- 您現在的位置：買賣IC網 > PDF目錄368631 > TDA936X (NXP Semiconductors N.V.) TV signal processor-Teletext decoder with embedded m-Controller PDF資料下載
參數資料
| 型號： | TDA936X |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | TV signal processor-Teletext decoder with embedded m-Controller |
| 中文描述： | 電視信號處理器與嵌入式米圖文電視解碼器控制器 |
| 文件頁數： | 89/140頁 |
| 文件大小： | 570K |
| 代理商： | TDA936X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁當前第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
1999 Sep 28
89
Philips Semiconductors
Preliminary Device Specification
TV signal processor-Teletext decoder with
embedded
μ
-Controller
TDA935X/6X/8X series
The types which are intended to be used in combination
with 110
°
picture tubes have an East-West control circuit
in stead of the AVL function. The additional controls for
these types are:
EW width
EW parabola width
EW upper and lower corner parabola correction
EW trapezium correction
Vertical zoom
and in some versions:
horizontal parallelogram and bow correction.
Chroma and luminance processing
The chroma band-pass and trap circuits (including the
SECAM cloche filter) are realised by means of gyrators
and are tuned to the right frequency by comparing the
tuning frequency with the reference frequency of the
colour decoder. The luminance delay line and the delay
cells for the peaking circuit are also realised with gyrators.
The circuit contains a black stretcher function which
corrects the black level for incoming signals which have a
difference between the black level and the blanking level.
Colour decoder
The ICs can decode PAL, NTSC and SECAM signals. The
PAL/NTSC decoder does not need external reference
crystals but has an internal clock generator which is
stabilised to the required frequency by using the 12 MHz
clock signal from the reference oscillator of the
μ
-Controller/Teletext decoder.
Underbad-signalconditions(e.g.VCR-playbackinfeature
mode), it may occur that the colour killer is activated
although the colour PLL is still in lock. When this killing
action is not wanted it is possible to overrule the colour
killerbyforcingthecolourdecodertotherequiredstandard
and to activate the FCO-bit (Forced Colour On) in
subaddress 21H.
The Automatic Colour Limiting (ACL) circuit (switchable
via the ACL bit in subaddress 20H) prevents that
oversaturation occurs when signals with a high
chroma-to-burst ratio are received. The ACL circuit is
designed such that it only reduces the chroma signal and
not the burst signal. This has the advantage that the colour
sensitivity is not affected by this function.
The SECAM decoder contains an auto-calibrating PLL
demodulator which has two references, viz: the divided 12
MHz reference frequency (obtained from the
μ
-Controller)
which is used to tune the PLL to the desired free-running
frequency and the bandgap reference to obtain the correct
absolute value of the output signal. The VCO of the PLL is
calibrated during each vertical blanking period, when the
IC is in search or SECAM mode.
The base-band delay line (TDA 4665 function) is
integrated. This delay line is also active during NTSC to
obtain a good suppression of cross colour effects. The
demodulated colour difference signals are internally
supplied to the delay line.
RGB output circuit and black-current stabilization
In the RGB control circuit the signal is controlled on
contrast, brightness and saturation. The ICs have a linear
input for external RGB signals. It is possible to use this
input for the insertion of YUV signals. Switching between
RGB and YUV can be realised via the YUV-bit in
subaddress 2BH. The signals for OSD and text are
internally supplied to the control circuit. The output signal
has an amplitude of about 2 Volts black-to-white at
nominal input signals and nominal settings of the various
controls.
To obtain an accurate biasing of the picture tube the
‘Continuous Cathode Calibration’ system has been
included in these ICs. A black level off set can be made
with respect to the level which is generated by the black
current stabilization system. In this way different colour
temperatures can be obtained for the bright and the dark
part of the picture.
The black current stabilization system checks the output
level of the 3 channels and indicates whether the black
level of the highest output is in a certain window (WBC-bit)
or below or above this window (HBC-bit). This indication
can be read from the status byte 01 and can be used for
automatic adjustment of the V
g2
voltage during the
production of the TV receiver.
During switch-off of the TV receiver a fixed beam current
is generated by the black current control circuit. This
current ensures that the picture tube capacitance is
discharged. During the switch-off period the vertical
deflection is placed in an overscan position so that the
discharge is not visible on the screen.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA938X | TV signal processor-Teletext decoder with embedded m-Controller |
| TDA9829T | Downconverter For DVB(下變頻器 （DVB應用）) |
| TDAT04622 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TDAT042G51A-3BLL1 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TE13004D | Silicon NPN High Voltage Switching Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA9380 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA938O超級芯片將微處理器(CPU)與TV信號處理器集成在一起 |
| TDA9383 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| TDA9400 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9403 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9500 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
發布緊急采購，3分鐘左右您將得到回復。