- 您現在的位置：買賣IC網 > PDF目錄225319 > TLE7368G (INFINEON TECHNOLOGIES AG) 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 PDF資料下載
參數資料
| 型號： | TLE7368G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| 封裝： | PLASTIC, SOP-36 |
| 文件頁數： | 26/39頁 |
| 文件大小： | 932K |
| 代理商： | TLE7368G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
TLE7368
Detailed Internal Circuits Description
Data Sheet
32
Rev. 1.1, 2007-11-08
input WDI. A valid trigger signal is a falling edge from
V
WDI,high to VWDI,low. After receiving a valid trigger signal within
the "Open Window" the watchdog immediately terminates the "Open Window" and enters the "Closed Window"
state. The "Closed Window" has a fixed duration
t
WD,W. During normal operation a trigger signal should not be
applied during the "Closed Window. After the "Closed Window" time
t
WD,W an the watchdog returns back to the
"Open Window" state. Within the "Open Window", a valid trigger signal must be applied to the watchdog input WDI.
In normal operation, the watchdog continues to cycle between the "Open Window" and "Closed Window" state. If
reset signal RO_2 is asserted and transitions to a low state, then the watchdog needs to be reinitialized as
described in the Initialization section. The watchdog output WDO stays high as long as the watchdog input WDI
is triggered correctly.
Valid Trigger Signal:
Please refer to Figure 9.
Watchdog input WDI is periodically sampled with a period of
T
WD. A valid trigger signal is a falling edge from
V
WDI,high to VWDI,low. To improve immunity against noise or glitches on the WDI input, at least two high samples
followed two low samples are required for a valid trigger signal. For example, if the first three samples (two HGH
one LOW) of the trigger pulse at pin WDI are inside the closed window and only the fourth sample (the second
LOW sample) is taken in the open window then the watchdog output WDO will remain High.
Invalid Triggering:
No trigger signal detected during the "Open Window" or a trigger signal detected during the "Closed Window", is
considered invalid triggering. Watchdog output WDO switches to low for a duration of
t
WD,W immediately after no
valid trigger during the "Open Window" or immediately if a trigger signal is detected during the "Closed Window".
Fault Operation:
If a capacitor failure on the watchdog timing pin RT causes a short circuit to GND, then the internal oscillator stops
operating. Without oscillator operation there is no time reference for the watchdog so it does not know when the
"Closed Window" period has ended. Thus, every second trigger signal on watchdog input WDI generates a
watchdog failure causing WDO to switch from high to low. An open circuit at pin RT also causes WDO to switch
from high to low.
Figure 9
Window Watchdog Input Signal Validation
相關PDF資料 |
PDF描述 |
|---|---|
| TLGE158P(Q) | T-1 3/4 SINGLE COLOR LED, HIGH INTENSITY GREEN, 5 mm |
| TLHY4601BT21 | T-1 SINGLE COLOR LED, YELLOW, 3 mm |
| TLMG3102 | SINGLE COLOR LED, GREEN, 2.4 mm |
| TLMM-109-01-L-D-RA | 18 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER |
| TLMM-109-01-L-D-SM | 18 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE7368GNUMA1 | 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PDSO-36 |
| TLE7368GZT | 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO T/R |
| TLE7469 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA |
| TLE7469_08 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dual Low Drop Voltage Regulator Ultra low quiescent current consumption < 55 μA |
| TLE7469G V52 | 功能描述:低壓差穩壓器 - LDO Dual LW Drop VLT REG 5/2.6/3.3V 215/200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。