參數資料
型號: TLE7368G
廠商: INFINEON TECHNOLOGIES AG
元件分類: 電源管理
英文描述: 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36
封裝: PLASTIC, SOP-36
文件頁數: 34/39頁
文件大?。?/td> 932K
代理商: TLE7368G
TLE7368
Overview
Data Sheet
4
Rev. 1.1, 2007-11-08
Description
The TLE7368 device is a multifunctional power supply circuit especially designed for Automotive powertrain
systems using a standard 12 V battery. The device is intended to supply and monitor next generation 32-bit
microcontroller families (13
m lithography) where voltage levels such as 5 V, 3.3 V or 1.5 V are required.
The regulator follows the concept of its predecessor TLE6368/SONIC, where the output of a pre-regulator feeds
the inputs of the micro’s linear supplies. In detail, the TLE7368 cascades a Buck converter with linear regulators
and voltage followers to achieve lowest power dissipation. This configuration allows to power the application even
at high ambient temperatures.
The step-down converter delivers a pre-regulated voltage of 5.5 V with a minimum peak current capability of 2.5 A.
Supplied by this step down converter two low drop linear post-regulators offer 5 V and 3.3 V (2.6 V) with high
accuracy. The current capability of the regulators is 800 mA and 700 mA. The 3.3 V (2.6 V) linear regulator does
have its own input allowing to insert a dropper from the Buck output to reduce the on chip power dissipation if
necessary. For the same reason, reduction of on chip power dissipation, the 1.5 V core supply follows the concept
of integrated control circuit with external power stage.
Implementing the on board and microcontroller supplies in this way described, allows operation even at high
ambient temperatures.
The regulator system contains the so called power sequencing function which provides a controlled power up
sequence of the three output voltages.
In addition to the main regulators the inputs of two voltage trackers are connected to the 5.5 V Buck converter
output voltage. Their protected outputs follow the main 5 V linear regulator with high accuracy and are able to drive
loads of 50 mA and 105 mA.
To monitor the output voltage levels of each of the linear regulators two independent undervoltage detection
circuits are available. They can be used to implement the reset or an interrupt function.
For energy saving reasons, e.g. while the motor is turned off, the TLE7368 offers a stand-by mode. The stand by
mode can be enabled and disabled either by battery or the microcontroller. In this stand-by mode just the stand-
by regulator remains active and the current drawn from battery is reduced to a minimum for extended battery
lifetime. A selection pin allows to configure the output voltages of the stand-by regulator to the application’s needs.
The input of the stand-by regulator is separated from the high power input of the pre-/post-regulator system.
The TLE7368 is based on Infineon’s Power technology SPT which allows bipolar, CMOS and power DMOS
circuitry to be integrated on the same monolithic chip/circuitry.
相關PDF資料
PDF描述
TLGE158P(Q) T-1 3/4 SINGLE COLOR LED, HIGH INTENSITY GREEN, 5 mm
TLHY4601BT21 T-1 SINGLE COLOR LED, YELLOW, 3 mm
TLMG3102 SINGLE COLOR LED, GREEN, 2.4 mm
TLMM-109-01-L-D-RA 18 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER
TLMM-109-01-L-D-SM 18 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
TLE7368GNUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PDSO-36
TLE7368GZT 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO T/R
TLE7469 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA
TLE7469_08 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA
TLE7469G V52 功能描述:低壓差穩壓器 - LDO Dual LW Drop VLT REG 5/2.6/3.3V 215/200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20