參數資料
型號： MC7445ARX933LG
廠商： 飛思卡爾半導體(中國)有限公司
英文描述： RISC Microprocessor Hardware Specifications
中文描述： RISC微處理器硬件規格
文件頁數： 21/64頁
文件大?。?/td> 1127K
代理商： MC7445ARX933LG
MPC7455 RISC Microprocessor Hardware Specifications, Rev. 4.1
Freescale Semiconductor
21
Electrical and Thermal Characteristics
The L3_CLK timing diagram is shown in
Figure 7
.
Figure 7. L3_CLK_OUT Output Timing Diagram
5.2.4 L3 Bus AC Specifications
The MPC7455 L3 interface supports three different types of SRAM: source-synchronous, double data rate (DDR)
MSUG2 SRAM, late write SRAMs, and pipeline burst (PB2) SRAMs. Each requires a different protocol on the L3
interface and a different routing of the L3 clock signals. The type of SRAM is programmed in L3CR[22:23] and the
MPC7455 then follows the appropriate protocol for that type. The designer must connect and route the L3 signals
appropriately for each type of SRAM. Following are some observations about the chip-to-SRAM interface.
The routing for the point-to-point signals (L3_CLK[0:1], L3DATA[0:63], L3DP[0:7], and
L3_ECHO_CLK[0:3]) to a particular SRAM should be delay matched. If necessary, the length of traces can
be altered in order to intentionally skew the timing and provide additional setup or hold time margin.
For a 1-Mbyte L3, use address bits 16:0 (bit 0 is LSB).
No pull-up resistors are required for the L3 interface.
For high speed operations, L3 interface address and control signals should be a ‘T’ with minimal stubs to
the two loads; data and clock signals should be point-to-point to their single load.
Figure 8
shows the AC
test load for the L3 interface.
Figure 8. AC Test Load for the L3 Interface
In general, if routing is short, delay-matched, and designed for incident wave reception and minimal reflection, there
is a high probability that the AC timing of the MPC7455 L3 interface will meet the maximum frequency operation
of appropriately chosen SRAMs. This is despite the pessimistic, guard-banded AC specifications (see
Table 12
,
Table 13
, and
Table 14
), the limitations of functional testers described in
Section 5.2.3, “L3 Clock AC
Specifications
,”
and the uncertainty of clocks and signals which inevitably make worst-case critical path timing
analysis pessimistic.
L3_CLK0
VM
t
L3CR
t
L3CF
VM
VM
VM
L3_CLK1
VM
VM
t
L3_CLK
t
CHCL
VM
t
L3CSKW1
L3_ECHO_CLK1
L3_ECHO_CLK3
VM
VM
VM
VM
t
L3CSKW2
VM
VM
VM
VM
t
L3CSKW2
For PB2 or Late Write:
Output
Z
0
= 50
GV
DD
/2
R
L
= 50
相關PDF資料
PDF描述
MC7445ARX867LF RISC Microprocessor Hardware Specifications
MC9328MXL i.MX Integrated Portable System Processor
MRF18030BLSR3 RF Power Field Effect Transistors N-Channel Enhancement-Mode Lateral MOSFETs
MW6S004NT1_07 RF Power Field Effect Transistor
MC9328MXLCVP15 i.MX Integrated Portable System Processor
相關代理商/技術參數
參數描述
MC7447A 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:PowerPC microprocessor
MC7447AHX1000LB 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.3V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MC7447AHX1000NB 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MC7447AHX1000NBR 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 32BIT 0.13UM 1GHZ 1.8V/2.5V 360FCCBGA - Tape and Reel
MC7447AHX1000PC 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 32BIT 0.13UM 1GHZ 1.8V/2.5V 360FCCBGA - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*