(t)LI 0150" />
參數資料
型號: SPC5200CVR400
廠商: Freescale Semiconductor
文件頁數: 31/80頁
文件大小: 0K
描述: IC MPU 32BIT 400MHZ 272-PBGA
標準包裝: 40
系列: MPC52xx
處理器類型: 32-位 MPC52xx PowerPC
速度: 400MHz
電壓: 1.5V
安裝類型: 表面貼裝
封裝/外殼: 272-BBGA
供應商設備封裝: 272-PBGA(27x27)
包裝: 托盤
Electrical and Thermal Characteristics
MPC5200 Data Sheet, Rev. 4
Freescale Semiconductor
37
(t)LI
015001500150
Limited Interlock time.1,2
A8.34
(t)MLI
20
20
20
Interlock time with minimum.1,2
A8.35
(t)UI
0
0
0
Unlimited interlock time. 1,2
A8.36
(t)AZ
10
10
10
Maximum time allowed for output drivers to release
from being asserted or negated
A8.37
(t)ZAH
20
20
20
Minimum delay time required for output drivers to
assert or negate from released state
A8.38
(t)ZAD
0—0—0—
A8.39
(t)ENV
20
70
20
70
20
70
Envelope time—from DMACK to STOP and
HDMARDY during data out burst initiation.
A8.40
(t)SR
50
30
20
STROBE to DMARDY time, if DMARDY is negated
before this long after STROBE edge, the recipient
receives no more than one additional data word.
A8.41
(t)RFS
75
60
50
Ready-to-Final STROBE time—no STROBE edges
are sent this long after negation of DMARDY.
A8.42
(t)RP
160
125
100
Ready-to-Pause time—the time recipient waits to
initiate pause after negating DMARDY.
A8.43
(t)IORDYZ
20
20
20
Pull-up time before allowing IORDY to be released.
A8.44
(t)ZIORDY
0
0
0
Minimum time drive waits before driving IORDY
A8.45
(t)ACK
20
20
20
Setup and hold times for DMACK, before assertion or
negation.
A8.46
(t)SS
50
50
50
Time from STROBE edge to negation of DMARQ or
assertion of STOP, when sender terminates a burst.
A8.47
NOTES:
1
tUI, tMLI, tLI indicate sender-to-recipient or recipient-to-sender interlocks. That is, one agent (either sender or recipient)
is waiting for the other agent to respond with a signal before proceeding.
tUI is an unlimited interlock that has no maximum time value.
tMLI is a limited time-out that has a defined minimum.
tLI is a limited time-out that has a defined maximum.
2
All timing parameters are measured at the connector of the drive to which the parameter applies. For example, the
sender shall stop generating STROBE edges tRFS after negation of DMARDY. Both STROBE and DMARDY timing
measurements are taken at the connector of the sender. Even though the sender stops generating STROBE edges,
the receiver may receive additional STROBE edges due to propagation delays. All timing measurement switching
points (low to high and high to low) are taken at 1.5 V.
Table 29. Ultra DMA Timing Specification (continued)
Name
MODE 0
(ns)
MODE 1
(ns)
MODE 2
(ns)
Comment
SpecID
Min
Max
Min
Max
Min
Max
相關PDF資料
PDF描述
SPC5517GAMMG66 IC MCU 32B 1.5MB FLASH 208MAPBGA
SPC5604PGF0MLQ6 IC MCU 32BIT 512KB FLASH 144LQFP
SST89C58RC-40-C-QIF IC MCU 8BIT FLASH 40WQFN
SST89E54RC-33-C-PIE IC MCU 8BIT 17KB FLASH 40PDIP
SST89E58RD2-40-I-TQJE IC MCU 8BIT FLASH 44TQFP
相關代理商/技術參數
參數描述
SPC5200CVR400B 功能描述:微處理器 - MPU HABANERO AUTO PBFREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
SPC5200CVR400BR2 功能描述:微處理器 - MPU HABANERO AUTO PB FREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
SPC5200CVR400R2 功能描述:IC MPU 32BIT 400MHZ 272-PBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC52xx 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA(25x25) 包裝:托盤
SPC5200VVR266B 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:SDRAM/DDR Memory Controller
SPC5293 制造商:SPC Multicomp 功能描述:D Subminiature Gender Changer Convert Fr