- 您現在的位置：買賣IC網 > PDF目錄368020 > PI7C7100 (Pericom Semiconductor Corp.) 3-Port PCI Bridge PDF資料下載
參數資料
| 型號： | PI7C7100 |
| 廠商： | Pericom Semiconductor Corp. |
| 英文描述： | 3-Port PCI Bridge |
| 中文描述： | 3端口PCI橋 |
| 文件頁數： | 39/132頁 |
| 文件大?。?/td> | 2559K |
| 代理商： | PI7C7100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁
31
09/18/00 Rev 1.1
123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567
123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567
PI7C7100
ADVANCE INFORMATION
32-bit value of 0 is compared to the prefetchable memory base address upper 32 bits register and the prefetchable memory
limit address upper 32 bits register. The prefetchable memory base address upper 32 bits register must be 0 to pass any single
address cycle transactions downstream.
Prefetchable memory address range has a granularity and alignment of 1MB. Maximum memory address range s 4GB when
32-bit addressing is being used.
Prefetchable memory address range is defined by a 16-bit prefetchable memory base address register at configuration
offset 24h and by a 16-bit prefetchable memory limit address register at offset 26h. The top 12 bits of each of these registers
correspond to bits [31:20] of the memory address. The lowest 4 bits are hardwired to 1h. The lowest 20 bits of the
prefetchable memory base address are assumed to be 0 0000h, which results in a natural alignment to a 1MB boundary.
The lowest 20 bits of the prefetchable memory limit address are assumed to be FFFFFh, which results in an alignment to
the top of a 1MB block.
Note:
The initial state of the prefetchable memory base address register is 0000 0000h. The initial state of the prefetchable
memory limit address register is 000F FFFFh. Note that the initial states of these registers define a prefetchable memory
range at the bottom 1MB block of memory. Write these registers with their appropriate values before setting either the
memory enable bit or the master enable bit in the command register in configuration space.
To turn off the prefetchable memory address range, write the prefetchable memory base address register with a value
greater than that of the prefetchable memory limit address register. The entire base value must be greater than the entire
limit value, meaning that the upper 32 bits must be considered. Therefore, to disable the address range, the upper 32
bits registers can both be set to the same value, while the lower base register is set greater than the lower limit register.
Otherwise, the upper 32-bit base must be greater than the upper 32-bit limit.
5.4 VGA Support
PI7C7100 provides two modes for VGA support:
VGA mode, supporting VGA-compatible addressing
VGA snoop mode, supporting VGA palette forwarding
5.4.1 VGA Mode
When a VGA-compatible device exists downstream from PI7C7100, set the VGA mode bit in the bridge control register
in configuration space to enable VGA mode. When PI7C7100 is operating in VGA mode, it forwards downstream those
transactions addressing the VGA frame buffer memory and VGA I/O registers, regardless of the values of the base and
limit address registers. PI7C7100 ignores transactions initiated on the secondary interface addressing these locations.
The VGA frame buffer consists of the following memory address range:
000A 0000h–000B FFFFh
Read transactions to frame buffer memory are treated as non-prefetchable. PI7C7100 requests only a single data transfer
from the target, and read byte enable bits are forwarded to the target bus.
The VGA I/O addresses are in the range of 3B0h–3BBh and 3C0h–3DFh I/O. These I/O addresses are aliases every 1KB
throughout the first 64KB of I/O space. This means that address bits <15:10> are not decoded and can be any value, while
address bits [31:16] must be all 0s. VGA BIOS addresses starting at C0000h are not decoded in VGA mode.
5.4.2 VGA Snoop Mode
PI7C7100 provides VGA snoop mode, allowing for VGA palette write transactions to be forwarded downstream. This mode
is used when a graphics device downstream from PI7C7100 needs to snoop or respond to VGA palette write transactions.
To enable the mode, set the VGA snoop bit in the command register in configuration space. Note that PI7C7100 claims
VGA palette write transactions by asserting DEVSEL# in VGA snoop mode.
When VGA snoop bit is set, PI7C7100 forwards downstream transactions within the 3C6h, 3C8h and 3C9h I/O addresses
space. Note that these addresses are also forwarded as part of the VGA compatibility mode previously described. Again,
address bits <15:10> are not decoded, while address bits <31:16> must be equal to 0, which means that these addresses
are aliases every 1KB throughout the first 64KB of I/O space.
Note:
If both the VGA mode bit and the VGA snoop bit are set, PI7C7100 behaves in the same way as if only the VGA
mode bit were set.
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C7100CNA | 3-Port PCI Bridge |
| PI7C7300 | 3-PORT PCI-to-PCI BRIDGE |
| PI7C7300A | 3-PORT PCI-to-PCI BRIDGE |
| PI7C7300ANA | 3-PORT PCI-to-PCI BRIDGE |
| PI7C8140A | 2 PORT PCI TO PCI BRIDGE PLX PCI 6140 COMPARISON |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C7100BNA | 制造商:Pericom Semiconductor Corporation 功能描述:3 PORT PCI TO PCI |
| PI7C7100CNA | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:3-Port PCI Bridge |
| PI7C7300 | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:3-PORT PCI-to-PCI BRIDGE |
| PI7C7300A | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:3-PORT PCI-to-PCI BRIDGE |
| PI7C7300AEVB-3 | 功能描述:界面開發工具 3 Port PCI Bridge Eval Brd RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
發布緊急采購，3分鐘左右您將得到回復。