- 您現在的位置：買賣IC網 > PDF目錄385520 > MAX109EHF-D (MAXIM INTEGRATED PRODUCTS INC) 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs PDF資料下載
參數資料
| 型號： | MAX109EHF-D |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | ADC |
| 英文描述： | 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs |
| 中文描述： | 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, BGA256 |
| 封裝： | 27 X 27 MM, 1.27 MM PITCH, SBGA-256 |
| 文件頁數： | 21/29頁 |
| 文件大?。?/td> | 451K |
| 代理商： | MAX109EHF-D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
M
nal shift register is enabled and multiplexed with the
input of the 1:4 demultiplexer, replacing the quantizer
8-bit output. The test pattern consists of 8 bits. Table 3
depicts the composition of the first and last steps of the
PRN pattern. The entire look-up table can be down-
loaded from the Maxim website at www.maxim-ic.com.
Applications Information
Single-Ended Analog Inputs
The MAX109 is designed to work at full speed for both
single-ended and differential analog inputs; however,
for optimum dynamic performance it is recommended
that the inputs are driven differentially. Inputs INP and
INN feature on-chip, laser-trimmed 50
termination
resistors.
In a typical single-ended configuration, the analog
input signal (Figure 9) enters the T/H amplifier stage at
the in-phase input (INP), while the inverted phase input
(INN) is reverse-terminated to GNDI with an external
50
resistor. Single-ended operation allows for an input
amplitude of 500mV
P-P
. Table 4 shows a selection of
input voltages and their corresponding output codes
for single-ended operation.
Differential Analog Inputs
To obtain a full-scale digital output with differential input
drive (Figure 10), 250mV
P-P
must be applied between
INP and INN (INP = 125mV and INN = -125mV). Mid-
scale digital output codes (01111111 or 10000000)
occur when there is no voltage difference between INP
and INN. For a zero-scale digital output code, the in-
phase INP input must see -125mV and the inverted
input INN must see 125mV. A differential input drive is
recommended for best performance. Table 5 repre-
sents a selection of differential input voltages and their
corresponding output codes.
Offset Adjust
The MAX109 provides a control input (VOSADJ) to
compensate for system offsets. The offset adjust input
is a self-biased voltage-divider from the internal 2.5V
precision reference. The nominal open-circuit voltage is
one-half the reference voltage. With an input resistance
(R
VOSADJ
) of typically 50k
, VOSADJ can be driven
with an external 10k
potentiometer (Figure 11) con-
nected between REFOUT and GNDI to correct for offset
errors. For stabilizing purposes, decouple this output
with a 0.01μF capacitor to GNDI. VOSADJ allows for a
typical offset adjustment of ±10 LSB.
Clock Operation
The MAX109 clock inputs are designed for either sin-
gle-ended or differential operation (Figure 12) with flexi-
8-Bit, 2.2Gsps ADC with Track/Hold Amplifier
and 1:4 Demultiplexed LVDS Outputs
______________________________________________________________________________________
21
INP
INN
0V
+250mV
-250mV
t
500mV
P-P
FS ANALOG
INPUT RANGE
V
IN
=
±
250mV
500mV
Figure 9. Single-Ended Analog Input Signal Swing
INP
INN
+125mV
-125mV
t
±
250mV
FS ANALOG
INPUT RANGE
0V
250mV
-250mV
Figure 10. Differential Analog Input Signal Swing
GNDI
POTENTIOMETER
10k
REFOUT
VOSADJ
Figure 11. Offset Adjustment Circuit
CLKP
CLKCOM
SIMPLIFIED DIAGRAM
(INPUT ESD PROTECTION
NOT SHOWN).
CLKN
50
1V
50
GNDI
V
EE
Figure 12. Clock Input Structure
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1101 | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX1101CWG | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX11041 | Wired Remote Controllers |
| MAX110 | Low-Cost, 2-Channel, 4-Bit Serial ADCs(±5V，2通道，±14位串行模數轉換器) |
| MAX1126 | Quad, 12-Bit, 40Msps, 1.8V ADC with Serial LVDS Outputs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX109EHF-TD | 制造商:Maxim Integrated Products 功能描述:8-BIT 2.5GSPS ADC - Tape and Reel |
| MAX109EVKIT | 制造商:Maxim Integrated Products 功能描述:EVAL KIT FOR THE MAX109 ADC - Bulk |
| MAX10D | 制造商:Lanzar 功能描述:Dual 4 Ohm 800W Peak 10 Paper Cone Dual Vc Woofer 制造商:LANZAR 功能描述:10 PAPER CONE DUAL VC WOOFER DUAL 4 OHM 800W PEAK |
| MAX10G | 制造商:Aavid Thermalloy 功能描述:Thrml Mgmt Access Heat Sink Clip 制造商:Aavid Thermalloy 功能描述:HEAT SINK CLIP - MAX TO220 - SLIM 制造商:Aavid Thermalloy 功能描述:Long Standard Force Clip |
| MAX10NG | 功能描述:散熱片 MaxClip TO220/Max220 9lb 19.7x12mm RoHS:否 制造商:Ampro By ADLINK 產品:Heat Sink Accessories 安裝風格:Through Hole 散熱片材料: 散熱片樣式: 熱阻: 長度: 寬度: 高度: 設計目的:Express-HRR |
發布緊急采購，3分鐘左右您將得到回復。