- 您現在的位置：買賣IC網 > PDF目錄383955 > TLK1221RHA (Texas Instruments, Inc.) ETHERNET TRANSCEIVER PDF資料下載
參數資料
| 型號： | TLK1221RHA |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | ETHERNET TRANSCEIVER |
| 中文描述： | 以太網收發器 |
| 文件頁數： | 3/23頁 |
| 文件大?。?/td> | 501K |
| 代理商： | TLK1221RHA |
www.ti.com
Detailed Description
In the TBI mode, the transmitter portion registers incoming 10-bit-wide data words (8b/10b encoded data,
TD0–TD9) on the rising edge of REFCLK. REFCLK is also used by the serializer, which multiplies the clock by a
factor of 10, providing a signal that is fed to the shift register. The 8b/10b encoded data is transmitted
sequentially, bits 0 through 9, over the differential high-speed I/O channel.
Transmission Latency
10-Bit Code
TXP, TXN
REFCLK
t
d(Tx latency)
10-Bit Code
b9
TD(0–9)
Data Reception
Receiver Clock Select Mode
TLK1221
SLLS713–FEBRUARY 2007
Data transmission latency is defined as the delay from the initial 10-bit word load to the serial transmission of
bit 9. The minimum latency in TBI mode is 19 bit times. The maximum latency in TBI mode is 20 bit times.
Figure 1. Transmitter Latency, Full-Rate Mode
The receiver section deserializes the differential serial data. The serial data is retimed based on an interpolated
clock generated from the reference clock. The serial data is then aligned to the 10-bit word boundaries and
presented to the protocol controller along with the receive byte clocks (RBC0, RBC1).
The TLK1221 only supports TBI-mode operation with half-rate and full-rate clocks on RBC0 and RBC1. In TBI
mode, there are two user-selectable clock modes that are controlled by the RBCMODE terminal: 1) full-rate
clock on RBC0 and 2) half-rate clocks on RBC0 and RBC1.
Table 1. Mode Selection
RECEIVE BYTE CLOCK
TLK1221
30–65 MHz
60–130 MHz
RBCMODE
MODE
0
1
TBI half-rate
TBI full-rate
In the half-rate mode, two receive byte clocks (RBC0 and RBC1) are 180 degrees out of phase and operate at
one-half the data rate. The clocks are generated by dividing down the recovered clock. The received data is
output with respect to the two receive byte clocks (RBC0, RBC1), allowing a protocol device to clock the parallel
bytes using the RBC0 and RBC1 rising edges. For the outputs to the protocol device, byte 0 of the received data
is valid on the rising edge of RBC1. Refer to the timing diagram shown in
Figure 2
.
3
Submit Documentation Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| TLP630 | Programmable Controllers AC / DC−Input Module Telecommunication |
| TLV0832(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，單通道，帶串行控制，8位ADC) |
| TLV0831(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，單通道，帶串行控制，8位ADC) |
| TLV0834(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，4通道，帶串行控制，8位ADC) |
| TLV0838(中文) | 3-VOLT 8-Bit ADC With Serial Control(3V，8通道，帶串行控制，8位ADC) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLK1221RHAR | 功能描述:以太網 IC Ethernet Trans RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHARG4 | 功能描述:以太網 IC Gigabit Ethernet Serdes RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHAT | 功能描述:以太網 IC Ethernet Trans RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| TLK1221RHAT | 制造商:Texas Instruments 功能描述:Transceiver IC 制造商:Texas Instruments 功能描述:TRANSCEIVER IC |
| TLK1221RHATG4 | 功能描述:以太網 IC Gigabit Ethernet Serdes RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。