- 您現在的位置：買賣IC網 > PDF目錄383955 > TLK1221RHA (Texas Instruments, Inc.) ETHERNET TRANSCEIVER PDF資料下載
參數資料
| 型號： | TLK1221RHA |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | ETHERNET TRANSCEIVER |
| 中文描述： | 以太網收發器 |
| 文件頁數： | 7/23頁 |
| 文件大小： | 501K |
| 代理商： | TLK1221RHA |
www.ti.com
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)
DISSIPATION RATINGS
TLK1221
SLLS713–FEBRUARY 2007
Table 2. TERMINAL FUNCTIONS (continued)
TERMINAL
I/O
DESCRIPTION
NAME
NO.
Synchronous function enable. When SYNCEN is high, the internal synchronization function
is activated. When this function is activated, the transceiver detects the comma pattern
(0011 111 negative beginning disparity) in the serial data stream and realigns data on byte
boundaries if required. When SYNCEN is low, serial input data is unframed in RD0–RD9.
Synchronous detect. The SYNC output is asserted high upon detection of the comma
pattern in the serial data path. SYNC pulses are output only when SYNCEN is activated
(asserted high). In PRBS test mode (PRBSEN = high), SYNC/PASS outputs the status of
the PRBS test results (high = pass).
I
SYNCEN
32
P/U
(2)
SYNC/PASS
30
O
TEST
Loop enable. When LOOPEN is high (active), the internal loopback path is activated. The
transmitted serial data is directly routed to the inputs of the receiver. This provides a self-test
capability in conjunction with the protocol device. The TXP and TXN outputs are held in a
high-impedance state during the loopback test. LOOPEN is held low during standard
operational state with external serial outputs and inputs active.
PRBS enable. When PRBSEN is high, the PRBS generation circuitry is enabled. The PRBS
verification circuit in the receive side is also enabled. A PRBS signal can be fed to the
receive inputs and checked for errors, which are reported by the SYNC/PASS terminal
indicating low.
When this terminal is low, the device is disabled for Iddq testing. RD0–RD9, RBCn, TXP and
TXN are high-impedance. The pullup and pulldown resistors on any input are disabled.
When ENABLE is high, the device operates normally.
I
LOOPEN
15
P/D
(3)
I
PRBSEN
31
P/D
(3)
I
ENABLE
1
P/D
(2)
POWER
VDD
6, 16, 26
Supply
Digital logic power. Provides power for all digital circuitry and digital I/O buffers
Analog power. VDDA provides power for the high-speed analog circuits, receiver, and
transmitter.
PLL power. Provides power for the PLL circuitry. This terminal requires additional filtering.
VDDA
37
Supply
VDDPLL
GROUND
GNDA
GNDQFN
36
Supply
35, 40
PAD
Ground
Ground
Analog ground. GNDA provides a ground for the high-speed analog circuits, RX and TX.
Digital logic ground. Provides a ground for the logic circuits and digital I/O buffers
(2)
(3)
P/U = Internal pullup resistor
P/D = Internal pulldown resistor
VALUE
(1)
–0.3 to 3
–0.5 to 4
–0.3 to V
DD
+ 0.3
CDM: 1, HBM: 2
–65 to 150
–40 to 85
UNIT
V
V
V
kV
°
C
°
C
V
DD
V
I
V
I
ESD
T
stg
T
A
Supply voltage
(2)
Input voltage range at TTL terminals
Input voltage range at other terminals
Electrostatic discharge
Storage temperature
Characterized free-air temperature range
(1)
Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
All voltage values, except differential I/O bus voltages, are with respect to network ground terminal.
(2)
T
≤
25
°
C
POWER RATING
2.85 W
DERATING FACTOR
ABOVE T
A
= 25
°
C
28 mW/
°
C
T
= 70
°
C
POWER RATING
1.57 W
T
= 85
°
C
POWER RATING
1.4 W
PACKAGE
RHA
(1)(2)
(1)
(2)
The thermal resistance junction to ambient of the RHA package is 35
°
C/W measured on a high-K board.
The thermal resistance junction-to-case (exposed pad) of the RHA package is 5
°
C/W.
7
Submit Documentation Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| TLP630 | Programmable Controllers AC / DC−Input Module Telecommunication |
| TLV0832(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，單通道，帶串行控制，8位ADC) |
| TLV0831(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，單通道，帶串行控制，8位ADC) |
| TLV0834(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，4通道，帶串行控制，8位ADC) |
| TLV0838(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，8通道，帶串行控制，8位ADC) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLK1221RHAR | 功能描述:以太網 IC Ethernet Trans RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHARG4 | 功能描述:以太網 IC Gigabit Ethernet Serdes RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHAT | 功能描述:以太網 IC Ethernet Trans RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHAT | 制造商:Texas Instruments 功能描述:Transceiver IC 制造商:Texas Instruments 功能描述:TRANSCEIVER IC |
| TLK1221RHATG4 | 功能描述:以太網 IC Gigabit Ethernet Serdes RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。