- 您現在的位置：買賣IC網 > PDF目錄385520 > MAX109EHF-D (MAXIM INTEGRATED PRODUCTS INC) 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs PDF資料下載
參數資料
| 型號： | MAX109EHF-D |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | ADC |
| 英文描述： | 8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs |
| 中文描述： | 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, BGA256 |
| 封裝： | 27 X 27 MM, 1.27 MM PITCH, SBGA-256 |
| 文件頁數： | 18/29頁 |
| 文件大?。?/td> | 451K |
| 代理商： | MAX109EHF-D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
M
Internal Reference
The MAX109 features an on-chip 2.5V precision
bandgap reference used to generate the full-scale
range for the data converter. Connecting REFIN with
REFOUT applies the reference output to the positive
input of the reference buffer. The buffer’s negative input
is internally connected to GNDR. It is recommended
that GNDR be connected to GNDI on the user’s appli-
cation board.
If required, REFOUT can source up to 2.5mA to supply
other external devices. Additionally, an adjustable
external reference can be used to adjust the ADC’s full-
scale range. To use an external reference supply, con-
nect a high-precision bandgap reference to the REFIN
pin and leave the REFOUT pin floating. REFIN has a
typical input resistance R
REFIN
of 5k
and accepts
input voltages of 2.5V ±10%.
Digital LVDS Outputs
The MAX109 provides data in offset binary format to
differential LVDS outputs on four output ports (PortA,
PortB, PortC, and PortD). A simplified circuit schematic
of the LVDS output cells is shown in Figure 5. All LVDS
outputs are powered from the output driver supply
V
CC
O, which can be operated at 3.3V ±10%. The
MAX109 LVDS outputs provide a differential output-
voltage swing of 600mV
P-P
with a common-mode volt-
age of approximately 1.2V, and must be differentially
terminated at the far end of each transmission line pair
(true and complementary) with 100
.
Data Out-of-Range Operation
(DORP, DORN)
A single differential output pair (DORP, DORN) is pro-
vided to flag an out-of-range condition, if the applied
signal is outside the allowable input range, where out-
of-range is above positive full scale (+FS) or below
negative full scale (-FS). The DORP/DORN transitions
high/low whenever any of the four output ports (PortA,
PortB, PortC, and PortD) display out-of-range data.
DORP/DORN features the same latency as the ADC
output data and is demultiplexed in a similar fashion, so
that this out-of-range signal and the data samples are
time-aligned.
Demultiplexer Operation
The MAX109’s internal 1:4 demultiplexer spreads the
ADC core’s 8-bit data across 32 true LVDS outputs and
allows for easy data capture in three different modes.
Two TTL/CMOS-compatible inputs are utilized to create
the different modes: SDR (standard data rate), DDR
8-Bit, 2.2Gsps ADC with Track/Hold Amplifier
and 1:4 Demultiplexed LVDS Outputs
18
______________________________________________________________________________________
Table 1. Timing Adjustments for T/H
Amplifier and Quantizer
DELGATE1
DELGATE0
T M E DEL A Y
B ET WEEN
T H A N D
Q U A N T Z ER
RECOMMENDED
FOR CLOCK
SPEEDS OF
0
1
25ps
f
CLK
= 2.2Gsps
to 2.5Gsps
1
0
50ps
f
CLK
= 1.75Gsps
to 2.2Gsps
Table 2. Data Rate Selection for
Demultiplexer Operation
DDR
QDR
DEMULTIPLEXER OPERATION
DCO
SPEED
0
X
SDR mode, PortA, PortB, PortC, and
PortD enabled, 550Msps per port
f
CLK
/ 4
1
0
DDR mode, PortA, PortB, PortC, and
PortD enabled, 550Msps per port
f
CLK
/ 8
1
1
QDR mode, PortA, PortB, PortC, and
PortD enabled, 550Msps per port
f
C LK
/ 16
AOP–A7P
BOP–B7P
COP–C7P
DOP–D7P
DCOP
RSTOUTP
AON–A7N
BON–B7N
CON–C7N
DON–D7N
DCON
RSTOUTN
CMFB:
COMMON-MODE
FEEDBACK
CMFB
GNDO
GNDO
V
CC
O
V
CC
O
Figure 5. Simplified LVDS Output Circuitry
X = Do not care.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1101 | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX1101CWG | Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX11041 | Wired Remote Controllers |
| MAX110 | Low-Cost, 2-Channel, 4-Bit Serial ADCs(±5V，2通道，±14位串行模數轉換器) |
| MAX1126 | Quad, 12-Bit, 40Msps, 1.8V ADC with Serial LVDS Outputs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX109EHF-TD | 制造商:Maxim Integrated Products 功能描述:8-BIT 2.5GSPS ADC - Tape and Reel |
| MAX109EVKIT | 制造商:Maxim Integrated Products 功能描述:EVAL KIT FOR THE MAX109 ADC - Bulk |
| MAX10D | 制造商:Lanzar 功能描述:Dual 4 Ohm 800W Peak 10 Paper Cone Dual Vc Woofer 制造商:LANZAR 功能描述:10 PAPER CONE DUAL VC WOOFER DUAL 4 OHM 800W PEAK |
| MAX10G | 制造商:Aavid Thermalloy 功能描述:Thrml Mgmt Access Heat Sink Clip 制造商:Aavid Thermalloy 功能描述:HEAT SINK CLIP - MAX TO220 - SLIM 制造商:Aavid Thermalloy 功能描述:Long Standard Force Clip |
| MAX10NG | 功能描述:散熱片 MaxClip TO220/Max220 9lb 19.7x12mm RoHS:否 制造商:Ampro By ADLINK 產品:Heat Sink Accessories 安裝風格:Through Hole 散熱片材料: 散熱片樣式: 熱阻: 長度: 寬度: 高度: 設計目的:Express-HRR |
發布緊急采購，3分鐘左右您將得到回復。