- 您現在的位置：買賣IC網 > PDF目錄225319 > TLE7368G (INFINEON TECHNOLOGIES AG) 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 PDF資料下載
參數資料
| 型號： | TLE7368G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| 封裝： | PLASTIC, SOP-36 |
| 文件頁數： | 25/39頁 |
| 文件大小： | 932K |
| 代理商： | TLE7368G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Data Sheet
31
Rev. 1.1, 2007-11-08
TLE7368
Detailed Internal Circuits Description
5.10
Watchdog Circuit
Figure 8
Window Watchdog State Diagram
Principle of Operation:
A Window Watchdog is integrated in the TLE7368 to monitor a microcontroller. The Window Watchdog duty cycle
consists of an "Open window" and a "Closed window". The microcontroller that is being monitored has to send a
periodic falling edge trigger signal to the watchdog input pin WDI within the "Open Window". If a trigger signal is
not sent or if it is sent during the "Closed Window", then Watchdog Output (WDO) switches from high to low
signaling a potential microcontroller fault has occurred. The watchdog cycle time
T
WD is derived from the time base
T
Cycle. An external capacitor connected between pins RT and GND determines TCycle.
Initialization:
The Watchdog is switched off per default and activated by pulling WDI to low at least for the time
t
WD,start after RO_2
has turned to high. Watchdog input pin WDI has an integrated pull-up resistor
R
WDI connected to Q_LDO2. If WDI
transitions to high before
t
WD,start has elapsed, then the watchdog will not start operation. To initialize the Watchdog
the watchdog input WDI should transition to high within the "Ignore Window". The WDI signal may also transition
to high during the following "Open Window", but sufficient time must be left for a falling edge transition before the
end of the "Open Window". The watchdog function is turned off following a RO_2 reset, and must be reinitialized
to be turned back on.
Normal Operation:
Please refer to Figure 8.
The Watchdog starts operating in the "Ignore Window" state for a duration of
t
WD,IW. Within the "Ignore Window"
the microcontroller is given time to initialize. Any signal to watchdog input WDI within the "Ignore Window" is
ignored. After time
t
WD,IW, the watchdog transitions from the "Ignore Window" state to the "Open Window" state for
a maximum duration of
t
WD,W. Within the "Open Window" a valid trigger signal must be applied to the watchdog
AEA03533.VSD
No Trigger
Closed
Window
Open
Window
Trigger
WDO = LOW
Ignore
Window
Always
No Trigger During
Open Window
Trigger During
Closed Window
相關PDF資料 |
PDF描述 |
|---|---|
| TLGE158P(Q) | T-1 3/4 SINGLE COLOR LED, HIGH INTENSITY GREEN, 5 mm |
| TLHY4601BT21 | T-1 SINGLE COLOR LED, YELLOW, 3 mm |
| TLMG3102 | SINGLE COLOR LED, GREEN, 2.4 mm |
| TLMM-109-01-L-D-RA | 18 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER |
| TLMM-109-01-L-D-SM | 18 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE7368GNUMA1 | 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PDSO-36 |
| TLE7368GZT | 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO T/R |
| TLE7469 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA |
| TLE7469_08 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA |
| TLE7469G V52 | 功能描述:低壓差穩壓器 - LDO Dual LW Drop VLT REG 5/2.6/3.3V 215/200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。