- 您現在的位置：買賣IC網 > PDF目錄385520 > MAX109EHF-D (MAXIM INTEGRATED PRODUCTS INC) 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs PDF資料下載
參數資料
| 型號： | MAX109EHF-D |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | ADC |
| 英文描述： | 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs |
| 中文描述： | 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, BGA256 |
| 封裝： | 27 X 27 MM, 1.27 MM PITCH, SBGA-256 |
| 文件頁數： | 25/29頁 |
| 文件大?。?/td> | 451K |
| 代理商： | MAX109EHF-D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁
integrated fans are available from Co-Fan USA (e.g.,
the 30-1101-02 model, which is used on the evaluation
kit of the MAX109). This particular heatsink with inte-
grated fan is available with pre-applied adhesive for
easy package mounting.
Bypassing/Layout/Power Supply
Grounding and power-supply decoupling strongly influ-
ence the MAX109’s performance. At a 2.2GHz clock
frequency and 8-bit resolution, unwanted digital
crosstalk may couple through the input, reference,
power supply, and ground connections and adversely
influence the dynamic performance of the ADC.
Therefore, closely follow the grounding and power-sup-
ply decoupling guidelines (Figure 17). Maxim strongly
recommends using a multilayer printed circuit board
(PCB) with separate ground and power-supply planes.
Since the MAX109 has separate analog and digital
ground connections (GNDA, GNDI, GNDR, and GNDD,
respectively), the PCB should feature separate analog
and digital ground sections connected at only one
point (star ground at the power supply). Digital signals
should run above the digital ground plane, and analog
signals should run above the analog ground plane.
Keep digital signals far away from the sensitive analog
inputs, reference inputs, and clock inputs. High-speed
signals, including clocks, analog inputs, and digital out-
puts, should be routed on 50
microstrip lines, such as
those employed on the MAX109 evaluation kit.
The MAX109 has separate analog and digital power-
supply inputs:
V
EE
(-5V) is the analog and substrate supply
V
CC
I (5V) to power the T/H amplifier, clock distribu-
tion, bandgap reference, and reference amplifier
V
CC
A (5V) to supply the ADC’s comparator array
V
CC
O (3.3V) to establish power for all LVDS-based
circuit sections
V
CC
D (5V) to supply all logic circuits of the data con-
verter
The MAX109 V
EE
supply contacts must not be left open
while the part is being powered up. To avoid this condi-
tion, add a high-speed Schottky diode (such as a
Motorola 1N5817) between V
EE
and GNDI. This diode
prevents the device substrate from forward biasing,
which could cause latchup. All supplies should be
decoupled with large tantalum or electrolytic capacitors
at the point they enter the PCB. For best performance,
bypass all power supplies to the appropriate grounds
with a 330μF and 33μF tantalum capacitor to filter power-
supply noise, in parallel with 0.1μF capacitors and high-
quality 0.01μF ceramic chip capacitors. Each power
M
8-Bit, 2.2Gsps ADC with Track/Hold Amplifier
and 1:4 Demultiplexed LVDS Outputs
______________________________________________________________________________________
25
CLKN
CLKP
ADC SAMPLE NUMBER
ADC SAMPLES ON THE RISING EDGE OF CLKP
t
SU
t
HD
DCON
RESET
INPUT
RSTINN
RSTINP
DCOP
PORTA DATA
PORTB DATA
PORTC DATA
PORTD DATA
SAMPLE HERE
RESETOUT
DATA PORT
RSTOUTN
RSTOUTP
THE GRAY AREAS INDICATE A POWER-UP DEPENDENT STATE, WHICH IS UNKNOWN AT THE TIME THE RESET IS BEING ASSERTED.
N
N + 1
N + 2
N + 3
N + 4
N + 5
N + 4
N + 6
N + 5
N + 8
N + 7
N + 6
N + 7
N + 8
N + 9 N + 10 N + 11 N + 12 N + 13 N + 14 N + 15 N + 16 N + 17 N + 18 N + 19
Figure 16. Reset Output Timing in Demultiplexed SDR Mode
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1101 | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX1101CWG | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX11041 | Wired Remote Controllers |
| MAX110 | Low-Cost, 2-Channel, 4-Bit Serial ADCs(±5V，2通道，±14位串行模數轉換器) |
| MAX1126 | Quad, 12-Bit, 40Msps, 1.8V ADC with Serial LVDS Outputs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX109EHF-TD | 制造商:Maxim Integrated Products 功能描述:8-BIT 2.5GSPS ADC - Tape and Reel |
| MAX109EVKIT | 制造商:Maxim Integrated Products 功能描述:EVAL KIT FOR THE MAX109 ADC - Bulk |
| MAX10D | 制造商:Lanzar 功能描述:Dual 4 Ohm 800W Peak 10 Paper Cone Dual Vc Woofer 制造商:LANZAR 功能描述:10 PAPER CONE DUAL VC WOOFER DUAL 4 OHM 800W PEAK |
| MAX10G | 制造商:Aavid Thermalloy 功能描述:Thrml Mgmt Access Heat Sink Clip 制造商:Aavid Thermalloy 功能描述:HEAT SINK CLIP - MAX TO220 - SLIM 制造商:Aavid Thermalloy 功能描述:Long Standard Force Clip |
| MAX10NG | 功能描述:散熱片 MaxClip TO220/Max220 9lb 19.7x12mm RoHS:否 制造商:Ampro By ADLINK 產品:Heat Sink Accessories 安裝風格:Through Hole 散熱片材料: 散熱片樣式: 熱阻: 長度: 寬度: 高度: 設計目的:Express-HRR |
發布緊急采購，3分鐘左右您將得到回復。