參數資料
型號: STA304A
廠商: 意法半導體
英文描述: 20 POS IMAGE SENSOR SOCKT
中文描述: 數字音頻處理器多通道的DDX⑩
文件頁數: 16/30頁
文件大?。?/td> 338K
代理商: STA304A
STA304A
16/30
10.0COEFFICIENT HANDLING
In order to implement the Static EQ filters and the Bass management, a RAM space for user coefficients has
been included in this device: starting from address 240h (YRAM) there are 69 x 20 bit registers available for this
purpose. In order to be able to read or write into these registers an indirected addressing approach must be
followed by the application software. As showed in Figure 8 there are two AC'97 dedicated registers (4 x 8 bits
registers from I2C point of view) to access the coefficient table. In register 78h (78h + 79h in I2C addressing)
the 16 low bits of the coefficient are stored (by the user in case of a write operation, by the logic in case of a
read operation); the higher 4 bits are stored in the lowest nibble of register 7Ah (7Bh in I2C addressing). The
address of the coefficient on which the R/W operation must be performed is stored in the high byte of register
7Ah. The address is made adding the coefficient index to the base location 40h.
To select between Read or Write operation the 'R' bit in register 7Ah (7Bh in I2C addressing) must be properly
setup. The actual read/write operation will start after the register 7Ah (7Bh in I2C addressing) has be written.
The following paragraphs will explain this in more details.
Figure 12. Coefficient registers usage
10.1Reading a coefficient value
Depending on the bus used to read the coefficient the following steps must be followed:
Reading from AC’97
– write 8 bit INDEX 40h and R/W bit at AC`97 address 7Ah
– read 16 lower data bits at AC`97 address 78h
– read 4 higher data bits at AC`97 address 7Ah
Reading from I
2
C
– write 8 bit address at I2C address 7Ah coeff INDEX + 40h
– write R/W bit at I
2
C address 7Bh
– read 8 middle data bits at I
2
C address 78h
– read 8 lower data bits at I
2
C address 79h
– read 4 higher data bits at I
2
C address 7Bh
10.2Writing a coefficient value
Depending on the bus used to write the coefficient the following steps must be followed:
Writing from AC’97
– write 16 lower bit data at AC`97 address 78h
– write 8 bit INDEX + 40h and R/W bit and 4 higher data bits at AC`97 address 7Ah
Writing from I2C
– write 8 middle data bits at I2C address 78h
– write 8 lower data bits at I2C address 79h
– write 8 bit address at I2C address 7Ah coeff INDEX + 40h
– write 4 higher data bits and R/W bit at I2C address 7Bh
Coefficient[15..0]
Coeff. Address (8 bits)
Coefficient[19..16]
R-x-x-x
Bit 0
Bit 15
78h
7Ah
AC`97
78h
7Ah
I2C
79h
7Bh
R : set this bit to 1 for reading a coefficient, 0 for writing it.
相關PDF資料
PDF描述
STA400A XMRADIO SDARS CHANNEL DECODER
STA450A XMRADIO SDARS SERVICE LAYER & SOURCE DECODER
STA508 40V 4.5A QUAD POWER HALF BRIDGE
STABP01 GT 7C 7#16S SKT PLUG RTANG
STABP01D GT 5C 5#16S SKT PLUG
相關代理商/技術參數
參數描述
STA305 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:PNP Darlington 3-phase motor drive
STA305A 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:PNP Darlington 3-phase motor drive
STA306 功能描述:多媒體雜項 AUDIO SYSTEMS RoHS:否 制造商:Texas Instruments 類型: 通道數量: 轉換速率:540 Mbps 分辨率: 封裝 / 箱體:SOIC-16 封裝:Tube
STA30613TR 功能描述:多媒體雜項 AUDIO SYSTEMS RoHS:否 制造商:Texas Instruments 類型: 通道數量: 轉換速率:540 Mbps 分辨率: 封裝 / 箱體:SOIC-16 封裝:Tube
STA308 功能描述:音頻 DSP Digital Audio Procsr RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube