- 您現在的位置：買賣IC網 > PDF目錄368631 > TDA936X (NXP Semiconductors N.V.) TV signal processor-Teletext decoder with embedded m-Controller PDF資料下載
參數資料
| 型號： | TDA936X |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | TV signal processor-Teletext decoder with embedded m-Controller |
| 中文描述： | 電視信號處理器與嵌入式米圖文電視解碼器控制器 |
| 文件頁數： | 33/140頁 |
| 文件大小： | 570K |
| 代理商： | TDA936X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
Philips Semiconductors
Preliminary specification
1999 Sep 28
33
TV signal processor-Teletext decoder with
embedded
μ
-Controller
TDA 935X/6X/8X series
P
ORT TYPE
All individual ports bits can be programmed to function in one of four modes, the mode is defined by eight Port
Configuration SFR’s (P0CFGA/P0CFGB, P1CFGA/P1CFGB, P2CFGA/P2CFGB and P3CFGA/P3CFGB). The
modes available are Open Drain, Quasi-bidirectional, High Impedance, Push-Pull.
Open Drain
The Open drain mode can be used for bi-directional operation of a port. It requires an external pull-up resistor,
the pull-up voltage has a maximum value of 5.5V, to allow connection of the device into a 5V environment.
Quasi-bidirectional
The quasi-bidirectional mode is a combination of open drain and push pull. It requires an external pull-up resistor
to VDDp (nominally 3.3V). When a signal transition from 0 to 1 is output from the device, the pad is put into push-
pull mode for one clock cycle (166ns) after which the pad goes into open drain mode. The mode may be used
to speed up the edges of signal transitions. This is the default mode of operation of the pads after reset.
High Impedance
The high impedance mode can be used for Input only operation of the port. When using this configuration the
two output transistors are turned off.
Push-Pull
The push pull mode can be used for output only. In this mode the signal is driven to either 0V or VDDp, which
is nominally 3.3V.
Interrupt System
The device has 7 interrupt sources, each of which can be enabled or disabled. When enabled each interrupt
can be assigned one of two priority levels. There are four interrupts that are common to the 80C51, two of these
are external interrupts (EX0 and EX1) and the other two are timer interrupts (ET0 and ET1). In addition to the
conventional 80c51, two application specific interrupts are incorporated internal to the device which have
following functionality:-
ECC (Closed Caption Data Ready Interrupt) - This interrupt is generated when the device is configured in
Closed Caption Acquisition mode. The interrupt is activated at the end of the currently selected Slice Line as
defined in the CCLIN SFR.
EBUSY (Display Busy Interrupt) - An interrupt is generated when the Display enters either a Horizontal or
Vertical Blanking Period. i.e. Indicates when the micro-controller can update the Display RAM without causing
undesired effects on the screen. This interrupt can be configured in one of two modes using the MMR
Configuration Register (Address 87FF, Bit-3 [TXT/V]):-
TeXT Display Busy: An interrupt is generated on each active horizontal display line when the Horizontal
Blanking Period is entered.
Vertical Display Busy: An interrupt is generated on each vertical display field when the Vertical Blanking
Period is entered.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA938X | TV signal processor-Teletext decoder with embedded m-Controller |
| TDA9829T | Downconverter For DVB(下變頻器 （DVB應用）) |
| TDAT04622 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TDAT042G51A-3BLL1 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TE13004D | Silicon NPN High Voltage Switching Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA9380 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA938O超級芯片將微處理器(CPU)與TV信號處理器集成在一起 |
| TDA9383 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| TDA9400 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9403 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9500 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
發布緊急采購，3分鐘左右您將得到回復。