONE-PORT CABLE TRANSCEIVER/ARBITER
TSB41LV01PAP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:
TSB41LV02 WAF 制造商:Texas Instruments 功能描述: