參數資料
型號： TLE7368G
廠商： INFINEON TECHNOLOGIES AG
元件分類： 電源管理
英文描述： 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36
封裝： PLASTIC, SOP-36
文件頁數： 20/39頁
文件大?。?/td> 932K
代理商： TLE7368G
Data Sheet
27
Rev. 1.1, 2007-11-08
TLE7368
Detailed Internal Circuits Description
5.5
Stand-by Regulator
The intention of the stand-by or keep alive regulator is to supply e.g. external memory even with the main
microcontroller supply being disabled. Therefore the state of the stand-by regulator is not controlled by the enable
block, but it is active all the time. The stand-by regulator starts to operate as soon as the battery voltage increases
above its operating threshold. The current consumption during single operation of the stand-by regulator is
reduced to a minimum. It can be configured for output voltages as either 1.0 V or 2.6 V through the SEL_STBY pin.
5.6
Overtemperature Protection
At junction temperatures between 160
°C and 190 °C, which can be caused by e.g. excessive power dissipation
or increased ambient temperatures, the overtemperature protection kicks in and disables the Buck converter. With
the Buck converter disabled the linear regulators will most likely not be able to keep up their output voltage and a
system reset can be expected. Due to the drop in power dissipation the junction temperature will decrease. The
built in hysteresis circuit ensures that the junction temperature cools down by a certain temperature delta before
the Buck converter is enabled again.
5.7
Device Enable Function
The device enable block controls the operation of the Buck converter as well as of the linear regulators and tracker
blocks. Two external signal inputs determine the state of those blocks, a high voltage input EN_IGN and a low
voltage input EN_uC. Internally the two signals are logic OR-ed which means that with either signal the Buck and
linear regulators can be turned on or held active, provided that the battery voltage is above its minimum operating
range. In order to turn off the regulator blocks, the signals on both inputs, EN_IGN and EN_uC must be lower than
their deactivating threshold. The stand-by regulator’s operation is not affected by the device enable block.
5.8
Reset Function
The Reset concept of the TLE7368 is chosen to support multiple microcontroller platforms. Two open drain
outputs, i.e. the Reset outputs, RO_1 and RO_2, indicate the states of the different regulators. Figure 5 gives the
details on the Reset timing. RO_1 is tied to LDO1 and will indicate whenever its output, Q_LDO1, is crossing the
under- or overvoltage threshold. The second Reset output, RO_2, turns low whenever one of the two outputs,
Q_LDO2 or FB_EXT, are crossing their under- and overvoltage thresholds. At power up in order to avoid a faulty
microcontroller start, a so called Reset delay function, i.e. the Reset release delay, is implemented. This delay until
the reset is released, counted from the time where the regulator outputs cross the threshold, is determined by a
small external delay capacitor at pin RT.
The power up reset delay time
t
RD is directly proportional to the capacitance CRT within the capacitance range of
0.33 nF … 4.7 nF:
t
RD = 160 × 50 s × CRT/nF
(3)
For the tolerance calculation please refer to the parameters 4.4.77, 4.4.78 and 4.4.79. In order to find the worst
case limits of
t
RD the capacitance tolerance should be taken into account.
The Reset generators within the TLE7368 are supplied from multiple sources, VIN_STBY, VCCP, VFB_L/IN,
VQ_LDO1 and VQ_LDO2, to fulfill next generation microcontroller requirements during power up and power down.
相關PDF資料
PDF描述
TLGE158P(Q) T-1 3/4 SINGLE COLOR LED, HIGH INTENSITY GREEN, 5 mm
TLHY4601BT21 T-1 SINGLE COLOR LED, YELLOW, 3 mm
TLMG3102 SINGLE COLOR LED, GREEN, 2.4 mm
TLMM-109-01-L-D-RA 18 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER
TLMM-109-01-L-D-SM 18 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
TLE7368GNUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PDSO-36
TLE7368GZT 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO T/R
TLE7469 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA
TLE7469_08 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA
TLE7469G V52 功能描述:低壓差穩壓器 - LDO Dual LW Drop VLT REG 5/2.6/3.3V 215/200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*