SPI/I2C UART with 128-Word FIFOs Bits 7–4: SwFlow[3:0] The SwFlow[3:0] bits conf" />
參數資料
型號： MAX3107ETG+T
廠商： Maxim Integrated Products
文件頁數： 31/52頁
文件大?。?/td> 0K
描述： IC UART SPI/I2C 128 FIFO 24TQFN
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 1
特點： 內部振蕩器
通道數： 4，QUART
FIFO's： 128 字節
規程： RS232，RS485
電源電壓： 2.35 V ~ 3.6 V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
安裝類型： 表面貼裝
封裝/外殼： 24-WFQFN 裸露焊盤
供應商設備封裝： 24-TQFN-EP（3.5x3.5）
包裝： 標準包裝
其它名稱： MAX3107ETG+TDKR
SPI/I2C UART with 128-Word FIFOs
Bits 7–4: SwFlow[3:0]
The SwFlow[3:0] bits configure auto software flow control and/or special character detection in combination with the
characters defined in the XON1, XON2, XOFF1 and/or XOFF2 registers. See Table 3.
FlowCtrl[5:4] select which of the XON1, XON2, XOFF1 or/and XOFF2 characters are used for special character detec-
tion and/or auto flow control. If auto receiver flow control is enabled through SwFlowEn and FlowCtrl[7:6], the XON and
XOFF characters that the MAX3107 receives are filtered out and are not put into the RxFIFO. Set the SwFlowEn bit to
0 and set MODE2[4] to 1 to only enable special character detection. Under these conditions, auto flow transmit flow
control is not active.
If both special character detection (MODE2[4]) and auto software flow control (FlowCtrl[3]) are to be enabled, XON1
and XOFF1 define the auto flow control characters, while XON2 and XOFF2 define the special character detection
characters.
Bit 3: SwFlowEn
The SwFlowEn bit enables auto software flow control. The characters used for auto software flow control are selected in
SwFlow[7:4]. If special character detection (MODE2[4] set to 1) is used in addition to auto software flow control, XON1
and XOFF1 are used for flow control, while XON2 and XOFF2 define the special characters.
Bit 2: GPIAddr
The GPIAddr bit, when set, enables that the four GPIO_ inputs are used in conjunction with XOFF2 for the definition of a
special character. This can be used, for example, for defining the address of a RS-485 slave device through hardware.
The GPIO_ inputs logic levels, which define the 4 LSBs of the special character, while the 4 MSBs are defined by the
XOFF2[7:4] bits. If GPIAddr is set, the contents of the XOFF2[3:0] bits are neglected. In this case, the XOFF2[3:0] bits,
when read, also do not reflect the logic on GPIO_.
Bit 1: AutoCTS
The AutoCTS bit enables auto CTS flow control by which the transmitter stops and starts sending data depending on
the logic state at the CTS input. See the Auto Hardware Flow Control section for a description of AutoCTS flow con-
trol. Logic changes at the CTS input result in an ISR[7]: CTSInt interrupt. The transmitter must be turned off by setting
MODE1[1] to 1 before AutoCTS is enabled.
Bit 0: AutoRTS
The AutoRTS bit enables auto RTS flow control by which the MAX3107 sets its RTS/CLKOUT output dependent on
the receive FIFO fill level. The FIFO thresholds at which RTS/CLKOUT changes state are set in FlowLvl. See the Auto
Hardware Flow Control section for more information.
FlowCtrl—Flow Control Register
ADDRESS:
0x13
MODE:
R/W
BIT
7
6
5
4
3
2
1
0
NAME
SwFlow3
SwFlow2
SwFlow1
SwFlow0
SwFlowEn
GPIAddr
AutoCTS
AutoRTS
RESET
0
Maxim Integrated
37
MAX3107
相關PDF資料
PDF描述
V24C12H150BF3 CONVERTER MOD DC/DC 12V 150W
MAX3111EENI+G36 IC UART SPI COMPAT 28-DIP
MAX3100EEE+ IC UART SPI/MICRWIRE COMP 16QSOP
V24C12H150BF2 CONVERTER MOD DC/DC 12V 150W
MAX3107ETG+ IC UART SPI/I2C 128 FIFO 24TQFN
相關代理商/技術參數
參數描述
MAX3107EVKIT+ 功能描述:UART 接口集成電路 UART with integrated Oscillator RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
MAX3108AEWA+ 制造商:Maxim Integrated Products 功能描述:LOW SHUTDOWN CURRENT SPI/I?C UART WITH 128-WORD FIFOS IN WLP - Rail/Tube
MAX3108AEWA+T 功能描述:UART 接口集成電路 SPI/I2C UART W/ 128 WORD FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
MAX3108EWA+ 制造商:Maxim Integrated Products 功能描述:SPI/IAC UART WITH 128-WORD FIFOS IN WLP - Rail/Tube
MAX3108EWA+T 功能描述:IC UART RoHS:是 類別:集成電路 (IC) >> 接口 - UART（通用異步接收器/發送器） 系列:* 標準包裝:250 系列:- 特點:* 通道數:2，DUART FIFO's:16 字節 規程:RS232，RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:托盤 其它名稱:XR16L2551IM-F-ND
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*