- 您現在的位置：買賣IC網 > PDF目錄2118 > TSB41AB3IPFPEP (Texas Instruments)IC 3PRT CABLE TXRX/ARBIT 80HTQFP PDF資料下載
參數資料
| 型號： | TSB41AB3IPFPEP |
| 廠商： | Texas Instruments |
| 文件頁數： | 34/55頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC 3PRT CABLE TXRX/ARBIT 80HTQFP |
| 標準包裝： | 96 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 6/6 |
| 規程： | IEEE 1394 |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 80-TQFP 裸露焊盤 |
| 供應商設備封裝： | 80-HTQFP（12x12） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 882 (CN2011-ZH PDF) |
| 其它名稱： | 296-22528 V62/03612-01XE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
TSB41AB3EP
IEEE 1394a2000 THREEPORT CABLE TRANSCEIVER/ARBITER
SGLS122C JULY 2002 REVISED JUNE 2008
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
description (continued)
The LPS input is considered inactive if it remains low for more than 2.6
s and is considered active otherwise.
When the TSB41AB3 detects that LPS is inactive, it places the PHY-LLC interface into a low-power reset state
in which the CTL and D outputs are held in the logic zero state and the LREQ input is ignored; however, the
SYSCLK output remains active. If the LPS input remains low for more than 26
s, the PHY-LLC interface is put
into a low-power disabled state in which the SYSCLK output is also held inactive. The PHY-LLC interface is also
held in the disabled state during hardware reset. The TSB41AB3 continues the necessary repeater functions
required for normal network operation regardless of the state of the PHYLLC interface. When the interface is
in the reset or disabled state and LPS is again observed active, the PHY initializes the interface and returns it
to normal operation.
When the PHY-LLC interface is in the low-power disabled state, the TSB41AB3 automatically enters a
low-power mode if all ports are inactive (disconnected, disabled, or suspended). In this low-power mode, the
TSB41AB3 disables its internal clock generators and also disables various voltage and current reference
circuits, depending on the state of the ports (some reference circuitry must remain active in order to detect new
cable connections, disconnections, or incoming TPBias, for example). The lowest power consumption (the
ultralow power sleep mode) is attained when all ports are either disconnected, or disabled with the port’s
interrupt enable bit cleared. The TSB41AB3 exits the low-power mode when the LPS input is asserted high or
when a port event occurs which requires that the TSB41AB3 become active in order to respond to the event
or to notify the LLC of the event (incoming bias is detected on a suspended port, a disconnection is detected
on a suspended port, a new connection is detected on a nondisabled port). The SYSCLK output becomes active
(and the PHY-LLC interface is initialized and becomes operative) within 7.3 ms after LPS is asserted high when
the TSB41AB3 is in the low-power mode.
The PHY uses the C/LKON terminal to notify the LLC to power up and become active. When activated, the
C/LKON signal is a square wave of approximately 163-ns period. The PHY activates the C/LKON output when
the LLC is inactive and a wake-up event occurs. The LLC is considered inactive when either the LPS input is
inactive, as described above, or the LCtrl bit is cleared to 0. A wake-up event occurs when a link-on PHY packet
addressed to this node is received, or conditionally when a PHY interrupt occurs. The PHY deasserts the
C/LKON output when the LLC becomes active (both LPS active and the LCtrl bit set to 1). The PHY also
deasserts the C/LKON output when a bus-reset occurs unless a PHY interrupt condition exists which otherwise
causes C/LKON to be active.
ORDERING INFORMATION{
TA
PACKAGE}
ORDERABLE
PART NUMBER
TOP-SIDE
MARKING
40
°C to 85°C
PQFP PFP
TSB41AB3IPFPEP
TSB41AB3IEP
55
°C to 125°C
PQFP PFP
TSB41AB3MPFPEP
TSB41AB3MEP
For the most current package and ordering information, see the Package Option Addendum
at the end of this document, or see the TI web site at http://www.ti.com.
Package
drawings,
thermal
data,
and
symbolization
are
available
at
http://www.ti.com/packaging.
相關PDF資料 |
PDF描述 |
|---|---|
| TVP5150APBSRG4 | IC VIDEO DECODER 8BIT 32TQFP |
| TVP5154AIPNP | IC VIDEO DECODER 4CH 128-HTQFP |
| TW2804-FE | IC NTSC/PAL VIDEO DECOD 128PQF |
| TW2809-BC1-GR | IC INTERFACE |
| TW2815-TA1-GR | IC A/V CODEC/DECOD 4CH 100TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSB41AB3IPFPG4 | 制造商:Texas Instruments 功能描述:THREE PORT CBL TRNSCVR/ARBITER 1TX 1RX 400MBPS 80HTQFP - Rail/Tube |
| TSB41AB3MPFPEP | 功能描述:1394 接口集成電路 Enh Product 3Port Cable Xcvr/Arbiter RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
| TSB41AB3PFP | 功能描述:緩沖器和線路驅動器 Three-Port Cable Xcvr/Arbiter RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel |
| TSB41AB3PFPG4 | 功能描述:1394 接口集成電路 Three-Port Cable Xcvr/Arbiter RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
| TSB41BA3 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE1394B THREE PORT CABLE TRANSCEIVER/ARBITER |
發布緊急采購，3分鐘左右您將得到回復。